Manual.ly Logo

Scott Keeper 2 Manual

0.0 · 0 Ratings

PDF manual · 56 Pages

English

M: OA-GPT-5-NAN
page

/ 56

Loading...
8b1638c955bc6a5bac67eeb1fe5e34d6295f page 9
SCOTT COULOIR MOUNTAIN | WHEL1702, SCOTT COULOIR FREERIDE | WHEL1902,
SCOTT COULOIR TOUR RE-SOURCE
| WHEL1902
HALO fit system : You can easily adjust the height when
the helmet is on your head. If your helmet does not fit
your head comfortably when in the middle position,
then push the rear of the fit system up or pull it down
to adjust the height of the rear of the fit system. There
are three positions in total. Please make sure that each
arm of the fit system is securely clicked into the helmet.
1
2
3
F. ADDITIONAL ADJUSTMENTS OF THE STRAPS AT YOUR EARS
The strap guide should be positioned so that it fits just under your earlobes. To do this, push
the strap guide up or down until you find the proper position. If you are satisfied with these
adjustments, put the helmet on and try to pull the helmet off your head from the back and
the front. A helmet that fits properly should be comfortable without sliding forwards or
backwards. If you are not able to adjust your chosen helmet accordingly, THEN DO NOT
USE THE HELMET - replace it with a different size helmet or a different model.
Note : Please always make sure your helmet (or your child’s helmet) is properly adjust
-
ed each time before starting your activity. If you have any questions, please contact your
SCOTT dealer.
G. ADDITIONAL INFORMATIONS
SCOTT helmets can be used with or without ear covers. Be aware that, without the ear cov-
ers, the helmet’s protective capacity can only be achieved in part and that the exposed
parts of your ears may be injured during a fall or the like.
• VII. INSTRUCTIONS
A. CARE AND CLEANING
Clean your helmet with a soft cloth or sponge, warm water, and mild soap. Helmets are made
of material that can be damaged by many traditional cleaning agents. Solvents or cleaning
agents with a petroleum base are particularly dangerous. These can damage the helmet to
such an extent that its protective ability is significantly compromised. Damage is often not
noticeable. SCOTT Sports is not liable for any damages caused by improper cleaning.
Lining : You can easily remove the inner lining by hand and wash it by hand using a mild
soap. Never machine-wash the lining pieces at high temperatures.
For cleaning, maintenance or disinfection, use only substances that have no adverse effect
on the helmet and are not known to be likely to have any adverse effect upon the wearer.
B. TRANSPORTATION AND STORAGE
When transporting or storing keep your helmet in the soft bag if supplied in the retail box.
Let your helmet air dry after each use and then store it in a cool dry place. Excessive heat
can damage your helmet. In direct sunlight, dark equipment cases or trunks of automobiles
can become so hot as to cause heat damage. Heat damaged helmets are recognizable by
uneven or blistered surfaces. Exposure to sunlight may cause color fading. SCOTT Sports
SA shall not be liable for any damages and losses due to improper storage.
C. CHECKING OF WEAR AND TEAR
It is recommended to regularly inspect your gear. If doubtful, please ask an expert or
your friendly dealer. The protection it offers could be reduced due to mechanical wear or
improper use. Before use, please check the product for any damage to the straps, stitch
-
ing and pads. Dispose of the product if you notice any damage.
D. DISPOSAL
Dispose of the products in the domestic waste. Do not tamper or incinerate the product.
This may lead to potential hazards.
9 - ENGLISH

Chat with your Scott Keeper 2 manual using AI

Get instant AI answers from your Scott Keeper 2 manual

Ask anything about the Scott Keeper 2. Answers come from this manual, with the pages they are based on.

Keeper 2 Maintenance Schedule

Remind me when maintenance is due
Every 3 years
Replace the helmet

Replace the product three years after the purchasing date for optimum safety, even if no damage is visible.

After every use
Air dry the helmet

Let your helmet air dry after each use before storing it in a cool, dry place.

Regularly
Inspect for wear and damage

Check straps, stitching, and pads before use. Replace if any damage is found or if the helmet has sustained a severe impact.

As needed
Hand wash the inner lining

Remove the lining by hand and wash with mild soap. Do not machine wash at high temperatures.

Free maintenance reminders

Timed to your purchase date. Always free, unsubscribe anytime.

By submitting you agree to the privacy policy. Unsubscribe with one click in any email.
M: QW-35-FL

Ask a Question

0/1000

Do you recommend Keeper 2?

Yes No

Frequently Asked Questions

A

The helmet is intended for skiing, snowboarding and related mountain activities. It is certified to EN 1077 for alpine skiing/snowboarding; some SCOTT models also meet EN 12492 for mountaineering. It is not designed for motorized vehicles or mopeds.

Is this answer helpful?

A

Measure head circumference and consult the manufacturer’s size chart. Try helmets on before purchase: a correct fit moves minimally when twisted and sits low on the forehead just above the eyebrows. If the helmet shifts significantly, try a different size or adjust the fit system.

Is this answer helpful?

A

Fasten the chin strap securely and tighten so you can still chew and swallow comfortably. Guide the strap’s loose end through the rubber O-ring to prevent loosening. Magnetic or ratchet buckles should click or lock firmly; give a quick tug to verify closure.

Is this answer helpful?

A

Replace the helmet after any severe impact even if it appears undamaged, because energy-absorbing foam may be compromised. For optimum safety, SCOTT recommends replacing helmets three years after purchase or sooner if wear or damage is evident.

Is this answer helpful?

A

Clean with a soft cloth, warm water and mild soap; avoid solvents or petroleum-based cleaners. Remove and hand-wash inner padding. Air dry after use and store in a cool, dry place away from direct sunlight and excessive heat to avoid material degradation.

Is this answer helpful?

A

Only attach accessories if the manufacturer issues a declaration of no objection. As a general rule, helmet-compatible goggles or headlamps should be attached with an elastic band. Unauthorized modifications can compromise safety and void warranty.

Is this answer helpful?

A

No. The helmet reduces the risk of skull and head injuries in covered areas but cannot protect the face, throat, neck, or spinal column. No helmet can prevent all injuries or fatalities in every accident scenario, especially collisions with motor vehicles.

Is this answer helpful?

M: OA-GPT-5-NAN

Advantages and Disadvantages

Advantages

  • Junior-focused sizing and fit systems (dial-adjustment) for secure, comfortable wear.
  • Complies with EN 1077 safety standards for skiing and snowboarding protection.
  • Lightweight construction with removable, hand-washable inner lining for hygiene.
  • Glove-friendly buckles (magnetic or ratchet) and strap guides positioned for correct fit.
  • Clear care, storage and replacement guidance to preserve protective performance.
VS

Disadvantages

  • Protection limited to areas covered by helmet; face, neck, and spine remain unprotected.
  • Must be replaced after severe impact and recommended every three years—ongoing cost.
  • Not suitable for motorized activities (motor sports, mopeds) or non-intended uses.
  • Incorrect fit or modifications void protection and increase injury risk.
  • Certain cleaning agents and heat exposure can irreversibly damage helmet materials.
M: OA-GPT-5-NAN

Product Specification

Type

Helmet

Visor

no

Sizes

20.08-21.65in (S), 21.65-23.23in (M)

Features

Goggle holder, Adjustment system, Ventilation

M: OA-GPT-54-NAN

Product Description

Scott Keeper 2 Helmet (Junior) Manual

The Scott Keeper 2 Helmet (Junior) is a youth-focused winter sports helmet designed to deliver dependable head protection, comfortable fit, and easy adjustability for skiing and snowboarding. Built on SCOTT’s safety standards and fit systems, it targets young riders who need a lightweight, well-ventilated helmet with secure retention and intuitive adjustment features.

Product overview

This junior helmet follows the same platform principles as SCOTT’s adult lines: certified compliance with EN 1077 (ski/snowboard) standards, careful sizing guidance, and a focus on proper fit and care. The Keeper 2 shares design cues such as low-profile coverage over the forehead, integrated strap guides positioned beneath the earlobes, and a comfortable, removable lining that can be hand-washed. Emphasis is placed on choosing the correct size using the manufacturer’s size chart and testing the fit by attempting gentle head rotations to ensure minimal movement.

Fit and adjustment

The helmet includes an adjustable fit system (dial-based WRAS/WRAS 2 / HALO style) that allows micro-adjustments for a snug but comfortable seal. The chin strap is intended to be secured under the chin and tightened so the helmet remains stable during activity; strap ends are passed through a rubber O-ring to prevent loosening. Magnetic or ratchet buckles (depending on model variants) allow quick fastening and are designed to be glove-friendly for juniors.

Safety and intended use

Designed expressly for skiing, snowboarding and related mountain activities, the Keeper 2 reduces the risk of skull and head injuries for impacts covered by the helmet shell. It does not protect the face, neck, or spine. SCOTT recommends replacing helmets after severe impacts and generally within three years of purchase for optimal protection. The product complies with relevant PPE regulations and bears CE/UKCA markings where applicable.

Care and maintenance

Clean with mild soap and warm water; avoid solvents or petroleum-based cleaners that can degrade materials. Remove and hand-wash inner padding only. Store the helmet dry in a cool place and avoid prolonged exposure to heat or direct sunlight. Inspect regularly for wear, damaged straps, stitching or padding; replace if any compromise is found.

Notes

  • Always fit and test a helmet before use; do not borrow helmets between users.
  • Never modify the helmet or attach accessories unless approved by SCOTT.
  • Replace the helmet after a significant impact even if damage is not visible.
  • Helmets are not suitable for motorized vehicle use or mopeds.
M: OA-GPT-5-NAN

© Copyright 2026 Manual.ly