Manual.ly Logo

Oase biOrb Classic 105 MCR RGB LED Manual

0.0 · 0 Ratings

PDF manual · 2 Pages

English

M: OA-GPT-54-NAN
page

/ 2

Loading...
8f578e09f810de750599dabb307aee70119a page 2
ENG
LISH
UK 016 03 710339
US 877-928-7333
FR 0811 850 11 3
DE 0800-181-9091
www.reef-one.com
Caring for your aquarium
1. Every 2 weeks a 30% water change is desirable
to reduce pollution in the water. Use a sachet of
water treatment in 4 litres/1 US Gallon of tap water.
A Cleaner Pump (not supplied) is an easy way to
remove debris and siphon out the water. After
setting up never use tap water to clean the
ceramic media, this will kill biological filtration.
2. Every 6 weeks a new filter cartridge will be
required to maintain the water condition. The
c
artridge and instructions are in the Service Kit.
Green Water is caused by algae growth. Some
algae is natural in healthy aquariums. However, if
your aquarium water quickly turns green it may be
caused by too much light, overfeeding, too many
fish or high levels of nitrate and phosphate in the
tap water.
3. The Air Stone in the base of the aquarium will
eventually become blocked restricting the flow of
bubbles into the aquarium, the Air stone should be
replaced every 6 months.
The Air Pump will wear out over time and could
become noisy, reducing the flow of bubbles even
after changing the air stone. Replace immediately
after failure, to avoid problems.
4. Cleaning the aquarium requires care to prevent
scratching. Never use household detergents,
polishes or scouring pads. The outside of the bowl
can be wiped with a soft cloth or purchase a Plastic
Scratch Remover & Polish kit. The inside should be
cleaned with a Cleaning Pad.
J
Choosing and
introducing fish
Do not crowd with decor or over stock
with fish. When introducing fish, add
gradually at a rate of 2 every 28 days.
This will encourage a population of filter
bacteria in the ceramic media that will
keep the water clean. Adding fish too
quickly may cause the water to be
polluted and unsafe for fish. When
adding fish follow instructions from your
aquatic shop to ensure the fish are
gently acclimatised to their new home.
Feed each fish 4-6 of the pellets supplied
per day, do not overfeed.
CAUTION: Overfeeding will harm fish
and pollute water.
Intelligent Light
1. Turn the light on at the switch (fig 1). The
blue LED will flash until one of the 5 lighting
modes is selected (the mode will repeat at this
time every day, to change this simply repeat
these steps at a different time).
24hr Lighting Modes
1xFlash= 1 hr sunrise - 6 hrs daylight - 1 hr sunset.
2xFlash= 1 hr sunrise - 8 hrs daylight - 1 hr sunset.
3xFlash= 1 hr sunrise - 10 hrs daylight - 1 hr sunset.
4xFlash= 1 hr sunrise - 12 hrs daylight - 1 hr sunset.
5xFlash= Test or demonstration 60 second cycle.
During the sunrise and sunset the blue LED and
white LEDs will be lit together until one or the
other fades out. The selected mode will repeat
automatically every 24 hours except in the event
of a power cut or if the mode is changed.
If you have any problems while selecting a
mode, re-set by switching off the power (fig 1).
Standard Light
Cleaning the light is easy and is a good idea to
keep your aquarium looking at its best. Simply
wipe the lens with a Cleaning Pad. Your long
life LEDs typically last for over 50,000 hours and
should never need replacing.
2
3
4
1
2. To select a lighting mode. Press and hold the
mode button (fig 2) for the required number of
flashes. ie. mode 4 - press and hold for 4 flashes.
(see below).
Fig. 1
Fig. 2

Chat with your Oase biOrb Classic 105 MCR RGB LED manual using AI

Get instant AI answers from your Oase biOrb Classic 105 MCR RGB LED manual

Ask anything about the Oase biOrb Classic 105 MCR RGB LED. Answers come from this manual, with the pages they are based on.

biOrb Classic 105 MCR RGB LED Maintenance Schedule

Remind me when maintenance is due
Every 2 weeks
Perform water change

Change 30% of the water every 2 weeks using treated tap water. Use a Cleaner Pump to remove debris and siphon water.

Every 6 weeks
Replace filter cartridge

Install a new filter cartridge every 6 weeks to maintain water condition. Instructions are in the Service Kit.

Every 6 months
Replace air stone

Replace the air stone every 6 months as it will eventually become blocked and restrict bubble flow.

As needed
Replace air pump

Replace the air pump immediately if it becomes noisy or fails to provide adequate bubble flow.

As needed
Clean aquarium glass

Clean the inside with a Cleaning Pad and wipe the outside with a soft cloth. Do not use household detergents.

As needed
Clean light lens

Wipe the LED lens with a Cleaning Pad to keep the aquarium looking its best.

Free maintenance reminders

Timed to your purchase date. Always free, unsubscribe anytime.

By submitting you agree to the privacy policy. Unsubscribe with one click in any email.
M: QW-35-FL

Ask a Question

0/1000

Do you recommend biOrb Classic 105 MCR RGB LED?

Yes No

Frequently Asked Questions

A

Remove the plastic wrapper from the filter cartridge, then offer it to the base of the bubble tube. Locate the tabs and twist counterclockwise until fully seated. After that, insert the bubble tube and filter assembly into the biOrb and turn the bubble tube clockwise until it locks in place.

Is this answer helpful?

A

After filling the aquarium and adding Water Conditioner, run the pump for at least 24 hours. Only then add Biological Booster. The guide also recommends gradual fish introduction, such as adding fish at about two per 28 days, to support filter bacteria growth.

Is this answer helpful?

A

A 30% water change is desirable every two weeks. Use water treatment per the guide, mixing it for each amount of tap water. For cleaning, wipe the outside with a soft cloth and clean the inside using a cleaning pad. Do not use household detergents or polish products inside the aquarium.

Is this answer helpful?

A

No. The guide warns that after setting up, never use tap water to clean the ceramic media because it can kill biological filtration. If you need to handle media, keep it associated with aquarium water and follow the instructions in your service kit.

Is this answer helpful?

A

Green water is commonly caused by algae growth. The guide notes several possible triggers: too much light, overfeeding, too many fish, or high nitrate and phosphate levels in tap water. Adjust lighting duration, feeding amounts, fish stocking levels, and water source parameters where possible.

Is this answer helpful?

A

Switch the light on. The blue LED flashes until you select a mode. Choose by pressing and holding the mode button for the required number of flashes. Each mode defines a sunrise, daylight, and sunset distribution over 24 hours, and the selected mode repeats automatically each day.

Is this answer helpful?

A

The air stone can become blocked over time and should be replaced about every six months. The filter cartridge should be replaced about every six weeks to maintain proper water condition. If the pump becomes noisy or fails, replace it immediately to avoid reduced bubble flow.

Is this answer helpful?

M: OA-GPT-54-NAN

Advantages and Disadvantages

Advantages

  • Step-by-step setup for bubble tube, filter cartridge, and ceramic media
  • Stable start routine with conditioner and Biological Booster before adding fish
  • Multiple lighting modes with repeatable sunrise, daylight, and sunset timing
  • Maintenance schedule guidance for water changes and cartridge replacement
  • Long-life LEDs, typically lasting over 50,000 hours
VS

Disadvantages

  • Requires consistent upkeep: 30% water changes every 2 weeks
  • Filter cartridges must be replaced about every 6 weeks
  • Air stone replacement is needed roughly every 6 months
  • Cleaning ceramic media must avoid tap water to protect biological filtration
  • Safety rules are strict: do not move when full and keep the light unit dry
M: OA-GPT-54-NAN

Product Specification

Type

Aquarium

Suitability

Freshwater, Aquascaping

Tank shape

Sphere, Circular base

Capacity

27.74 gal

Dimensions

24.02x24.80x24.02in

Weight

23.15lb

Special features

Lighting (RGB LED), Air pump, Filter, Air stone, Substrate

M: GO-GEM-FL-25

Product Description

Oase biOrb Classic 105 MCR RGB LED Aquarium black

A clean, stylish home for healthy fish

The Oase biOrb Classic 105 MCR RGB LED Aquarium black brings an elegant globe look to any room, with a built-in filtration air system and intelligent lighting to help you create a stable environment for your fish. This Oase biOrb Classic 105 MCR RGB LED Aquarium black Manual-style guide walks through setup, daily care, and lighting options so you can enjoy your aquarium with confidence.

Setup made straightforward, step by step

Start by choosing a strong, level location and ensuring a power source is within reach. Before assembling, remove all contents from the box and check everything is present. The guide emphasizes safety: it is not a toy, adult supervision is recommended, and you should not move the aquarium when full.

Next, assemble the filter components by removing the plastic wrapper from the filter cartridge and twisting it into the bubble tube base. Then install the bubble tube and filter assembly into the biOrb, turning the bubble tube clockwise until it locks in place. Before use, wash the supplied ceramic media thoroughly and place it around the filter body. Use only the ceramic media provided and avoid aquarium gravel.

Position the air pump so it sits higher than the water level to help prevent leakage or pump damage if a valve fails. Connect the airline, connect the pump and light unit to the transformer sockets, plug the transformer into power, and run the pump 24 hours a day. When filling, add water up to about 3 inches (7.5 cm) above the top of the bubble tube, treat tap water with Water Conditioner, and run the aquarium for at least 24 hours before adding Biological Booster.

Care routines that support long-term stability

For maintenance, the guide recommends a 30% water change every two weeks, using water treatment for each batch. It also advises cleaning with care: never use household detergents, and never use tap water to clean the ceramic media, as this can harm biological filtration.

Every six weeks, replace the filter cartridge to maintain water quality. Green water is often linked to algae growth, which can be triggered by too much light, overfeeding, too many fish, or high nitrate and phosphate in tap water. The air stone may become blocked over time, so replace it about every six months, and replace the pump immediately if it fails or becomes noisy.

Intelligent Light modes with sunrise to sunset effects

The RGB-style lighting uses a mode selection process: the blue LED flashes until you choose a lighting mode. The guide provides 24-hour cycles that combine sunrise, daylight, and sunset, with different total daylight lengths depending on the number of flashes you select (1x through 4x). A 5x flash mode is a short test or demonstration cycle. If you ever have issues, reset by switching off the power.

Key results

  • Clear, organized assembly steps for the bubble tube, filter cartridge, and ceramic media
  • A stable start routine: conditioner, 24-hour running time, then Biological Booster and gradual fish introduction
  • Reliable maintenance guidance: 30% water changes every 2 weeks and cartridge replacement every 6 weeks
  • Lighting schedules that automatically repeat every 24 hours, with easy mode switching
  • Long-life LEDs designed to typically last beyond 50,000 hours

Notes

  • Do not immerse the light unit in water.
  • Avoid hot areas and direct sunlight.
  • Feed carefully: overfeeding can harm fish and pollute the water.
M: OA-GPT-54-NAN

© Copyright 2026 Manual.ly