Manual.ly Logo

LAS SD260 11619 Manual

0.0 · 0 Ratings

PDF manual · 68 Pages

English

M: QW-35-FL
page

/ 68

Loading...
3bbf41c86564343f2572a37adf85744a3974 page 16
22
Safety Instructions
WARNING!
WARNING!
Follow the tting instructions carefully. Failure to follow the
instructions can lead to personal injuries and material
damage.
If you are not sure about correct tting, ask your dealer or the
manufacturer for further information. Neither the manufacturer
nor dealer are liable for damages which are due to improper use or
tting.
Check the bike carrier and the load regularly: you are required to do
so and may be held liable in case of damage.
Personal injury or material damage due to
projecting parts.
Parts projecting beyond the edge of the vehicle or
bike carrier can cause personal injury or material
damage when driving.
Personal injury or material damage due to
overloading.
Exceeding the max. carrying capacity of the bike
carrier or the permissible bearing load of the trailer
coupling or the permissible overall weight can lead
to serious accidents.
WARNING!
WARNING!
NOTE
Personal injury or material damage due to
changed vehicle driving characteristics.
Driving with the bike carrier tted will aect the
driving characteristics of your vehicle.
Personal injury or material damage due to
loss of the bicycles.
Carrying bicycles without using the safety straps
can lead to accidents.
The legal regulations and provisions on the
transport of goods on the back of your vehicle apply
when driving with a mounted bicycle carried.
Adjust your speed to the new driving
characteristics.
4
Fit only such parts which do not project beyond
the edge of the vehicle or bike carrier.
4
Observe the information on the max. carrying
capacity, permissible bearing load and
permissible overall weight of your vehicle.
Never exceed these specications.
4
Before the start of every journey, check the
correct and rm attachment of the strap around
the bikes and the frame holder bracket of
the carrier (see Step 8 of chapter “Mounting
bicycles”).
4
Before the start of every journey, check that the
straps are not worn or damaged.
4
A damaged or worn strap must be replaced
with an undamaged one before driving.
Only strap which are approved by EAL GmbH
may be used for this.
4
Avoid sudden and jerky steering movements.
4
Remember that your vehicle is longer than
usual.
4
Never exceed a speed of 130 km/h.
4
Before the start of every journey, check the
correct and rm attachment of both straps
around the front wheel, and the strap around
the rear wheel of the bicycle.
4
Tighten the straps if necessary.
4
WARNING!
Personal injury or material damage due to an
incompletely tted bike carrier.
Driving with a extended or folded bike carrier can
lead to accidents.
The moving parts of bike carrier constitute a source
of danger if not properly tted.
Remove the bike carrier if it is not needed.
4
WARNING!
Personal injury or material damage due to
tarpaulins.
Tarpaulins increase the air resistance. They can
become loose and y about leading to serious
accidents.
Never use tarpaulins or covers.
4
WARNING!
Personal injury or material damage due to
loss of the bicycles.
After the attachment, the carrier rst settles
properly into the coupling after driving several
kilometres.
Check the attachment of the carrier for secure
attachment after driving several kilometres.
4
Redo the attachment if it is loose.
4
Never drive with a extended or folded bike
carrier.
4
Ensure that the bicycle carrier is always locked
with both locking pins.
4

Chat with your LAS SD260 11619 manual using AI

Get instant AI answers from your LAS SD260 11619 manual

Ask anything about the LAS SD260 11619. Answers come from this manual, with the pages they are based on.

SD260 11619 Maintenance Schedule

Before every journey
Check carrier for wear and strap damage

Inspect the bike carrier for wear before each trip. Check straps for damage or looseness; replace defective parts and worn straps immediately.

Show in the manual (page 31)
After several km
Re-check attachment to trailer coupling

The carrier settles into the coupling after driving several kilometres. Check that it is firmly attached and redo the fitting if loose.

Show in the manual (page 22)
Before every journey
Check lighting system operation

Verify correct operation of the lighting system and check the connection between the plug and coupling before starting every journey.

Show in the manual (page 26)
Regularly in coastal/winter use
Clean carrier to remove salt

In coastal areas or winter conditions, clean regularly with mild detergent and warm water to wash off salt and prolong service life.

Show in the manual (page 31)
Immediately if fouled
Rinse sliding mechanism

If the sliding mechanism is dirty, rinse it with water immediately to ensure smooth gliding. Always return carrier to transport position when not in use.

Show in the manual (page 31)
M: qwen/qwen3.8-flash

Ask a Question

0/1000

Do you recommend SD260 11619?

Yes No

Frequently Asked Questions

A

The LAS SD260 has a maximum payload capacity of 60 kg. It is designed to carry up to two bicycles simultaneously, provided the total weight does not exceed this limit.

Is this answer helpful?

A

No, you must never mount the LAS SD260 on an aluminum, light metal, or plastic tow hitch. It is strictly designed for steel St52 or gray cast iron GGG52 hitches to prevent breakage.

Is this answer helpful?

A

You can use the built-in sliding mechanism. Lift the release knobs to unlock the carrier, then slide it backward away from the vehicle before opening the trunk or tailgate.

Is this answer helpful?

A

The carrier comes with a 13-pin plug. While wiring diagrams exist for 7-pin systems, any conversion must be performed by a qualified specialist; DIY modifications are prohibited.

Is this answer helpful?

A

No, driving over difficult or uneven terrain can cause the carrier to break off. It should only be used on paved roads and gentle slopes.

Is this answer helpful?

A

A layer of paint on the tow ball reduces friction and grip. Removing it ensures the carrier locks securely onto the ball, preventing dangerous loosening during travel.

Is this answer helpful?

M: QW-35-FL

Advantages and Disadvantages

Advantages

  • Sliding mechanism provides easy trunk access without unloading bikes
  • Compact folding design saves storage space when not in use
  • Durable steel and aluminum construction supports up to 60 kg load
  • Integrated lighting system meets European safety standards
  • Lockable frame holders add security against theft
VS

Disadvantages

  • Not suitable for off-road terrain due to risk of damage
  • Requires strict adherence to tow hitch material specifications
  • Tarpaulins cannot be used due to wind resistance risks
  • Paint on tow balls must be removed for optimal grip
  • Manual adjustment needed if quick release becomes loose over time
M: QW-35-FL

Product Specification

Type

Bike rack

Mounting

Rear/Tow hitch

Load capacity for sports equipment

2 bicycles

Max load

132.28 lbs

Features

foldable, rear lights (13-pin)

Color

black

Dimensions

31.89x51.18x30.31 in (WxDxH)

Weight

45.20 lbs

M: QW-35-FL

Product Description

Experience Freedom with the LAS SD260 Manual Bike Carrier

The LAS SD260 is a robust and reliable bike carrier designed for seamless integration with your vehicle's tow hitch. This manual-operated system offers a practical solution for transporting up to two bicycles, making it an ideal choice for weekend getaways or family adventures. Constructed from durable steel and aluminum, the SD260 balances strength with a manageable weight of approximately 20.5 kg, ensuring it does not overly burden your vehicle's suspension.

Designed with safety as a top priority, the LAS SD260 features a secure locking mechanism that prevents theft and accidental detachment during transit. The carrier includes essential accessories such as keys, safety straps for front wheels, and frame holders in both long and short configurations to accommodate various bicycle types. Whether you are carrying mountain bikes or roadsters, the adjustable wheelbase support handles frames up to 130 cm apart and tires up to 3.25 inches wide.

One of the standout features of this model is its sliding mechanism. This allows you to easily push the carrier backward to access your trunk without removing the bikes or the entire rack. When not in use, the ingenious folding system enables you to collapse the unit for compact storage, saving valuable space in your garage. The integrated lighting system ensures compliance with road regulations, featuring a 13-pin connector for standard vehicle setups, though adapters are available for 7-pin systems via professional installation.

Proper usage requires adherence to specific coupling requirements, including a minimum tow ball diameter of 50 mm and a D-value of at least 7.6 kN. Always ensure the carrier is mounted on a steel or gray cast iron hitch, never on aluminum or plastic components. Regular maintenance, such as cleaning after coastal trips or winter driving, preserves the powder-coated finish against corrosion. By following the detailed guidelines provided in the user manual, you guarantee a safe and enjoyable journey every time.

M: QW-35-FL

© Copyright 2026 Manual.ly