Manual.ly Logo

Yedoo Four Manual

0.0 · 0 Ratings

PDF manual · 116 Pages

English

M: OA-GPT-5-NAN
page

/ 116

Loading...
3cce278b2191d3e1fef68b7a6c58b886444a page 11
17
Safety recommendations
The scooter in its basic configuration is designed for riding in daylight in
areas designated for sport and recreation, ideally on a smooth, dry surface.
For riding on roads and in the dark you must equip the scooter with
additional safety devices (lights, reflectors etc.) in compliance with
applicable regulations in your country. Observe tra ic rules, principles
of safe riding and wear personal protective equipment (helmet, bike
gloves, knee and elbow pads, boots, etc.).
Before each ride check your brakes and the overall technical condition
of the scooter. Inflate the tyres to the recommended maximum
pressure (see the side of the tyre). Do not exceed its capacity. The
scooter is designed only for one rider. Do not overload the scooter.
Thescooter isnot intended for jumps or acrobatic riding.
All components designed to decrease the speed (brake pads, rims,
tyres, etc.) get hot while in use. Do not touch any of the parts until they
have cooled down!
Riding instructions
When riding, always grip the handlebar with both hands. While
pushing with one foot, place the other foot on the footboard
of the scooter. Regularly exchange feet. In order to brake, press
the brake levers on the handlebars. Usually you would use the
right lever which controls the rear brake. The front brake should
only be used to supplement the stopping power of the rear
brake. Never squeeze the front brake without also squeezing
the rear brake with equal or greater force.
Warning
: sudden braking
may cause a fall.
Maintenance
Proper maintenance will improve safety and extend the life of your
scooter. Therefore, tighten the screw connections, check the condition
of the quick release mechanisms, check the tyre pressures and
lubricate moving parts (bearings in the wheels and handlebars, brake
lever pins, brake mechanism pivot points, brake cables, etc.) regularly.
Make sure that the applied lubricant does not get on the rims and brake
pads. Grease reduces their e ect! If that happens, degrease soiled
areas with, for example, technical gasoline. Check the tyre tread depth
regularly and replace the tyres with new ones with the same parameters
if necessary. If the scooter is not ready to be used, clearly mark it as
such.
Check the condition of self-locking nuts regularly (if they become loose
spontaneously, replace them with new ones).
Check the wheel spokes regularly. Uneven tension of wires in the
spokes may cause their rupture or loss of wheel centering. It is
important to additionally adjust the new scooter after running
in, when the parts have settled against one another (the period is
individual and should not exceed 150 km). Neglect may lead to
destruction of loosened parts.
Keep the scooter clean, if dirty, wipe with a wet cloth. Store it indoors
in a dry shaded place, do not expose to increased humidity or extreme
temperatures in the long term. In case of long-term storage, for example
over winter, keep tyres su iciently inflated or hang the scooter up, so that
they would not be burdened.
The product complies with the relevant EU standards (EN14619) and it
also received certificates of quality and safety by a leading Czech testing
institute (Strojírenský zkušební ústav,s.p.).
The manufacturer and importer in the EU is INTREA – PIKO, s.r.o.,
Sasanková 2657/2, 106 00 Prague 10, Czech Republic, www.yedoo.eu.
Exercise of rights arising
from defective performance
General provisions
The content, scope and duration of the rights of the buyer from defective
performance is governed by the applicable legal regulations of the
country, in which the goods have been purchased. The rights of the buyer
in the sense of these legal regulations are not a ected in any way by this
document or the information stated in it.
Period for exercising of rights arising from defective performance
The purchaser can apply the right from defects in newly bought Yedoo
scooter (hereinafter goods) within a period of 36 months from the day
of receipt. If the buyer defines the defect of the goods legitimately,
the period for exercising rights arising from defective performance is
suspended for the time during which the buyer cannot use the goods.
Specifications of application of rights arising from the defective
performance
Rights arising from the defective performance are applied to the dealer
where the goods were purchased (see details below). We recommend to
submit this document, proof of purchase and a complete scooter free
from any impurities when applying the rights from defects.
The seller will issue a written confirmation of the exercise of rights arising
from defective performance or a confirmation ofrepair.
Specification of rights of defective performance
When assembling the scooter the instructions given in the installation
manual must be followed. The scooter must be used exclusively for
the purpose for which it was made. The scooter must be stored and
maintained according to the provided manufacturer’s instructions. The
manufacturer’s liability does not apply to defects caused exclusively by
improper installation or use of scooters in conflict with the user manual.
Model of the scooter:
Serial number of the frame:
Date of sale:
Vendor:
Stamp and signature:
EN

Chat with your Yedoo Four manual using AI

Get instant AI answers from your Yedoo Four manual

Ask anything about the Yedoo Four. Answers come from this manual, with the pages they are based on.

Four Maintenance Schedule

Before each ride
Check brakes and technical condition

Verify brake function and overall scooter condition before every ride.

Show in the manual (page 17)
Regularly
Tighten screw connections

Periodically tighten all screw connections to prevent loosening.

Show in the manual (page 17)
Regularly
Check quick release mechanisms

Inspect the condition of quick release mechanisms regularly.

Show in the manual (page 17)
Regularly
Lubricate moving parts

Lubricate wheel bearings, handlebar bearings, brake lever pins, pivot points, and cables. Avoid getting lubricant on rims or brake pads.

Show in the manual (page 17)
Regularly
Check tyre pressure

Monitor tyre pressure and inflate to the recommended maximum value indicated on the tyre sidewall.

Show in the manual (page 17)
Regularly
Check tyre tread depth

Inspect tread depth regularly and replace tyres with new ones having the same parameters if necessary.

Show in the manual (page 17)
Regularly
Check self-locking nuts

Inspect self-locking nuts and replace them if they loosen spontaneously during riding.

Show in the manual (page 17)
Regularly
Check wheel spokes

Inspect wheel spokes for uneven tension which may cause rupture or loss of wheel centering.

Show in the manual (page 17)
After 150 km run-in
Adjust new scooter after run-in

Perform an additional adjustment after the initial run-in period when parts settle, not exceeding 150 km.

Show in the manual (page 17)
As needed
Clean scooter

Wipe off dirt with a wet cloth to keep the scooter clean.

Show in the manual (page 17)
M: QW-35-FL

Ask a Question

0/1000

Do you recommend Four?

Yes No

Frequently Asked Questions

A

The Yedoo Four supports a maximum load of up to 150 kg (330 lb) for the Four model; other Yedoo models may have lower limits (e.g., 120 kg for some city-sized variants). Always follow the label and manual for the specific model.

Is this answer helpful?

A

The scooter requires assembly following the manual; the kickstand is not included as standard and must be purchased separately. The recommended stand capacity is about 15 kg and must be mounted centered in the prepared front frame hole.

Is this answer helpful?

A

For V-brakes, ensure 1–2 mm clearance from rim at rest, align pads to the rim sidewall and adjust cable tension and spring symmetry. For disc brakes, mount rotors with correct rotation arrow, ensure pads run parallel to the disc and set minimal safe pad-to-disc gap using the tension roller or anchor bolt.

Is this answer helpful?

A

Regular checks include tightening fasteners, inspecting quick releases, checking tire pressure and tread, lubricating bearings and pivots (avoiding rims and pads), inspecting spokes and self-locking nuts, and degreasing contaminated braking surfaces. Recheck adjustments after the initial running-in period (up to 150 km).

Is this answer helpful?

A

Yes, but for road or night riding you must fit appropriate lights and reflectors per local regulations. Observe traffic rules and wear protective equipment; the scooter’s basic configuration is intended for daytime sport and recreation on smooth surfaces.

Is this answer helpful?

A

Loosen the brake pad adjustment screws and reposition the pads so they run parallel to the rotor across their full surface, then retighten. Use the disc adjustment roller or the anchor bolt to fine-tune cable tension if needed.

Is this answer helpful?

A

Yedoo provides rights for defects subject to applicable national law; typically purchasers can claim defects within 36 months from receipt. Warranty claims should be handled through the dealer with proof of purchase and a cleaned, complete scooter per the manual’s assembly and use conditions.

Is this answer helpful?

M: OA-GPT-5-NAN

Advantages and Disadvantages

Advantages

  • Robust steel frame and high maximum load (up to 150 kg / 330 lb) for durability and heavy riders.
  • Configurable braking options (V-brake or disc) with clear adjustment procedures for reliable stopping.
  • Two-position rear fork enables deck-height tuning for comfort or off-road clearance.
  • Quick-release wheels and straightforward assembly make wheel removal and maintenance fast.
  • Detailed maintenance and safety guidance helps extend service life and ensures correct setup.
VS

Disadvantages

  • Stand not included and is limited to about 15 kg capacity; needs optional purchase.
  • Requires periodic adjustment after break-in (up to 150 km) which may be inconvenient for some users.
  • Care needed to avoid contaminating rims and brake pads with lubricant; contamination reduces braking.
  • Not intended for jumps, acrobatics, or overloaded use — limits extreme-sport usage.
  • Some models have mixed wheel sizes that may complicate finding replacement tires or parts.
M: OA-GPT-5-NAN

Product Specification

Type

Scooter

Material

Steel, Aluminum

Dimensions

57.09x25.20x36.22-39.37in

Wheels

20in (front), 16in (rear)

Max. user weight

330.69lb

Tire type

Air

Suspension

None

Recommended age

12 years and up

Weight

23.14lb

Special features

Kickstand

M: OA-GPT-54-NAN

Product Description

Yedoo Four Scooter — Yedoo Four Scooter Manual

The Yedoo Four is a sturdy, commuter-oriented kick scooter designed for reliable everyday use. Built with a reinforced steel frame and available with mixed wheel sizes (typically 20" front / 16" rear), it supports up to 150 kg (330 lb) depending on model. The Four balances stability and agility for urban commuting, fitness rides, and longer recreational trips.

Assembly follows clear step-by-step guidance: install wheels with quick-release skewers ensuring spring orientation toward the hub; fit disc rotors where applicable (observe rotor rotation arrows and torx screw sequence); mount the stem and handlebars, staying below the marked maximum height; and route and tension brake cables for correct pad-to-rim or pad-to-disc clearance. Torque and adjustment ranges are specified for stem and brake fasteners to ensure safe clamping without overtightening.

Braking is addressed for both V-brake and disc configurations. V-brake setup emphasizes symmetrical pad spacing (1–2 mm clearance at rest), correct pad alignment to the rim sidewall, and brake lever angle set so fingers extend the rider's arm in a natural riding posture. Disc brakes require rotor alignment to wheel rotation, minimal pad-to-disc gap, and fine adjustment via the tension roller or anchor bolt.

The scooter includes a two-position rear fork to alter deck height: the upper position lowers the deck for easier, less strenuous riding on smooth surfaces; the lower position is for rougher terrain. Optional accessories such as a side stand (max ~15 kg load) can be fitted at a front frame mounting point; the stand is not included and should be installed centered in the bracket.

Maintenance guidance stresses regular checks and lubrication of bearings, cables, quick-release mechanisms, spokes, and threaded fasteners. Avoid contaminating rims and brake pads with grease; degrease with suitable solvent if contamination occurs. Inspect tire tread and pressure, adjust spokes for even tension, and recheck the scooter after a running-in period (recommended within the first 150 km) to retorque and fine-tune components.

Safety recommendations recommend daytime use on smooth surfaces in basic configuration; for road use or night riding install lights and reflectors per local regulations. Always wear protective gear (helmet, gloves, pads) and observe traffic rules. The manufacturer warns against jumps, acrobatics, and overloading. The Yedoo Four complies with relevant EU standards (EN 14619) and carries manufacturer warranty and defect-rights provisions (36 months subject to local law and correct use/assembly).

Notes:

  • Follow torque specifications and do not exceed recommended tightening moments.
  • Set brake lever angles to a natural finger extension position while standing on the deck.
  • Recheck and retighten fasteners and spokes after the initial break-in period (up to 150 km).
  • Keep the scooter clean and store indoors in a dry, shaded place to preserve components.
M: OA-GPT-5-NAN

© Copyright 2026 Manual.ly