Manual.ly Logo

Shark Helmets EvoLine Series 3 Manual

0.0 · 0 Ratings

PDF manual · 106 Pages

English

M: qwen/qwen3.5-flash-20260224
page

/ 106

Loading...
91c7425f2f266e9d7c590e40ba03a9cb19d9 page 3
3
WARNINGS and INSTRUCTIONS
1. This helmet is for use only with motorcycles
ridden on the street or other paved surfaces.
Never use this helmet off road, on snowmobiles,
in automobiles, etc.
2. Always ride with care. Even though this
helmet meets or exceeds many of the world’s
most demanding standards for helmet
production, no helmet can protect the wearer
from all foreseeable high or low speed impacts.
All safety equipment have limits, and you
could still sustain a head injury in an accident
even if you are wearing a helmet. However,
for maximum protection against death or
permanent impairment from a head injury,
the helmet must fit firmly on your head and
the chinstrap must be securely fastened as
described in this manual.
3. The helmet is designed to absorb only one
impact by partial destruction of the shell and/
or liner. This damage may not be visible to you.
Therefore, if your helmet is subjected to any
impact, even if it is only dropped to the ground,
the helmet should be returned for inspection or
replaced and destroyed even if it is apparently
undamaged. If you have any doubts, and you
are not sure whether this «one impact» rule
applies, consult your dealer before you use your
helmet again.
4. A helmet, like all products, may wear out
over time depending on the conditions of use.
Please check your helmet every time you use
it for evidence of damage or wear. The helmet
should always fit snugly all around your head.
If it is not snug, it has become too big for you
and should be replaced. Never wear a damaged
helmet. Even if the helmet does not show any
evidence of damage or wear, we recommended
the helmet to be replaced five years after it is
first purchased.
5. Make no modifications whatsoever to your
helmet. Never drill or cut any component of
the helmet. Modifications can significantly
weaken your helmet, thereby eliminating its
ability to protect you from an impact.
6. Handle your helmet carefully. Never sit on
it or drop it to the ground. Never ride with
the helmet hanging from any part of your
motorcycle.
7. Never use petroleum or petroleum products,
chemicals or any other solvents to clean the
helmet, shell or visor. In addition, never expose
your helmet to the fumes of these solvents (for
example by leaving it on top of the fuel tank
cap on your motorcycle). Your helmet could be
seriously damaged by these agents, without
this damage being visible to you, thereby
eliminating its ability to protect you. Use only
mild soap, warm water, and a soft cloth to wipe
your helmet and visor clean.
8. Never apply any paint, stickers or adhesive
tape to any part of your shell or visor. They
could significantly weaken your helmet, without
this damage being visible to you, thereby
eliminating the helmet’s ability to protect you.
9 . You will experience some reduction in
hearing, peripheral vision and head movements
while you are wearing your helmet. Please ride
accordingly.
10. Dry your helmet at room temperature. Never
subject it to heat in excess of 160°F/70°C,
which can occur if your helmet is stored in the
passenger compartment or trunk of a car.
11. If you ever have any comments or questions
about this helmet, please contact Harley-
Davidson or your nearest dealer.
No warranty or representation is made
as to this product’s ability to protect the
user from all foreseeable high or low speed
impacts or from any injury or death; The user
of this helmet recognizes and agrees that
there are risks inherent in motorcycle riding,
including but not limited to the risk that your
helmet cannot protect against all foreseeable
high or low speed impacts. By his/her purchase
and use of this helmet, the user expressly,
voluntarily and knowingly accepts and assumes
these risks and agrees to hold Harley-Davidson
harmless to the fullest extent permitted by law
against any resulting damages.
OwnerManualEvoCarbon.indd 3 24/07/14 16:04

Chat with your Shark Helmets EvoLine Series 3 manual using AI

Get instant AI answers from your Shark Helmets EvoLine Series 3 manual

Ask anything about the Shark Helmets EvoLine Series 3. Answers come from this manual, with the pages they are based on.

EvoLine Series 3 Maintenance Schedule

Remind me when maintenance is due
Every 5 years
Replace helmet

Replace the helmet five years after first purchase even if no damage is visible.

Every use
Inspect for damage and fit

Check helmet every time you use it for evidence of damage, wear, or if it fits snugly.

After any impact
Inspect or replace helmet

If subjected to any impact or dropped, return for inspection or replace immediately.

As needed
Clean interior padding

Hand wash cheek pads and head section in warm soapy water; air dry completely at room temperature.

Show in the manual (page 22)
As needed
Clean visor and sun shield

Soak in tepid water with neutral soap and soft cloth; do not use solvents or alcohol.

Show in the manual (page 18)

Free maintenance reminders

Timed to your purchase date. Always free, unsubscribe anytime.

By submitting you agree to the privacy policy. Unsubscribe with one click in any email.
M: QW-35-FL

Ask a Question

0/1000

Do you recommend EvoLine Series 3?

Yes No

Frequently Asked Questions

A

Press the red button on the chin protection to unlock. Lift the chin section forward until it locks at the back. Always perform this while stationary to ensure safety.

Is this answer helpful?

A

Replace the helmet immediately. Impact damage may not be visible. Continued use compromises safety and structural integrity.

Is this answer helpful?

A

The helmet lasts approximately five years from purchase. Replace it sooner if any impact occurs or if fit becomes loose.

Is this answer helpful?

A

Yes, use mild soap and water. Never use solvents, petroleum, or abrasive pastes as they damage the coating.

Is this answer helpful?

A

No. Never drill, cut, paint, or sticker the helmet. Modifications weaken the structure and eliminate protection.

Is this answer helpful?

A

Remove cheek pads and head liner. Wash with mild soap and warm water by hand. Do not use a dryer. Air dry completely.

Is this answer helpful?

A

Never use the sun shield at night or in poor visibility. Keep it raised. Use only the clear visor for night riding.

Is this answer helpful?

M: qwen/qwen3.5-flash-20260224

Advantages and Disadvantages

Advantages

  • Converts effortlessly between integral and Jet configurations for versatility.
  • High quality polycarbonate visor with anti-scratch and anti-fog treatment.
  • Effective ventilation system to reduce fogging and heat during rides.
VS

Disadvantages

  • Must be replaced after 5 years regardless of visible condition.
  • Replacement required immediately after any impact or drop occurs.
  • Cannot use solvents or paint, limiting customization options significantly.
M: qwen/qwen3.5-flash-20260224

Product Specification

Type

Modular Helmet

Weight

3.97 lbs

M: qwen/qwen3.5-flash-20260224

Product Description

Experience the ultimate versatility on the road with the Shark Evoline series3. Available in various colors and sizes, this modular helmet delivers exceptional performance for riders seeking flexibility. The innovative design allows the rider to switch between an integral full-face configuration and an open face Jet style. This conversion is secure and stable, ensuring aerodynamic integrity in every mode. The chin bar retracts perfectly without causing stability or weight imbalance. Refer to the Shark Evoline series3 (various colors/sizes) Manual for precise operation instructions regarding the conversion mechanism. Protection is a core priority. The helmet features a shell designed to absorb shock impact, utilizing high-quality materials for durability against high and low speed impacts. Safety starts with fit. Riders should measure their head circumference to ensure the helmet fits snugly without gaps. The chin strap system offers advanced locking mechanisms, including the Precise Lock or Double-D ring options. Always test the fit by checking for movement limits when fastened. If the helmet feels too loose, select a smaller size immediately.

Visor quality cannot be overlooked. The integrated visor uses injected polycarbonate to resist scratches and impacts. It offers excellent optical quality labeled Total Vision. Anti-fog and anti-scratch treatments extend visibility and lifespan. An external sun shield button controls the tinted insert for varying light conditions. Never use tinted visors at night or in poor visibility. Proper ventilation channels manage airflow to prevent overheating and fogging. The conversion process is simple. Press the red button on the chin protection to unlock. Lift the chin section forward until it locks at the back. Always perform this while stationary. Never convert while riding. The sun shield should be kept up in tunnels or at night.

The textile parts are washable. Remove cheek pads and head liner for hand washing with warm water. Do not use a dryer. Maintenance requires strict adherence to care instructions. Clean the textile parts with mild soap and water. Never use solvents or petroleum products on the shell or visor. Do not paint or sticker the helmet as this weakens the structure. Replace the helmet after five years or if any impact occurs, even if damage is not visible. Air dry all parts completely before reassembly. This ensures correct fit and safety. This gear combines style and function for modern motorcyclists. Whether commuting or touring, it offers reliable protection. Remember to keep the manual available for future reference regarding fit checks and care procedures. Ensure the sun shield is functional. Always buy genuine replacement parts.

Important Notes:

Check padding wear regularly. Ensure chin strap length is correct. Never drill into the shell. Verify visor locking mechanism before every ride. Protect from heat above 70 degrees Celsius. Do not modify the helmet. Consult official sources for warranty info and safety updates. Keep head measurement records for future size checks.

M: qwen/qwen3.5-flash-20260224

© Copyright 2026 Manual.ly