Manual.ly Logo

Voltcraft VC-JS-800A-WP Manual

0.0 · 0 Ratings

PDF manual · 12 Pages

English

M: OA-GPT-5-NAN
page

/ 12

Loading...
b9e746ab99bd26529c65324fe7e40015e8b5 page 6
6
11.2 Protection mode
Status indicator Status
Red steady/red flashing Connection error. Please check all contacts.
Red on/alarm sound on
■
Reversed polarity: check if the clamps are connected the
wrong way around.
■
Short-circuit: Both cables are clamped together or clamped to
the same piece of conductive metal.
Red steady on
■
Reverse charging protection is triggered. Voltage of the con-
nected battery is >12.6 V.
■
The jump starter is not needed as the vehicle battery is
enough to start the vehicle.
Red flashing quickly Over temperature: Clamp >65 (±5) ºC. Remove the clips until the
starter status indicator returns to normal (alternating red/green
flashing).
Green flashing slowly Quick start battery charge is too low, recharge it.
12 Cleaning and care
Important:
– Do not use aggressive cleaning agents, rubbing alcohol or other chemical solutions.
They damage the housing and can cause the product to malfunction.
– Do not immerse the product in water.
1. Disconnect the product from the power supply.
2. Clean the product with a dry, fibre-free cloth.
13 Disposal
This symbol must appear on any electrical and electronic equipment placed on
the EU market. This symbol indicates that this device should not be disposed of
as unsorted municipal waste at the end of its service life.
Owners of WEEE (Waste from Electrical and Electronic Equipment) shall dispose
of it separately from unsorted municipal waste. Spent batteries and accumulators,
which are not enclosed by the WEEE, as well as lamps that can be removed from
the WEEE in a non-destructive manner, must be removed by end users from the
WEEE in a non-destructive manner before it is handed over to a collection point.
Distributors of electrical and electronic equipment are legally obliged to provide free take-
back of waste. Conrad provides the following return options free of charge (more details on
our website):
■
in our Conrad offices
■
at the Conrad collection points
■
at the collection points of public waste management authorities or the collection points
set up by manufacturers or distributors within the meaning of the ElektroG
End users are responsible for deleting personal data from the WEEE to be disposed of.
It should be noted that different obligations about the return or recycling of WEEE may apply
in countries outside of Germany.
14 Technical data
14.1 General
Charging input (Micro-USB) ........... 5 V/DС 2.0 A
recharge time 6 hrs
Charging input (USB-C®)............... 5 V/DC 2.0 A
recharge time 6 hrs
Rechargeable battery ..................... 14.8 V 37 Wh, Li-ion (non-removeable),
10000 mAh (4x type 606080)
LED light modes ............................. Constant ON → SOS → flashing → OFF
Ingress protection........................... IP68
Protection mechanisms .................. Over temperature:
- discharging: 60 °C ±5 °C
- recharging: 60 °C ±5 °C
Low temperature:
- discharging: -20 °C ±5 °C
- recharging: -20 °C ±5 °C
Overvoltage (USB inputs): max. 6 V
Overcharge: 16.6 V
Over discharge:
- software protection: ≤13 V ±0.3 V 12.5 V - 13 V
- hardware protection: 10.8 V - 11 V
Overcurrent: 3.4 - 3.7 A
Operating conditions....................... Sockets cover open: -20 to +60 °C, 20 – 85 % RH
(non-condensing)
Sockets cover closed: -20 to +60 °C
Storage conditions.......................... Sockets cover open:
0 to +45 °C, 20 – 85 % RH (non-condensing)
Sockets cover closed: 0 to +45 °C
Dimensions (L x W x H).................. 168 x 92 x 38 mm
Weight ............................................ 520 g
14.2 Power bank
Output 1 (USB-A) ........................... 5 V/DC 3 A, 9 V/DC 2 A, 12 V/DC 1.5 A (max. 18 W)
Output 2 (USB-A) ........................... 5 V/DC 3 A, 9 V/DC 2 A, 12 V/DC 1.5 A (max. 18 W)
14.3 Jump starter
Vehicle on-board system................ 12 V/DC
Start current (peak value)............... 400 A (800 A)
Jump starts..................................... approx. 15 (affected by factors such as ambient
temperature, size, and mechanical condition of the
engine)
Suitable engine types ..................... Petrol (displacement ≤6.0 L), Diesel (displacement
≤4.0 L)
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method (e.g. photocopying, microfilming or the capture in
electronic data processing systems) requires prior written approval from the editor. Reprinting, also in part, is prohibited.
This publication reflects the technical status at the time of printing.
Copyright by Conrad Electronic SE.
*2812940_V2_0823_dh_mh_en 9007200149572235-2 I2/O2 en

Chat with your Voltcraft VC-JS-800A-WP manual using AI

Get instant AI answers from your Voltcraft VC-JS-800A-WP manual

Ask anything about the Voltcraft VC-JS-800A-WP. Answers come from this manual, with the pages they are based on.

VC-JS-800A-WP Maintenance Schedule

Remind me when maintenance is due
Every 3 months
Fully charge the battery

To prolong battery life, fully charge the battery every 3 to 6 months even if not using the product.

Every 6 months
Clean the product

Disconnect from power and clean with a dry, fibre-free cloth. Do not use aggressive agents or immerse in water.

Free maintenance reminders

Timed to your purchase date. Always free, unsubscribe anytime.

By submitting you agree to the privacy policy. Unsubscribe with one click in any email.
M: QW-35-FL

Ask a Question

0/1000

Do you recommend VC-JS-800A-WP?

Yes No

Frequently Asked Questions

A

The unit is designed for 12 V onboard vehicle systems: petrol engines up to 6.0 L displacement and diesel engines up to 4.0 L. It must not be used on higher-voltage systems or engines beyond those limits.

Is this answer helpful?

A

Perform start attempts of no more than 3 seconds each, allow 30 seconds cooling between attempts, and limit to a maximum of three attempts within two minutes. If unsuccessful, disconnect and use the force-start method or consult a specialist.

Is this answer helpful?

A

Charge via USB-C or Micro-USB input (both 5 V / 2 A). Typical recharge time is about 6 hours. Do not charge via a computer USB-A port; it may provide insufficient current and risk damage.

Is this answer helpful?

A

The device has an IP68 rating and is protected from dust and strong water jets when the sockets cover is closed, making it suitable for outdoor use. Do not submerge it in water and avoid moisture contact when the cover is open.

Is this answer helpful?

A

Built-in protections include reverse polarity detection, short-circuit protection, overcurrent and over/under-voltage safeguards, thermal monitoring (overheat alerts if clamps exceed ~65°C) and software/hardware cutoffs to prevent damage and ensure safe operation.

Is this answer helpful?

A

After the engine starts, disconnect the black (negative) clamp first, then the red (positive) clamp. Replace the sockets cover and let the vehicle run for about 30 minutes to recharge the vehicle battery.

Is this answer helpful?

A

No. The Li-ion battery is permanently built into the unit and cannot be user-replaced. Repairs or battery service must be performed by authorized technicians to avoid safety risks.

Is this answer helpful?

M: OA-GPT-5-NAN

Advantages and Disadvantages

Advantages

  • IP68 rating protects against dust and strong water jets when ports are closed.
  • High peak start current (400 A, 800 A peak) suitable for petrol ≤6.0 L and diesel ≤4.0 L.
  • Dual fast-charge USB-A outputs (up to 18 W each) plus USB-C and Micro-USB charging inputs.
  • Integrated LED with constant, SOS and flashing modes aids roadside visibility and emergencies.
  • Multiple safety protections: reverse polarity, overcurrent, over/under-voltage, and thermal cutoffs.
VS

Disadvantages

  • Battery is non-removable—professional service required if battery fails.
  • Do not submerge despite IP68; protection valid only with ports cover closed.
  • Charging via a computer USB-A port is discouraged due to insufficient current.
  • Limited to 12 V vehicle systems; not suitable for larger engines beyond specified limits.
  • Requires careful adherence to start attempt limits and cooling intervals to avoid overheating.
M: OA-GPT-5-NAN

Product Specification

Battery Type

Lithium-ion

Capacity

10000mAh (37Wh)

Output

2x USB-A (socket, 18W)

Input

1x USB Micro-B (socket, 10W), 1x USB-C (socket, 10W), max. 10W

Features

Charge level indicator (4x LED), Flashlight, Car jump start function, IP68-certified

Color

black, red

Dimensions

6.61x3.62x1.50in

Weight

1.15lb

Volume

35.83in^3

M: OA-GPT-54-NAN

Product Description

Voltcraft VC-JS-800A-WP IP68 3-in-1 jump starter Manual

The Voltcraft VC-JS-800A-WP is a rugged, IP68-rated 3-in-1 jump starter and fast-charging power bank designed for modern motorists and outdoor use. Combining a 10,000 mAh Li-ion battery, dual USB-A outputs (up to 18 W each), and a high-current starter function, this compact unit (168 x 92 x 38 mm, 520 g) handles emergency jump starts for 12 V vehicle systems — petrol engines up to 6.0 L and diesel engines up to 4.0 L. It includes smart starter cables, USB-C and Micro-USB charging leads, a storage case and an integrated LED light with constant, SOS and flashing modes for roadside visibility.

Built for reliability in harsh conditions, the device’s IP68 protection guards against dust and powerful water jets when the ports cover is closed; it is suitable for outdoor use but must not be submerged. Safety features include reverse polarity protection, overcurrent and over/under-voltage safeguards, thermal monitoring, and software/hardware cutoffs to protect both the unit and vehicle battery. Status LEDs clearly indicate ready, force-start, protection errors, overheating, low battery and wiring faults so users can diagnose issues quickly.

In normal operation the starter provides a peak start current of 400 A (800 A peak quoted) and supports quick start procedures with cooling intervals: each attempt should be no longer than 3 seconds, with up to three attempts within two minutes and 30 seconds cooling between attempts. If normal starting fails, a force-start mode can be engaged by holding the dedicated button for 3 seconds; the LED will turn steady green and you have 30 seconds to attempt starting. After a successful start, remove the black clamp first, then the red, and let the vehicle run about 30 minutes to recharge its battery.

As a power bank the unit supplies fast charge outputs (5V/3A, 9V/2A, 12V/1.5A) for mobile devices. Charging inputs include USB-C and Micro-USB (both 5V/2A, ~6 hours charge). Regular charging every 3–6 months is recommended to prolong battery life. Important safety notes stress avoiding charging from computer USB-A ports, not charging unattended, and always keeping sockets covered to prevent moisture ingress.

Practical accessories and clear instructions make the Voltcraft VC-JS-800A-WP a versatile emergency tool for drivers, campers and technicians who need a portable, weather-resistant starter with multi-device charging and visible LED signaling. Follow all safety guidance: wear eye protection when working with lead-acid batteries, avoid flammable atmospheres, keep clear of moving engine parts, and never attempt to modify the unit.

Notes

  • Always inspect clamps and cables before use; do not use if damaged.
  • Ensure the jump starter is at least 50% charged before attempting a start.
  • The device is not user-serviceable; the Li-ion battery is non-removable.
  • Store in a dry place with the ports cover closed; adhere to specified temperature ranges.
M: OA-GPT-5-NAN

© Copyright 2026 Manual.ly