Manual.ly Logo

Seagate Exos 2X18 Manual

0.0 · 0 Ratings

PDF manual · 55 Pages

English

M: QW-35-FL
page

/ 55

Loading...
869b015a79e74ec4edcc0330afa2b0bb96f4 page 13
Seagate Exos 2X18 SAS Product Manual, Rev. A 18
www.seagate.com Reliability specifications
Predictive failures
S.M.A.R.T. signals predictive failures when the drive is performing unacceptably for a period of time. The firmware keeps a running count of the
number of times the error rate for each attribute is unacceptable. To accomplish this, a counter is incremented each time the error rate is
unacceptable and decremented (not to exceed zero) whenever the error rate is acceptable. If the counter continually increments such that it
reaches the predictive threshold, a predictive failure is signaled. This counter is referred to as the Failure History Counter. There is a separate Failure
History Counter for each attribute.
5.2.4 Thermal monitor
Exos 2X18 drives implement a temperature warning system which:
1. Signals the host if the temperature exceeds a value which would threaten the drive.
2. Saves a S.M.A.R.T. data frame on the drive which exceeds the threatening temperature value.
A temperature sensor monitors the drive temperature and issues a warning over the interface when the temperature exceeds a set threshold. The
temperature is measured at power-up and then at ten-minute intervals after power-up.
The thermal monitor system generates a warning code of 01-0B01 when the temperature exceeds the specified limit in compliance with the SCSI
standard.
This feature is controlled by the Enable Warning (EWasc) bit, and the reporting mechanism is controlled by the Method of Reporting Informational
Exceptions field (MRIE) on the Informational Exceptions Control (IEC) mode page (1Ch).
5.2.5 Drive Self Test (DST)
Drive Self Test (DST) is a technology designed to recognize drive fault conditions that qualify the drive as a failed unit. DST validates the
functionality of the drive at a system level.
There are two test coverage options implemented in DST:
1. Extended test
2. Short test
The most thorough option is the extended test that performs various tests on the drive and scans every logical block address (LBA) of the drive.
The short test is time-restricted and limited in length—it does not scan the entire media surface, but does some fundamental tests and scans
portions of the media.
If DST encounters an error during either of these tests, it reports a fault condition. If the drive fails the test, remove it from service and return it to
Seagate for service.
5.2.5.1 DST failure definition
The drive will present a “diagnostic failed” condition through the self-tests results value of the diagnostic log page if a functional failure is
encountered during DST. The channel and servo parameters are not modified to test the drive more stringently, and the number of retries are not
reduced. All retries and recovery processes are enabled during the test. If data is recoverable, no failure condition will be reported regardless of
the number of retries required to recover the data.
The following conditions are considered DST failure conditions:
• Seek error after retries are exhausted
• Track-follow error after retries are exhausted
• Read error after retries are exhausted
• Write error after retries are exhausted
Recovered errors will not be reported as diagnostic failures.

Chat with your Seagate Exos 2X18 manual using AI

Get instant AI answers from your Seagate Exos 2X18 manual

Ask anything about the Seagate Exos 2X18. Answers come from this manual, with the pages they are based on.

Exos 2X18 Maintenance Schedule

Not required
No preventive maintenance required

The manual explicitly states that no preventive maintenance or adjustments are required for this drive.

Show in the manual (page 10)
Hourly (automatic)
Monitor S.M.A.R.T. attributes

S.M.A.R.T. automatically measures and saves attribute data once every hour during idle periods to detect imminent failure conditions.

Show in the manual (page 18)
Every 10 minutes
Check thermal monitor status

The drive's temperature sensor monitors the drive temperature at power-up and then at ten-minute intervals to issue warnings if limits are exceeded.

Show in the manual (page 19)
M: qwen/qwen3.8-flash

Ask a Question

0/1000

Do you recommend Exos 2X18?

Yes No

Frequently Asked Questions

A

The drive supports up to 18 terabytes with 16 terabyte options also available for flexibility.

Is this answer helpful?

A

Yes, select models feature Self Encrypting Drive technology for enhanced security at rest.

Is this answer helpful?

A

It supports Serial Attached SCSI up to 12 gigabits per second for high performance.

Is this answer helpful?

A

The product includes a five-year limited warranty covering standard enterprise operations.

Is this answer helpful?

A

The spindle operates at 7200 revolutions per minute for balanced performance and latency.

Is this answer helpful?

A

Yes, the drive supports hot plugging to minimize downtime during maintenance or replacement.

Is this answer helpful?

M: QW-35-FL

Advantages and Disadvantages

Advantages

  • Dual actuator technology boosts performance significantly over single actuator drives
  • High capacity options reaching up to 18 terabytes for massive data storage
  • Five-year limited warranty provides long-term reliability and support
  • SAS interface supports high-speed transfer rates up to 12 gigabits per second
  • Hot plug support allows system maintenance with minimal downtime
VS

Disadvantages

  • Requires adequate cooling to maintain optimal operating temperatures
  • Heavier power draw during peak operations compared to lower capacity drives
  • Enterprise pricing can be high for smaller setup budgets
  • Physical 3.5 inch size requires specific mounting space in servers
  • Heat generation demands efficient airflow management in confined racks
M: QW-35-FL

Product Specification

Form Factor

3.5" (Width), 1.03" (Thickness/Height)

Interface

SAS 12Gb/s

Rotational Speed

7200 RPM

Cache

256MB

Power Consumption

13.5W (Operation), 8W (Idle)

Recording Method

Conventional Magnetic Recording (CMR)

Sectors

4KB with Emulation (512e)/4KB Native (4Kn)

Reliability Forecast

2,500,000 Hours (MTBF)

Warranty

60 Months

Warning/Note/Trivia

Note: Non-branded OEM/System Builder drives may be circulating. Reduced warranty service possible. Check manufacturer warranty via serial number. Important: When used within a RAID array, do not combine drives with different recording methods (CMR, SMR). When using SMR drives in a RAID array, ensure the RAID Controller (or NAS System) is compatible with SMR drives to avoid mistaking the partially blocked writing behavior of SMR as a "Hardware Defect".

M: QW-35-FL

Product Description

Seagate Exos X - 2X18 HDD SAS Enterprise Storage

The Seagate Exos X - 2X18 HDD SAS stands as a pinnacle of enterprise storage innovation designed for high-density data centers. Engineers seeking maximum performance will rely on the advanced MACH 2 technology incorporated within every unit. This dual actuator architecture effectively doubles transfer speeds compared to traditional single actuator drives. It allows the system to handle massive workloads with ease while maintaining stability under heavy pressure. With capacities reaching up to 18 terabytes, this solution offers immense space for big data analytics and virtualization tasks. The internal configuration supports parallel data access, ensuring efficient resource utilization across complex server architectures. Specific models are available in 16 and 18 terabyte capacities to fit diverse storage needs.

Reliability is paramount in critical infrastructure environments. This drive comes equipped with a five-year limited warranty and boasts an impressive Mean Time Between Failures rating. Users often integrate this hardware into network servers and mainframes where data integrity cannot be compromised. The SAS interface ensures compatibility with existing storage networks while delivering high-speed data transfer rates up to 12 gigabits per second. This flexibility allows organizations to scale their storage arrays without replacing the entire infrastructure immediately. Spindle speeds hover around 7200 revolutions per minute, ensuring low latency for random access operations. A substantial 256 megabyte buffer further enhances transaction throughput during peak demand periods.

Security features are also integrated for sensitive operations. Select models include Self Encrypting Drive capabilities to protect data at rest. Encryption keys remain secure within the hardware itself, preventing unauthorized access even if the physical media is stolen. Power management tools help optimize energy consumption without sacrificing critical throughput during peak usage times. Cooling requirements must be considered as the hardware generates heat during intensive read and write cycles. Proper airflow ensures longevity and consistent performance ratings over the long term. The drive supports hot plugging which minimizes downtime during critical system updates.

For organizations needing robust storage solutions, the Seagate Exos X - 2X18 HDD SAS delivers exceptional value. It balances raw capacity with speed and security in a single 3.5 inch form factor. Whether for supercomputers or engineering workstations, this drive meets rigorous industry standards. The dual port options and hot plug capabilities further simplify maintenance and upgrades. IT professionals prefer its consistency across large deployments where uniformity reduces operational complexity significantly. Advanced monitoring tools track temperature and health metrics proactively. This proactive approach helps prevent data loss before catastrophic failure occurs in the field. It is built to withstand demanding environmental conditions including temp fluctuations.

M: QW-35-FL

© Copyright 2026 Manual.ly