Manual.ly Logo

Jung Pumpen U3 Manual

0.0 · 0 Ratings

PDF manual · 36 Pages

English

M: QW-35-FL
page

/ 36

Loading...
e4c6681bf7cf055b84ac5db3da6073e3ca89 page 6
6
ENGLISH
You have purchased a product made by Pentair Jung Pum-
pen and with it, therefore, also excellent quality and service.
Secure this service by carrying out the installation works
in accordance with the instructions, so that our product
can perform its task to your complete satisfaction. Please
remember that damage caused by incorrect installation
or handling will adversely affect the guarantee. Therefore
please adhere to the instructions in this manual!
This appliance can be used by children aged 8 years or over
and by persons with limited physical, sensory or intellectual
capabilities, or with limited experience and knowledge, pro-
vided that they are supervised or have been instructed in
the safe use of the appliance and are aware of the dangers
involved. Children must not be allowed to play with the ap-
pliance. Cleaning and user maintenance must not be carried
out by children unless they are supervised.
Damage prevention in case of failure
Like any other electrical device, this product may fail due to a lack of
mains voltage or a technical defect.
If damage (including consequential damage) can occur as a result of
product failure, the following precautions can be taken at your discre-
tion:
• Installation of a water level dependent (under circumstances,
mains-independent) alarm system, so that the alarm can be heard
before damage occurs.
• Inspection of the collecting tank/chamber for tightness up to the top
edge before – or at the latest, during – installation or operation of
the product.
• Installation of backow protection for drainage units that can be
damaged by wastewater leakage upon product failure.
• Installation of a further product that can compensate in case of fail-
ure of the other product (e.g. duplex unit).
• Installation of an emergency power generator.
As these precautions serve to prevent or minimise consequential
damage upon product failure, they are to be strictly observed as the
manufacturer’s guideline – in line with the standard DIN EN speci-
cations as state of the art – when using the product (Higher Regional
Court Frankfurt/Main, Ref.: 2 U 205/11, 06/15/2012).
SAFETY INSTRUCTIONS
This instruction manual contains essential information that
must be observed during installation, operation and servic-
ing. It is therefore important that the installer and the respon-
sible technician/operator read this instruction manual before
the equipment is installed and put into operation. The manual
must always be available at the location where the pump or the
plant is installed.
Failure to observe the safety instructions can lead to the loss
of all indemnity.
In this instruction manual, safety information is distinctly la-
belled with particular symbols. Disregarding this information
can be dangerous.
General danger to people
Warning of electrical voltage
NOTICE! NOTICE!
Danger to equipment and operation
Qualication and training of personnel
All personnel involved with the operation, servicing, inspection
and installation of the equipment must be suitably qualied
for this work and must have studied the instruction manual in
depth to ensure that they are suciently conversant with its
contents. The supervision, competence and areas of responsi-
bility of the personnel must be precisely regulated by the ope-
rator. If the personnel do not have the necessary skills, they
must be instructed and trained accordingly.
Safety-conscious working
The safety instructions in this instruction manual, the existing
national regulations regarding accident prevention, and any
internal working, operating and safety regulations must be ad-
hered to.
Safety instructions for the operator/user
All legal regulations, local directives and safety regulations
must be adhered to.
The possibility of danger due to electrical energy must be pre-
vented.
Leakages of dangerous (e.g. explosive, toxic, hot) substances
must be discharged such that no danger to people or the envi-
ronment occurs. Legal regulations must be observed.
Safety instructions for installation, inspection and mainte-
nance works
As a basic principle, works may only be carried out to the equip-
ment when it is shut down. Pumps or plant that convey harmful
substances must be decontaminated.
All safety and protection components must be re-tted and/or
made operational immediately after the works have been com-
pleted. Their effectiveness must be checked before restarting,
taking into account the current regulations and stipulations.
Unauthorised modications, manufacture of spare parts
The equipment may only be modied or altered in agreement
with the manufacturer. The use of original spare parts and
accessories approved by the manufacturer is important for
safety reasons. The use of other parts can result in liability for
consequential damage being rescinded.
Unauthorised operating methods
The operational safety of the supplied equipment is only guar-
anteed if the equipment is used for its intended purpose. The
limiting values given in the "Technical Data" section may not be
exceeded under any circumstances.
Instructions regarding accident prevention
Before commencing servicing or maintenance works, cordon
off the working area and check that the lifting gear is in perfect
condition.
Never work alone. Always wear a hard hat, safety glasses and
safety shoes and, if necessary, a suitable safety belt.
Before carrying out welding works or using electrical devices,
check to ensure there is no danger of explosion.
People working in wastewater systems must be vaccinated
against the pathogens that may be found there. For the sake of
your health, be sure to pay meticulous attention to cleanliness
wherever you are working.
Make sure that there are no toxic gases in the working area.
Observe the health and safety at work regulations and make
sure that a rst-aid kit is to hand.
In some cases, the pump and the pumping medium may be hot
and could cause burns.
For installations in areas subject to explosion hazards, special
regulations apply!

Chat with your Jung Pumpen U3 manual using AI

Get instant AI answers from your Jung Pumpen U3 manual

Ask anything about the Jung Pumpen U3. Answers come from this manual, with the pages they are based on.

U3 Maintenance Schedule

Regularly
Clean the pump

Clean regularly depending on water hardness to prevent seal and motor damage from iron or lime deposits. Disconnect power before cleaning.

Before each pumping operation
Empty drainage hose

For flat suction or mobile use with a hose, ensure the drainage hose is completely empty before submerging the pump to allow proper venting.

M: qwen/qwen3.8-flash

Ask a Question

0/1000

Do you recommend U3?

Yes No

Frequently Asked Questions

A

The U3 series is designed for domestic waste water without stones, including water from washing machines and dishwashers. The U3 K Spezial can also pump aqueous solutions with up to 10 percent salt and condensate from gas boilers.

Is this answer helpful?

A

Yes, the pump is frost resistant down to minus 20 degrees Celsius when stored in dry conditions. However, once installed in water, it must never be allowed to freeze.

Is this answer helpful?

A

The pump has a built-in thermostat that shuts off during high temperatures caused by dry running or overload. Always ensure the pump is connected to the correct voltage and avoid running it without water.

Is this answer helpful?

A

Mobile operation is permitted only with the foot strainer attached. You must empty any drainage hose before submerging the pump to allow proper venting and operation.

Is this answer helpful?

A

The pump must be connected to sockets protected by at least a 10 amp slow-blow fuse and a residual current device (RCD) rated at 30 milliamps or less.

Is this answer helpful?

A

Regular cleaning is recommended based on water hardness. In areas with high iron or lime content, frequent cleaning is necessary to prevent seal and motor damage.

Is this answer helpful?

A

If the impeller is blocked by solids or fibers, you must remove the foot strainer, unscrew the bottom cover, and clean the impeller carefully. Check for wear and replace if necessary.

Is this answer helpful?

M: QW-35-FL

Advantages and Disadvantages

Advantages

  • Handles domestic wastewater from washing machines and dishwashers effectively
  • U3 K Spezial version tolerates saline solutions up to 10 percent and boiler condensate
  • Built-in thermal protector prevents motor damage from overheating or dry running
  • Low noise operation stays under 70 decibels for quiet indoor use
  • Can pump surfaces down to very low water levels with minimal residue left behind
VS

Disadvantages

  • Auto-restart feature after cooling creates a safety hazard if not manually disconnected
  • Requires specific 10-amp fuses and RCD protection for safe electrical connection
  • Impeller wear may occur faster in water with high iron or lime content without regular cleaning
  • Maintenance requires disconnecting power and careful handling of sharp edges on worn parts
  • Mobile operation strictly requires a foot strainer for safety compliance
M: QW-35-FL

Product Specification

Pressure connection

1.25 in

M: QW-35-FL

Product Description

Jung Pumpen U3: Reliable Domestic Wastewater Solutions

The Jung Pumpen U3 series represents a pinnacle of engineering for domestic wastewater management. Designed specifically for pumping household dirty water without stones, these submersible pumps are ideal for handling effluent from washing machines and dishwashers. The U3 K Spezial variant extends this capability further, capable of managing aqueous solutions with up to 10% salt content as well as condensate from gas condensing boilers. This versatility makes the U3 an essential component for modern homes and small commercial buildings requiring efficient drainage.

Safety is paramount in the design of the U3. The pump features a winding thermostat that automatically cuts power if temperatures become unacceptably high, preventing damage from dry running or electrical overload. However, users must remember that the pump will restart automatically once cooled, posing a potential injury risk if not disconnected first. Installation requires strict adherence to safety guidelines, including the use of qualified electricians and ensuring proper grounding with at least a 10-amp fuse and a residual current device. The pump is frost-resistant down to -20 degrees Celsius when stored dry, but it must never be allowed to freeze while installed in water.

Operationally, the U3 is built for efficiency and ease of maintenance. It can pump flooded areas leaving only minimal residual water, such as 5 millimeters for the U3K model. For mobile operations, the pump includes a foot strainer to prevent clogging and ensure safe venting. Regular cleaning of the foot strainer and impeller is crucial, especially in hard water areas, to maintain peak performance and prevent seal damage. The system supports both single and duplex installations, offering flexibility for various basement or utility room configurations. With noise levels kept below 70 dB(A), the U3 operates quietly, making it suitable for indoor environments without causing disturbance.

M: QW-35-FL

© Copyright 2026 Manual.ly