Manual.ly Logo

SXT 100 Manual

5.0 · 1 Ratings

PDF manual · 18 Pages

English

M: qwen/qwen3.5-flash-20260224
page

/ 18

Loading...
11faa24bd2cd2155815ccfdd0e8a6845375e page 8
A N L E I T U N G sxT-scooTErs
6
ACHTUNG: Wenn sie
an der Batterie ein Leck
feststellen vermeiden Sie
Hautkontakt und legen sie
die defekte Batterie in einen
Kunststoffbeutel. Halten Sie
sich an die Entsorgungs-
hinweise wie auf der linken
Seite angegeben. Wenn
Batterieüssigkeit mit der
Haut oder Augen in Kontakt
kommt spülen sie diese
Stellen 15 Minuten lang un-
ter iessendem Wasser aus
und konsultieren umgehend
einen Arzt.
ACHTUNG: Batterie-
pole, Zellen und sonstige
Bauteile enthalten Blei und
bleihaltige Stoffe. Waschen
sie nach jedem Umgang
mit Batterien ihre Hände
sorgfältig.
REPARATUR / WARTUNG
BATTERIEPFLEGE UND ENTSORGUNG
Batterie nicht bei Temperaturen über 23° C oder unter -23° C lagern.
ENTHÄLT VERSIEGELTE WARTUNGSFREIE BLEI GEL AKKUS.
BATTERIEN MÜSSEN RECYCELT WERDEN.
Entsorgung: In Ihrem Produkt sind Blei/Gel Akkus verbaut - diese müssen recycelt oder
umweltfreundlich entsorgt werden.Werfen sie die Blei/Gel Akkus auf keinen Fall ins Feuer
- die Batterie könnte explodieren oder leck schlagen.
Entsorgen sie die Blei/Gel Akkus auf keinen Fall über Ihren normalen Hausmüll. Diese Art
der Entsorgung ist in den meisten Ländern gesetzlich verboten und wird streng bestraft.
Geben sie aufgebrauchte, erschöpfte sowie defekte Altbatterien bei einer öffentlichen
Recyclingstelle oder einem Verkäufer von Batterien zum Recycling zurück.
LADEGERÄT
Das Ladegerät welches sie zusammen mit dem Roller geliefert bekommen sollte regel-
mäßig auf Beschädigungen am Netzstecker, Kabel und Ladestecker überprüft werden.
Im Falle einer solchen Beschädigung sollte das Ladegerät solange nicht mehr verwendet
werden bis dieses repariert oder ausgetauscht wurde. Verwenden Sie ausschliesslich das
mitgelieferte und empfohlene Ladegerät(e).
RÄDER
Die Räder und das Antriebssystem unterliegen normalem Verschleiss. Es obliegt der
Verantwortung des Besitzers die Räder sowie das Antriebssystem regelmäßig auf
Verschleiss zu überprüfen um eine sichere Benutzung zu gewährleisten und ggs Teile zu
erneuern / ersetzen.
AUSTAUSCH- / ERSATZTEILE
Die am meisten benötigten Austausch- und Ersatzteile nden Sie in unserem Produkts-
ortiment.
FEHLERDIAGNOSE
Problem
Roller läuft nicht
Roller bleibt während der
Fahrt plötzlich stehen
mögliche Ursache
nicht ausreichend geladene
Batterie
Sicherung ist rausgefallen
Lösung
Laden sie die Batterie. Eine neue Batterie sollte für mindestens 15
Stunden gekaden werden bevor diese das erste Mal verwendet
wird und ca. 12 Stunden nach jedem Entladezyklus.
Prüfen sie alle Steckverbindungen. Vergewissern Sie sich dass das
Ladkabel richtig am Roller angeschlossen ist und der Netzstecker
fest in der Steckdose steckt.
Alle Kabel und Stecker überprüfen and sicherstellen dass diese
fest verbunden sind.
Die Sicherung (neben dem AN/AUS Schalter) unterbricht automa-
tisch die Stromversorgung wenn es zu einem Kurzschluss kommt
oder der Motor überlastet ist.

Chat with your SXT 100 manual using AI

Get instant AI answers from your SXT 100 manual

Ask anything about the SXT 100. Answers come from this manual, with the pages they are based on.

100 Maintenance Schedule

Remind me when maintenance is due
Monthly
Charge the battery

Recharge the battery at least once a month if the scooter is not in regular use to prevent damage.

Regularly
Inspect brakes

Check brakes for proper function and ensure they do not rub or drag.

Regularly
Inspect frame and fork

Check for cracks or broken connections on the frame, fork, and handlebars regularly.

Periodically
Inspect wheels

Periodically inspect wheels for excess wear and replace as required.

Regularly
Check charger

Regularly examine the charger cord, plug, and enclosure for damage before use.

Regularly
Lubricate chain

Apply lubricant such as 3-in-1 or Tri-Flow to the chain if it appears dry.

Free maintenance reminders

Timed to your purchase date. Always free, unsubscribe anytime.

By submitting you agree to the privacy policy. Unsubscribe with one click in any email.
M: QW-35-FL

Ask a Question

0/1000

Do you recommend 100?

Yes No
0
User Pic

Julia Weber

6 months ago

What is the recommended charging schedule for the battery when the scooter is not in use?

0
User Pic

Manual.ly

6 months ago

The manufacturer recommends charging the battery once a month when the scooter is stored for an extended period to maintain optimal performance. This prevents deep discharge and ensures the battery remains healthy over time. If you use it regularly, charge as needed after each ride.

M: qwen/qwen3.5-flash-20260224
M: qwen/qwen3.5-flash-20260224

Frequently Asked Questions

A

You should charge the battery for fifteen hours before using it for the first time. Subsequent charges typically take up to twelve hours to ensure the battery remains healthy.

Is this answer helpful?

A

The maximum weight limit for the rider is strictly fifty kilograms. Exceeding this weight can cause motor overheating or mechanical failure.

Is this answer helpful?

A

Yes, you must wear a certified helmet with a chin strap, knee and elbow pads, and lace-up shoes with rubber soles at all times.

Is this answer helpful?

A

No, you should not ride at night or when visibility is poor. The manual warns that riding at night is dangerous due to low visibility.

Is this answer helpful?

A

Charge the battery at least once a month if not in use. Avoid charging it for excessive times and keep it within the recommended temperature range.

Is this answer helpful?

A

Assembly takes approximately twenty minutes. The scooter is 95% preassembled, so you only need to attach the handlebar and secure the fold mechanism.

Is this answer helpful?

A

Check the circuit breaker located near the switch. If it tripped, reset it after the motor cools down. Also ensure the battery is charged and cables are connected.

Is this answer helpful?

M: qwen/qwen3.5-flash-20260224

Advantages and Disadvantages

Advantages

  • Soft start function prevents sudden acceleration and falls during operation.
  • Folding design allows for compact storage in small apartments or vehicles easily.
  • Safety cut-off switch stops motor immediately when brakes are applied effectively.
  • Preassembled 95% saves significant time during initial setup process.
  • Built-in overcharge protection safeguards the battery from damage during use.
VS

Disadvantages

  • Short battery runtime of approximately forty minutes limits travel distance.
  • Long charging time of twelve hours is required for effective battery life.
  • Strict weight limit of fifty kilograms restricts rider eligibility significantly.
  • Night riding is prohibited due to visibility issues on the road.
  • Battery contains lead acid requiring special disposal instead of trash.
M: qwen/qwen3.5-flash-20260224

Product Specification

Type

Electric Scooter

Colors

Blue

Motor Power

100W

Range

up to 4.97 miles

Max Speed

6.21 mph

Rear Brake

Foot brake

Dimensions

37.01x7.87x37.80 in

Handle Height

37.01 in

Max User Weight

110.23 lbs

Tire Type

Solid

Tire Diameter

8 in

Suspension

None

Weight

26.46 lbs

Special Features

Foldable, Front fender, Kids scooter

M: qwen/qwen3.5-flash-20260224

Product Description

Introduction to Urban Commuting

Urban commuting has evolved significantly with electric devices like the SXT 100 E-Scooter blue. This compact vehicle is designed for efficiency in city environments. However, operating this machine requires strict safety knowledge. Reading the SXT 100 E-Scooter blue Manual is the first step. This documentation contains critical safety warnings to prevent injury. It outlines how to assemble the unit within twenty minutes.

Assembly and Setup

The scooter arrives ninety-five percent preassembled. You need to attach the handlebar and fold down the kickstand. Once set up, the folding mechanism allows easy storage indoors. The blue finish looks stylish and stands out visually. Performance varies by usage conditions and rider behavior. The maximum rider weight is strictly fifty kilograms. Exceeding this limit causes motor overheating or frame failure. The battery provides approximately forty minutes of runtime on a full charge. Initial charging takes twelve hours to ensure longevity for the battery.

Safety and Performance

A new battery needs fifteen hours before the first operation. Overcharging is protected by built-in safeguards on the charger unit. If lights do not work, check the power outlet connections. Plug the charger into the port. Safety gear is paramount for all riders regardless of experience level. The soft start function activates only after kicking the scooter forward. This ensures gradual acceleration to prevent sudden falls. You must wear protective gear at all times.

Maintenance and Usage

A certified helmet is legally required in many regions. Knee and elbow pads reduce injury severity during falls. Gloves improve grip and protect hands. Use them to protect skin. Footwear must include laced athletic shoes with rubber soles. Never wear sandals while driving this vehicle due to lack of protection. Maintenance involves checks on tires and chain tension regularly. Inspect tires for pressure loss that happens during shipping. Tighten the chain tension regularly to prevent slipping.

Clean the unit without liquids near electrical components to avoid shorts. The battery contains lead and must be recycled responsibly. If problems occur, check the circuit breaker for trips. Reset it if it trips due to overload conditions. Find a local recycling center. Riding conditions matter greatly for accident prevention always. Avoid wet or icy surfaces to prevent damage to electrical parts. Riding at night is dangerous due to low visibility. Always check local traffic laws.

M: qwen/qwen3.5-flash-20260224

© Copyright 2026 Manual.ly