Manual.ly Logo

Oase FiltoSmart 60 Manual

0.0 · 0 Ratings

PDF manual · 98 Pages

English

M: QW-35-FL
page

/ 98

Loading...
de634e5ecefd526039f1cb7c8d7970520119 page c
- EN -
12 FiltoSmart 60
Safe operation
• Switch off all units in the aquarium or disconnect
the power plugs of all units before reaching into the
water.
• Never operate the unit if either the electrical cables
or the housing are defective!
• Do not carry or pull the unit by its electrical cable.
• Route cables/hoses such that they are protected
from damage and do not present a tripping hazard.
• Only open the unit housing or its attendant compo-
nents, when this is explicitly required in the operat-
ing instructions.
• Only carry out work on the unit that is described in
this manual. If problems cannot be overcome,
please contact an authorised customer service point
or, when in doubt, the manufacturer.
• Only use original spare parts and accessories for the
unit.
• Never carry out technical modifications to the unit.
• Power connection cables cannot be replaced. If a ca-
ble is damaged, dispose of the respective unit or
components.
Electrical connection
• Only connect the unit if the electrical data of the
unit and the power supply coincide. The unit data is
to be found on the unit type plate, on the packaging
or in this manual.
• Protect the plug connections from moisture.
• Only plug the unit into a correctly fitted socket.
Symbols used in these instructions
CAUTION
• Indicates a possibly hazardous situation.
• Non-observance may lead to slight or minor inju-
ries.
NOTE
Indicates information intended to give the user a bet-
ter understanding.
Additional information
A Reference to a figure, e.g. Fig. A.
→ Reference to another section.
PRODUCT DESCRIPTION
Scope of delivery
A
FiltoSmart 60
Quantity
1
Operating manual for FiltoSmart 60
1
2
Unit head
1
3
Blind plug
1
4
Hose connector, inlet (IN)
1
5
Container, filled with filter medium
1
6
Slide closure
1
7
Hose connector, outlet
1
8
Bag with 4 feet
9
Ceramic substrate
(120 g bag)
2
10
Hose
1
11
Flow-out pipe
1
12
Suction pipe
1
B
Connection set
Quantity
1
Suction cup
5
2
Terminal
5
3
Hose adapter
2
4
Angle piece
1
5
Union nut
4
6
Suction basket
1
7
Water distributor
1
8
Cover cap
1
Intended use
FiltoSmart 60, referred to in the following as "unit",
may only be used as specified in the following:
• Water filtering and recirculation
• For operation with freshwater or saltwater.
• Operation under observance of the technical data.
The following restrictions apply to the unit:
• Only use indoors and for aquaristic purposes in the
home (not for commercial use).
• Only operate with water at a water temperature of
+4 °C to +35 °C.
Function description
C
Drawn in by a pump into the pump unit, the water
flows through two filter chambers arranged one be-
hind the other. The first filter chamber is filled with ce-
ramic substrate, the second filter chamber contains a
20ppi foam filter.
ACCESSING THE UNIT
Dismantling the unit head
How to proceed:
D
1. Slide the closure on each side to the "padlock open"
symbol.
2. Lift the unit head from the container.
Fitting the unit head
How to proceed:
E
1. Check that the seal on the unit head is correctly po-
sitioned.
– Clean the seal, replace it if damaged.
2. Ensure that the vent hose is in place and is pointing
upwards.

Chat with your Oase FiltoSmart 60 manual using AI

Get instant AI answers from your Oase FiltoSmart 60 manual

Ask anything about the Oase FiltoSmart 60. Answers come from this manual, with the pages they are based on.

FiltoSmart 60 Maintenance Schedule

Regularly
Check water level and circulation

Regularly check the water level and circulation in the filter and in the aquarium to ensure proper operation.

As needed
Clean unit with clear water and soft brush

If necessary, clean the unit with clear water using a soft brush. Do not use cleaning agents or chemical solutions.

Show in the manual (page 10)
As needed
Rinse or replace foam filter

Remove the foam filter and rinse it in warm water or replace it if worn. Frequency depends on tank size and stocking.

Show in the manual (page 10)
As needed
Rinse or replace ceramic substrate

Rinse the ceramic substrate in warm water or replace it if worn. Frequency depends on tank size and stocking.

Show in the manual (page 10)
As needed
Clean or replace impeller unit

Remove the pump lid, take out the impeller unit, clean it, or replace it if worn. Ensure rubber bearings are seated correctly.

Show in the manual (page 10)
M: qwen/qwen3.8-flash

Ask a Question

0/1000

Do you recommend FiltoSmart 60?

Yes No

Frequently Asked Questions

A

The Oase FiltoSmart 60 is recommended for aquariums with a maximum volume of 60 liters.

Is this answer helpful?

A

Yes, the device is suitable for both freshwater and saltwater operations within the specified temperature range.

Is this answer helpful?

A

Ensure the vent hose is present and pointing upwards when reassembling the unit head to allow air to escape properly.

Is this answer helpful?

A

Thoroughly rinse all filter materials like the ceramic substrate and foam with warm tap water to remove any soiling before installation.

Is this answer helpful?

A

Yes, the unit has an IPX8 protection rating and is waterproof up to a depth of 1 meter.

Is this answer helpful?

M: QW-35-FL

Advantages and Disadvantages

Advantages

  • Compact size fits perfectly in small aquarium setups
  • Dual filtration chambers provide excellent mechanical and biological cleaning
  • IPX8 rating allows safe submersion up to 1 meter depth
  • Easy-to-clean head design simplifies routine maintenance tasks
VS

Disadvantages

  • Hose length is limited to 1 meter which may restrict placement options
  • Ceramic substrate must be rinsed well before first use to avoid cloudiness
  • Pump cannot operate if running dry, requiring careful monitoring
  • Holder for wall mounting is sold separately and not included
M: QW-35-FL

Product Specification

Type

External Filter

Suitability

Freshwater, Saltwater, Aquarium

Flow Rate

79.3 gal/h

Net Pump Head

2.3 ft

Aquarium Size

max. 15.9 gal

Filtration

1.3 qt Filter Volume, 0.74 qt Pre-filter Volume, 1x Pre-filter Insert, 1x Filter Foam (Cartridge), 1x Ceramic Substrate (Filter Rings)

Connections

8/12mm Hose Connections

Power Consumption

5W

Dimensions

5.9x6.5x3.5 in (WxHxD)

Weight

1.88 lbs

Features

Self-priming, Outlet Pipe, Diffuser, Intake Pipe, 1x 3.3 ft Hose, 4.9 ft Cable Length, Includes Inlet/Outlet Set

Manufacturer Warranty

Three Years

M: QW-35-FL

Product Description

Oase FiltoSmart 60 External Filter Review

The Oase FiltoSmart 60 is a versatile external canister filter designed specifically for smaller aquariums up to 60 liters. This unit combines mechanical and biological filtration into a compact design, making it an ideal choice for freshwater or saltwater setups in home environments. The system utilizes a two-chamber filtration process where water first passes through a ceramic substrate for biological cleaning before moving through a 20 ppi foam filter for mechanical debris removal.

Installation is straightforward, allowing the unit to sit beside the tank or be mounted on the outside wall using a separate holder. The package includes all necessary hoses, suction cups, and a connection set with a water distributor option. Before initial use, it is crucial to rinse all filter media thoroughly with warm water to remove manufacturing dust. The pump features an IPX8 protection rating, ensuring it remains safe even if submerged up to one meter deep during operation.

Maintenance involves periodic cleaning of the impeller unit and replacing worn foam filters or ceramic substrates. Users should ensure the vent hose is correctly positioned to prevent air locks, which can cause noise or reduced flow. Always disconnect power before reaching into the water to handle the unit safely. This filter offers a reliable solution for keeping small aquatic habitats clear and healthy without taking up excessive space.

Key Features

  • Compact design suitable for tanks up to 60 liters
  • Dual-stage filtration with ceramic and foam media
  • Safe operation with IPX8 waterproof rating
  • Easy access head design for quick maintenance

Important Notes

  • Do not let the pump run dry as this will destroy the motor.
  • Cut cables before disposal to render the unit unusable.
  • Use only original spare parts for optimal performance.
M: QW-35-FL

© Copyright 2026 Manual.ly