Manual.ly Logo

Growatt ARK HV H Manual

0.0 · 0 Ratings

PDF manual · 17 Pages

English

M: QW-35-FL
page

/ 17

Loading...
b4f614a9a796a894b030106c9c2aa7add077 page c
20
5 Power on/off Battery system
5.1 Power on Battery system
5.2 Power off
Ø The installation and use of batteries need to be operated by
professional technicians.
Ø Do not contact any positions with potential difference.
Ø Prohibition sign should be hung on the battery: " Non - professionals,
do not touch.
Ø If any abnormalities occur during the startup phase, power off the
system immediately. After problem confirmed, proceed again.
Ø Make sure the inverter is turned off before checking the battery system.
Notice
Ø Before turning on the battery, please check if the cable is properly connected.
Power on the battery system by pressing power button(t>5S)
Serial
Procedures
Acceptation criteria
1
Connect the battery and PCS
Make sure the wiring harnesses are well
connected
2
Close the breaker of the battery
system
Make sure the breaker is ON
3
Press POWER button for 5
seconds. Observe the LED
indication on panel..
1. If both RUN/ALM and SOC lights turn on
normally, system is powered on successfully.
2. If RUN/ALM light turns red, there is a failure
and should solve it before power on again.
Fig 5.1
Fig 5.2
Turn the DC breaker of the HVC 60050-
A1(High Voltage Controller) to "Off" to turn
off the entire battery system.
19
Maintenance Guide 6
6.1 Preparation
Before maintenance, please make sure that the battery system is powered off and the DC
circuit breaker is off.
6.2 Battery pack or high voltage controller replacement
Ø Wear safety gloves.
Ø Close the breaker and power off the battery system.
Ø Disconnect power lines and CAN communication lines of the battery system.
Ø Uninstall the safety screws on both sides of the battery pack or high voltage controller.
Lift up the battery pack or high voltage controller.
Ø Put the battery pack or high voltage controller into the packing box according to the
repair procedure and transport the battery pack or high voltage controller to the
designated repair site.
Ø Install new battery pack or high voltage controller based on procedure specified in
Section 4.
6.3 System Failure Information List and Troubleshooting
Suggestions
Error
Indication
Error
description
Error cause
Suggested actions
ALM
( ALM
Light
Flickers)
Discharge under
voltage
protection
Single cell voltage
below the threshold
for under-voltage
protection.
There is over discharge risk. User
should stop discharging and
arrange recharge
Charge over
voltage
protection
Single cell voltage
exceeding threshold
for protection
threshold.
1. There is no safety threat;
2. User should stop charging.
Wait for the battery system to
automatically resolve the fault
External CAN
Communication
failure
Communication loss
between PCS and
battery system.
1. There is no safety threat and
user should stop using battery.
2. Check if PCS and battery
communication terminal is well
connected.
3. If PCS and battery system
cannot communicate when the
communication wire is confirmed
well connected, user should
contact installer to repair battery.
Ø Before replacing the battery, use the charger to charge the new battery
and the existing battery to full (SOC 100%).
Ø If the battery is not used, it is recommended to charge and discharge
the battery every 3 months to activate the chemical characteristics, and
the maximum interval shall not exceed 6 months.
Notice

Chat with your Growatt ARK HV H manual using AI

Get instant AI answers from your Growatt ARK HV H manual

Ask anything about the Growatt ARK HV H. Answers come from this manual, with the pages they are based on.

ARK HV H Maintenance Schedule

Remind me when maintenance is due
Quarterly
Perform discharge/charge cycle if unused

If the battery is not operated for a longer period, perform a discharge/charge cycle every 3 months to maintain chemical properties. Do not exceed 6 months between charges.

Show in the manual (page 12)
Every 6 Months
Charge battery to 40% SOC during long-term storage

If the battery is stored for longer than six months, charge it to 40% State of Charge using a charger every six months.

Free maintenance reminders

Timed to your purchase date. Always free, unsubscribe anytime.

By submitting you agree to the privacy policy. Unsubscribe with one click in any email.
M: qwen/qwen3.8-flash

Ask a Question

0/1000

Do you recommend ARK HV H?

Yes No

Frequently Asked Questions

A

You can connect up to ten ARK 2.5H-A1 battery modules in series to expand the system capacity. This configuration allows you to achieve higher voltage and total energy storage tailored to your specific needs.

Is this answer helpful?

A

Yes, the system has an IP65 rating, making it suitable for outdoor use. However, it must be protected from direct sunlight and rain using appropriate shading or shelter to ensure longevity and safety.

Is this answer helpful?

A

The battery operates between -10°C and +50°C. Performance may be limited when ambient temperatures drop below 0°C, but the system includes thermal management to protect cells and ensure safe operation.

Is this answer helpful?

A

The system is optimized for use with Growatt PCS inverters using the CAN communication protocol. While physical connections might be possible, full functionality and safety features are best realized with compatible Growatt equipment.

Is this answer helpful?

A

If communication between the battery and PCS fails, the system will trigger an alarm. It may stop discharging to prevent unsafe conditions. You should check cable connections and contact a qualified technician if the issue persists.

Is this answer helpful?

A

If storing the battery for more than six months, you must recharge it every six months to a 40% State of Charge (SOC). This prevents deep discharge damage and maintains cell health during long-term inactivity.

Is this answer helpful?

M: QW-35-FL

Advantages and Disadvantages

Advantages

  • Modular design allows scaling from 2 to 10 units for flexible capacity
  • High safety standards with LFP chemistry and comprehensive BMS protection
  • IP65 rated enclosure supports versatile indoor and outdoor installation
  • Excellent round-trip efficiency minimizes energy waste during cycles
  • Real-time monitoring via CAN protocol ensures stable system operation
VS

Disadvantages

  • Requires professional installation due to high voltage and safety risks
  • Initial setup cost may be higher compared to lower voltage alternatives
  • System performance can degrade slightly in extreme cold temperatures below zero
  • Strict compatibility requirements limit use with non-Growatt inverters
  • Heavy modules require reinforced mounting structures for wall installation
M: QW-35-FL

Product Specification

Note

Prices include partial 0% VAT rates for AT and DE

Battery Type

LiFePO4

Operating Temperature

14°F to 122°F

Lifespan

10 years

Display

No

Features

Battery Management System, State of Charge Indicator, Soft Start, Emergency Power Function

Interfaces

RS-485

Mounting Type

Freestanding (stackable), Wall-mounted

Protection Class

IP65

M: QW-35-FL

Product Description

Unlocking Energy Independence with the Growatt ARK HV H

The Growatt ARK HV H represents a significant leap in residential and commercial energy storage, designed to maximize solar self-consumption and ensure power reliability during outages. This high-voltage battery system integrates seamlessly with Growatt inverters to create a robust energy ecosystem. By utilizing advanced Lithium Iron Phosphate (LFP) technology, the system offers superior safety, extended cycle life, and consistent performance across varying environmental conditions.

At the heart of the ARK HV H is a modular architecture that allows for scalable deployment. Users can configure the system by connecting between two and ten battery modules in series, tailoring the total capacity to meet specific energy demands. Whether powering a single home or a small business facility, the system intelligently manages energy flow. During daylight hours, excess solar generation is stored efficiently, while at night or during grid failures, the battery discharges to keep essential loads running without interruption.

Installation flexibility is a key feature, supporting both wall-mounted and floor-standing configurations. The unit boasts an IP65 rating, making it suitable for indoor and outdoor environments provided it is shielded from direct weather exposure. Advanced monitoring capabilities via CAN communication allow real-time tracking of voltage, current, and temperature, ensuring optimal operation and immediate alerts for any anomalies. Safety is paramount, with built-in protections against overvoltage, overheating, and short circuits, all managed by a sophisticated Battery Management System (BMS).

Key Operational Highlights

The system operates within a wide temperature range, maintaining efficiency even in challenging climates. Its high round-trip efficiency ensures minimal energy loss during charge and discharge cycles. Regular maintenance is straightforward, with clear indicators guiding users through diagnostics and module replacement if necessary. The integration of smart software updates ensures the system evolves with new features and security patches.

Important Notes

  • Always ensure professional installation to maintain warranty validity.
  • Regularly check ventilation areas to prevent overheating.
  • Use only compatible Growatt components for optimal performance.
  • Store spare modules in a dry, climate-controlled environment.
M: QW-35-FL

© Copyright 2026 Manual.ly