Manual.ly Logo

Jung Pumpen U6 Manual

0.0 · 0 Ratings

PDF manual · 76 Pages

English

M: OA-GPT-5-NAN
page

/ 76

Loading...
d7006a1d9d228c9fe2dd79efdaf126a813bd page 7
7
DEUTSCH
Um das Fördern der Pumpe zu erreichen, muss
der Ablaufschlauch vor jedem Pumpvorgang
entleert werden und ein Mindestwasserstand
vorhanden sein, U5K: 60 mm und U6K: 90 mm.
VORSICHT!
Ein mobiler Betrieb ist aus sicherheitstech ni-
schen Gründen nur senkrecht und mit Siebfuß
zugelassen!
Wird ein Schlauch als Druckleitung verwandt, ist
darauf zu achten, dass dieser bei jedem Pump-
vorgang vor dem Eintauchen der Pumpe voll-
ständig entleert ist. Eventuell noch vorhandene
Flüssigkeitsreste würden das Entlüften des
Pumpengehäuses und damit das Fördern ver-
hindern. Aus dem gleichen Grund fördert auch
die vor dem Eintauchen bereits eingeschaltete
Pumpe nicht.
Die beiliegende Gummiklappe (nicht bei Flutbox
und U6) wird im montierten Winkel (U5) befestigt.
Achten Sie darauf, dass die Klappe in Fließ-
richtung öffnet.
Vergrößerung des freien Durchganges
Bei den Pumpen der Baureihen U5 und U6
kann der freie Durchgang von 10 auf 20 mm er-
höht werden. Dazu wird der Siebfuß mit einem
Schraubendreher abgehebelt und die bei-
liegenden Verlängerungen auf die angeformten
Pumpenfüße gesteckt. Der Siebfuß passt jetzt
nicht mehr unter die Pumpe.
HINWEIS! Bei einer defekten Pumpe kann ein
Teil der Ölkammerfüllung in das Fördermedium
entweichen.
WARTUNG
Wartung und Inspektion dieses Produktes sind
nach EN 12056-4 vorzunehmen.
WARNUNG!
Vor jeder Arbeit Pumpe und Steuerung vom Netz
trennen und sicherstellen, dass sie von anderen
Personen nicht wieder unter Spannung gesetzt
werden können.
WARNUNG!
Die Netzzuleitung auf mechanische und chemi-
sche Beschädigung prüfen. Beschädigte oder
geknickte Leitungen müssen durch den Herstel-
ler ersetzt werden.
HINWEIS! Fehlende Reinigung führt bei stark
eisen- oder kalkhaltigem Wasser auf Dauer zur
Zerstörung der Dichtung und damit des Pum-
penmotors. Deshalb muss die Pumpe regel-
mäßig gereinigt werden, je nach Härtegrad des
Wassers.
Reinigung
Der Siebfuß verhindert das Eindringen grober Ver-
unreinigungen in die Pumpe. Regelmäßiges Reini-
gen des Schwimmers und des Siebfußes sichert
die maximal mögliche Leistung und Funktion.
Reinigung des Laufrades U5 und U6
Zur Reinigung des Laufrades, bei Blockierung
oder Verstopfung, muss zuerst der Siebfuß
abgehebelt werden. Dann können die Schrauben
an der Unterseite der Pumpe herausgeschraubt
und der Deckel abgezogen werden. Jetzt kann
das Laufrad gereinigt werden.
VORSICHT!
Abgenutzte Laufräder können scharfe Kanten
haben.
Bei abnehmender Förderleistung ist das Laufrad
auf Verschleiss zu prüfen und, falls erforderlich,
durch den Hersteller zu erneuern.
Anzugsdrehmomente M
A
für Schraubenwerk-
stoff A2 für M 5 M
A
= 5 Nm ,
für Amtec 3,5 M
A
= 1 Nm, für Amtec 5,0 M
A
= 2 Nm

Chat with your Jung Pumpen U6 manual using AI

Get instant AI answers from your Jung Pumpen U6 manual

Ask anything about the Jung Pumpen U6. Answers come from this manual, with the pages they are based on.

U6 Maintenance Schedule

As needed
Check mains cable for damage

Inspect the power cord for mechanical or chemical damage. Replace damaged or kinked cables only through the manufacturer.

As needed
Clean float and foot strainer

Regularly clean the float and foot strainer to ensure maximum performance. This prevents coarse impurities from entering the pump.

As needed
Clean impeller

Remove the foot strainer and unscrew the underside cover to access the impeller for cleaning if blocked or obstructed.

As needed
Inspect impeller for wear

If pumping performance decreases, check the impeller for wear and sharp edges. Replace worn parts only via the manufacturer.

M: QW-35-FL

Ask a Question

0/1000

Do you recommend U6?

Yes No

Frequently Asked Questions

A

The U6 series pumps domestic faecal-free wastewater (including water from washing machines and dishwashers). The U6K variant additionally handles groundwater, drainage water, silage juice and liquid fertilisers within specified limits.

Is this answer helpful?

A

Yes, outdoor installations require models fitted with at least a 10-metre mains cable. Always follow local regulations and ensure RCD protection (≤30 mA) and appropriate fusing (minimum 10 A slow-blow) for safe outdoor use.

Is this answer helpful?

A

Regularly clean the foot strainer and float, inspect and clean the impeller if blocked, and check the power cable for damage. In iron- or lime-rich water, increase cleaning frequency to prevent seal and motor damage.

Is this answer helpful?

A

Only qualified electricians should perform electrical work. Observe the nameplate voltage, use RCD protection, and for three-phase units verify correct rotation (startup jolt counter-clockwise). If rotation is wrong, swap two supply phases.

Is this answer helpful?

A

Yes—using specific steps: remove the foot strainer and, where applicable, lock the float switch in ON. Models can pump down to a few millimetres (U5K: ~6 mm, U6K: ~10 mm) but switching mode is not possible in low-level pumping.

Is this answer helpful?

A

Install level-dependent alarms, verify tank/sump tightness, fit backflow prevention, consider duplicate pumps or emergency power, and follow local standards (e.g., EN 12056) to minimise consequential damage.

Is this answer helpful?

A

Disconnect power, remove the foot strainer, open the lower screws and clean the impeller and housing. Check for worn impellers and replace through the manufacturer if needed; also inspect pressure lines and non-return valves for blockages.

Is this answer helpful?

M: OA-GPT-5-NAN

Advantages and Disadvantages

Advantages

  • Versatile: handles domestic wastewater plus groundwater, drainage and agricultural liquids (U6K).
  • Multiple installation options: base, guide-rail coupling or duplex setup for redundancy.
  • Built-in protections: winding thermostat, recommended RCD and fusing for safe operation.
  • Serviceable design: accessible impeller and foot strainer for cleaning and blockage removal.
  • Shallow pumping capability and options to enlarge free passage for larger solids.
VS

Disadvantages

  • Not suitable for pumping sewage containing solids with fecal matter (faecal-free wastewater only).
  • Requires qualified electrician for electrical work and correct three-phase phase rotation checks.
  • Mobile operation restrictions: vertical use only and must use foot strainer; hose must be emptied before submersion.
  • Regular maintenance required in iron- or lime-rich water to avoid seal damage and motor failure.
  • Some modifications (e.g., enlarging passage) may prevent use of the foot strainer and change operating constraints.
M: OA-GPT-5-NAN

Product Specification

Flow rate

3962.32 gal/h

Delivery head

29.53 ft

Pressure connection

1 1/4"

Special features

without Tank, IP68

M: OA-GPT-54-NAN

Product Description

Jung Pumpen U6 — Reliable Submersible Utility Pump

The Jung Pumpen U6 is a versatile, robust submersible pump designed for domestic wastewater and a range of drainage tasks. Engineered to handle household effluent—such as water from washing machines and dishwashers—the U6 also supports groundwater, drainage water, silage juice and liquid fertilizers in its K variant. It is built for dependable everyday performance with safety and maintenance in mind.

Compact and user-focused, the U6 features corrosion-resistant construction, a protective foot strainer, and an impeller accessible for cleaning or service. Models with integrated float switches provide automatic on/off control while other variants support external level controls and guide-rail installations for fixed sump stations. The pump’s design includes options to enlarge free passage and a flushing modification to reduce sediment build-up in the intake area.

Key practical attributes include frost resistance in storage (to -20°C), a maximum pumped-medium temperature of 35°C, and straightforward mounting options: base plate, guide-rail coupling or duplex installations for redundancy. Electrical safety is emphasised: only qualified electricians should perform connections, and use of RCD-protected outlets (≤30 mA) plus appropriate fusing is required. The U6 includes a winding thermostat for thermal protection and provides guidance on phase rotation for three-phase units.

Maintenance is simple but essential: regular cleaning of the foot strainer and float, periodic inspection of the impeller for wear, and ensuring the power cable is undamaged. The manual explains procedures for clearing blockages, venting the housing, and preparing the pump for shallow pumping (down to a few millimetres with specific steps). It also details safety measures, installation clearances, and legal/regulatory considerations for installation and operation.

Beyond technical guidance, the U6’s documentation stresses risk mitigation for failure scenarios—suggesting alarm systems, backflow protection, redundancy or emergency power—so that consequential damage from pump failure is minimised. Overall, the Jung Pumpen U6 is positioned as a dependable, maintainable choice for domestic and small commercial wastewater lifting and drainage needs.

Notes

  • U6K variant extends application to groundwater, drainage and agricultural liquids.
  • For outdoor use, use pumps with ≥10 m cable.
  • Observe local regulations (e.g., EN 12056, VDE) and install RCD protection.
  • Regular cleaning prevents seal and motor damage in iron- or lime-rich water.
M: OA-GPT-5-NAN

© Copyright 2026 Manual.ly