Manual.ly Logo

Revell Roxter Manual

3.5 · 4 Ratings

PDF manual · 28 Pages

English

M: OA-GPT-54-NAN
page

/ 28

Loading...
ceaab015a3d628cde2ff746a6ac3fc518c80 page 6
Deutsch
Deutsch
10 11
7 FLUGSTEUERUNG
Hinweis: Ihr Hubschrauber ist so eingestellt, dass er von sich aus
vorwärts fliegt.
7B Zum Landen oder um tiefer
zu fliegen, den Schubregler
nach hinten bewegen.
Für ein ruhiges Flugverhalten des
Helikopters sind nur minimale
Korrekturen am Regler nötig.
7D Um Rechtskurven zu
fliegen, den Richtungsregler
vorsichtig nach rechts bewegen,
sofern der Helikopter mit dem
Heck zum Piloten zeigt.
7A Um zu starten oder an
Flughöhe zu gewinnen, den
Schubregler vorsichtig nach
vorn bewegen.
7C Um Linkskurven zu fliegen,
den Richtungsregler vorsichtig
nach links bewegen, sofern der
Helikopter mit dem Heck zum
Piloten zeigt.
6 TRIMMEN DER STEUERUNG
Die richtige Trimmung ist die Grundvoraussetzung für ein einwandfreies
Flugverhalten des Helikopters.
6A
Dreht sich der Helikopter von
selbst schnell oder langsam nach
rechts, dann so lange die Tasten
für die gegenläufige Trimmung
nach links immer wieder kurz
antippen, bis sich der Helikopter
nicht mehr von selbst dreht.
Die Trimmtasten keinesfalls
einfach nur dauerhaft drücken.
Wenn sich der Helikopter
von selbst schnell oder
langsam nach rechts dreht
…
Dreht sich der Helikopter von
selbst schnell oder langsam
nach links, dann so lange die
Tasten für die gegenläufige
Trimmung nach rechts immer
wieder kurz antippen, bis sich
der Helikopter nicht mehr
von selbst dreht. Die Trimm-
tasten keinesfalls einfach nur
dauerhaft drücken.
Wenn sich der Helikopter
von selbst schnell oder
langsam nach links dreht
…
6B
4 AUFLADEN DES HELIKOPTERS
Achtung: Vor dem Laden und nach jedem Flug muss der Akku 10 bis
15 Minuten abkühlen. Andernfalls kann die Flugbatterie beschädigt
werden. Der Ladevorgang wird elektronisch überwacht, trotzdem nicht
unbeaufsichtigt lassen.
• Den Helikopter und die Fernsteuerung ausschalten.
• Den Hubschrauber vorsichtig mit der Rumpfspitze nach oben auf die
Fernsteuerung aufsetzen. Hierbei darauf achten, dass die Platine mit
den Kontakten in den Schacht an der Fernsteuerung geführt wird (4A).
• Der Ladevorgang beginnt, wenn die blaue Lade-LED im Hubschrauber
leuchtet (4B).
• Der Ladevorgang ist abgeschlossen, sobald die Lade-LED erlischt.
• Nach dem Ladevorgang den Hubschrauber von der Fernsteuerung
abnehmen.
Nach einer Ladezeit von 20-30 Minuten kann der Helikopter
ca. 5-7 Minuten lang fliegen.
5 STARTVORBEREITUNG
Der Schubregler (der linke Regler der Fernsteuerung) muss vor dem
Einschalten nach unten zeigen (5A). Anschließend den ON/OFF-Taster
der Fernsteuerung kurz drücken (5B), die Power LED blinkt rot. Nun
den ON/OFF-Schalter auf der Unterseite des Helikopters auf „ON“ stellen
(5C). Den Helikopter auf den Boden setzen, sodass das Heck in ihre
Richtung zeigt. Danach einmal kurz mit dem linken Steuerknüppel
Vollgas geben, danach leuchtet die Power-LED an der Fernsteuerung
2 FERNSTEUERUNG
2A Schubregler Auf/Ab
2B ON/OFF-Taste
2C Infrarot-Sender
2D Steuerregler für Links/Rechts
2E Trimmtasten Links/Rechts
2F Ladestation
2G Power-LED
2H Batteriefach-Abdeckung
3 BATTERIEN EINSETZEN (FERNSTEUERUNG)
3A Abdeckung aufschrauben und abnehmen.
3B 4 x 1,5 V AA-Batterien einlegen und auf die Polaritätsangaben, wie
im Batteriefach angegeben, achten.
3C Die Batteriefach-Abdeckung schließen und verschrauben.
dauerhaft rot. Nun ist der Hubschrauber startbereit. Nach dem Flug
zuerst den Hubschrauber, danach die Fernsteuerung ausschalten. Zum
Ausschalten der Fernsteuerung den ON/OFF-Taster etwa 3 Sekunden
lang gedrückt halten

Chat with your Revell Roxter manual using AI

Get instant AI answers from your Revell Roxter manual

Ask anything about the Revell Roxter. Answers come from this manual, with the pages they are based on.

Roxter Maintenance Schedule

After every flight
Cool down the battery before charging

Allow the battery to cool for 10 to 15 minutes after every flight before charging to prevent damage.

Before each flight
Check product function

Verify that the product is working correctly before every flight.

As needed
Replace damaged rotor blades

If rotor blades are damaged, replace them following the specific procedure in section 8.

When not used
Remove remote control batteries

Remove batteries from the remote control when it is not in use or for extended periods.

M: QW-35-FL

Ask a Question

0/1000

Do you recommend Roxter?

Yes No
0
User Pic

Maarten Blom

7 months ago

The listing says age 8+. Is the toy actually suitable for children? Ours stopped working after about 2 hours (on/off switch broke, remote connection cut out). What should we check or do?

0
User Pic

Manual.ly

7 months ago

Thanks for the feedback. If the on/off switch or any part fails within the first hours, please do a quick check first: install/replace the remote batteries correctly, make sure the battery cover is closed firmly, and keep the remote within clear range/line of sight. Also confirm the toy is fully powered before use and avoid rough handling during the first attempts (the controls can feel tricky at the start). If the toy still fails or the switch is broken, it likely arrived defective. Contact our support with your order number and a short video/photo, and we will arrange a replacement or warranty solution. Supervision is recommended for children, especially during setup and remote handling.

M: OA-GPT-5-NAN
M: OA-GPT-5-NAN

Frequently Asked Questions

A

It is best for indoor flying, beginner practice, and short controlled flights. The stable rotor setup and easy charging make it a good entry-level RC helicopter for learning basic handling skills.

Is this answer helpful?

A

The battery usually needs about 20 to 30 minutes to charge. After that, flight time is typically around 5 to 7 minutes, depending on how aggressively it is flown.

Is this answer helpful?

A

It is recommended for users aged 8 and up, but adult supervision is required. Younger children should not use it, and very small parts make it unsuitable for children under 36 months.

Is this answer helpful?

A

Only in very calm, dry conditions, but it is mainly intended for indoor use. Wind, obstacles, and open spaces can make control much harder and less safe.

Is this answer helpful?

A

The remote control uses 4 AA batteries at 1.5 V each. These are not included, so they need to be purchased separately before first use.

Is this answer helpful?

A

Trimming helps correct unwanted spinning and improves flight stability. A properly trimmed helicopter is easier to control and will hover more predictably.

Is this answer helpful?

A

Yes, damaged rotor blades can be replaced with original spare parts. The blades are marked differently for top and bottom, so they must be installed in the correct position.

Is this answer helpful?

M: OA-GPT-54-NAN

Advantages and Disadvantages

Advantages

  • Stable coaxial rotor design with electronic gyro support.
  • Easy charging through the remote control.
  • LED lighting and sturdy plastic body add appeal and durability.
  • Simple trim controls help beginners keep the helicopter steady.
VS

Disadvantages

  • Short flight time, so sessions are brief.
  • Requires 4 AA batteries for the remote, and they are not included.
  • Not suited for windy outdoor use.
  • Adult supervision is needed, especially for younger pilots.
M: OA-GPT-54-NAN

Product Specification

Type

Helicopter

Frequency

Infrared

Propulsion

Electric motor

Range

32.81 ft

Operating time

5 min

M: OA-GPT-54-NAN

Product Description

Revell Roxter: A Compact Indoor Helicopter with Big Personality

The Revell Roxter is the kind of micro helicopter that makes flying feel approachable from the very first takeoff. Built around a coaxial rotor system with an electronic gyro, it is designed for stable handling, smooth hovering, and easy correction during flight. For beginners, that means less frustration and more time enjoying the experience. For casual flyers, it offers a lightweight, responsive model that feels lively without being overly complicated.

A standout detail is the integrated rechargeable LiPo battery. Instead of needing a separate charger, the helicopter charges directly through the remote control, which keeps the setup simple and convenient. After a short charge, the Roxter is ready for a few minutes of flight, making it ideal for quick practice sessions, indoor fun, or a short break between tasks. The LED lighting and sturdy plastic body also give it a polished look that adds to the fun.

The Revell Roxter Manual focuses heavily on safe use and controlled flying, and that emphasis makes sense. This model is best suited for indoor spaces with no wind, plenty of room, and a clear flight path. The controls are straightforward: throttle for altitude, directional input for turning, and trim buttons for fine-tuning rotation. Once trimmed correctly, the helicopter becomes much easier to hold steady, which is especially helpful for new pilots learning to manage lift and direction at the same time.

Another strength of the Roxter is how beginner-friendly its maintenance is. If rotor blades are damaged, they can be replaced with original parts, and the instructions clearly explain how to handle that process. The overall design encourages careful learning, responsible use, and a realistic understanding of flight basics rather than gimmicks. It is a small aircraft, but it teaches the core rhythm of RC flying in a surprisingly practical way.

In short, the Revell Roxter is a compact helicopter built for indoor enjoyment, guided practice, and safe handling. It is not made for speed or long endurance, but for controlled flights that reward patience and precision.

Notes

  • Best used in a windless indoor area
  • Adult supervision is required for younger users
  • Let the battery cool before recharging
  • Replace damaged rotor blades with original parts only
M: OA-GPT-54-NAN

© Copyright 2026 Manual.ly