Manual.ly Logo

Hammer FlyRun 2.0 Manual

0.0 · 0 Ratings

PDF manual · 27 Pages

English

M: OA-GPT-5-NAN
page

/ 27

Loading...
386cf9612645390562438d3ad9c60baed05e page 11
16
7.1 Pflege
Entfernen Sie Schmutz von der Lauäche mit einem han-
delsüblichen Staubsauger, bei starker Verschmutzung kann
die Lauäche auch mit einem feuchten Tuch und Wasser
gereinigt werden. Verwenden Sie niemals Reinigungsmittel.
Zur Reinigung verwenden Sie bitte nur ein feuchtes
Tuch ohne scharfe Reinigungsmittel. Achten Sie darauf,
dass keine Flüssigkeit in den Computer gelangt.
Bauteile, welche mit Schweiß in Kontakt kommen,
brauchen nur mit einem feuchten Tuch gereinigt
werden. -
7.2 Zentrierung des Laufgurtes
Während des Trainings wird der Laufgurt von einem Fuß
stärker beansprucht als vom anderen. Dies führt dazu, dass
der Laufgurt auf Dauer aus der Mitte geschoben wird. Das
Laufband wurde so konstruiert, dass eine automatische
Zentrierung kontinuierlich erfolgt. Es kann aber aufgrund eines
längeren Gebrauchs dazu kommen, dass sich der Laufgurt
nicht mehr von selbst zentriert. In diesem Fall ist es notwendig
die Lauäche mit den zwei Innensechskantschrauben am
hinteren Ende des Laufbandes zu zentrieren.
Tragen Sie beim Zentrieren der Lauäche keine lose Kleidung
- Drehen Sie die Innensechskantschraube nie mehr als eine
¼ Drehung auf einmal.
- Spannen Sie immer eine Seite und lösen anschließend die
andere.
- Lassen Sie während der Zentrierung das Laufband
mit einer Geschwindigkeit von ca. 6km/h ohne
Trainingsperson laufen.
Ist die Zentrierung beendet, gehen Sie für fünf Minuten mit
der bereits eingestellten Geschwindigkeit auf dem Laufband.
Falls notwendig, wiederholen Sie den beschriebenen Vorgang.
Achten Sie darauf, dass Sie eine Überspannung des Laufgurts
vermeiden, da dadurch die Lebensdauer stark beeinträchtigt
wird.
Ist der Abstand von der linken Seite zu groß, dann
- drehen Sie die linke Schraube um eine ¼ Drehung im
Uhrzeigersinn (rechts herum; Anziehen) A
- und drehen Sie die rechte Schraube um eine ¼ Drehung
gegen den Uhrzeigersinn (links herum; Lösen). Ist
der Abstand von der rechten Seite zu groß, dann
- drehen Sie die rechte Schraube um eine ¼ Drehung im
Uhrzeigersinn (rechts herum; Anziehen)B
- und drehen die linke Schraube um eine ¼ Drehung gegen
den Uhrzeigersinn (links herum; Lösen)
7.1 Care
For cleaning the running belt use a vacuum cleaner. If the
belt is really dirty, please use a wet cloth. Do not use any
cleanser.
When cleaning, use only a moist cloth and avoid harsh
cleaning agents.
Ensure that no moisture comes into the computer.
Components that come into contact with perspiration,
need cleaning only with a damp cloth.
7.2 Centering the running belt
During the exercise, one foot is pushing the running belt
stronger than the other. According to that, the belt will be moved
out of the centre. Normlly the belt will be centred automatically,
but during longer exercise, it can be, that the belt is off the
centre.In this case, please follow up the following instruction. At
the rear end of the running deck, there are 2pcs of allen screws,
which will be used for centering the belt. Don´t use any loose
clothes during centering.
- Please turn the allen screw not more than ¼ turn for each
step.
- Stretch one side and release the other side.
- the speed of the belt has to be 6km/h, but make sure,
that nobody is running on the belt.
If you nish the centering, walk on the treadmill for about 5
minutes, with the speed of 6km/h. If the running belt is still
not in centre, please centre the belt again. Pay attention, that
you don´t force the belt too much, a shorter life will be caused.
If the gap on the left side is too big, please
- turn the left screw a ¼ turn clockwise (tighten it)A
- turn the right screw a ¼ turn anticlockwise (loose it)
If the gap on the right side is too big, please
- turn the left screw a ¼ turn anticlockwise (loose it)B
- turn the right screw a ¼ turn clockwise (tighten it)
7. Pflege und Wartung
7. Care and Maintenance

Chat with your Hammer FlyRun 2.0 manual using AI

Get instant AI answers from your Hammer FlyRun 2.0 manual

Ask anything about the Hammer FlyRun 2.0. Answers come from this manual, with the pages they are based on.

FlyRun 2.0 Maintenance Schedule

Before first use
Lubricate the treadmill

Apply silicone lubricant to the running deck before first use. Check periodically by feeling for silicon under the belt.

Show in the manual (page 16)
As needed
Clean the running belt and components

Remove dirt with a vacuum or damp cloth. Do not use cleaning agents. Wipe sweat-contact parts with a damp cloth.

Show in the manual (page 17)
Regularly
Check screws and nuts

Regularly check that all screws, nuts, handles, and pedals are tightly secured and free of defects.

Regularly
Inspect wear parts

Regularly inspect parts subject to wear indicated by an asterisk in the parts list to ensure safety.

M: QW-35-FL

Ask a Question

0/1000

Do you recommend FlyRun 2.0?

Yes No

Frequently Asked Questions

A

The treadmill supports up to 130 kg maximum user weight and is certified to EN ISO20957-1/6 Class HB for home use.

Is this answer helpful?

A

Yes. Lubricate the running deck before first use with the recommended silicone lubricant. Raise the belt, apply lubricant to the deck, wipe it evenly, and repeat on the other side. Unplug the unit before maintenance.

Is this answer helpful?

A

The treadmill will not start unless the safety key is inserted and clipped to your clothing. Pulling the key out stops the treadmill immediately. Use the START/STOP button for controlled stopping; if incline is not zero after an emergency stop, reset incline to 0 before restarting.

Is this answer helpful?

A

The console supports Quickstart, 15 preset programs, 3 user-program slots (U01–U03), HRC heart-rate control (HP1–HP3), countdown modes (time/distance/calories), and a fat-measurement mode.

Is this answer helpful?

A

Centering and tensioning are done via two rear hex screws. Perform adjustments in 1/4-turn increments while the belt runs at about 6 km/h with no user. Tighten clockwise to increase tension; center by alternating small turns and testing.

Is this answer helpful?

A

No. It is intended for private home use only. Using it in commercial settings like gyms, hotels, or rehab centers may void warranty and exceed design specifications.

Is this answer helpful?

A

A recommended session includes 5–10 minutes warm-up, 15–40 minutes main training at 70–85% of maximum heart rate, and 5–10 minutes cool-down. Beginners should start at lower intensity and build up gradually.

Is this answer helpful?

M: OA-GPT-5-NAN

Advantages and Disadvantages

Advantages

  • Comprehensive console: Quickstart, 15 programs, 3 user programs, HRC, countdown modes and body-fat measurement.
  • Safety-focused: emergency safety key, clear start/stop procedure and mains safety instructions.
  • Space-saving foldable design with air-assist cylinder and three incline settings.
  • Maintenance-friendly: clear instructions for lubrication, belt centering and tensioning; wear parts listed.
  • Suitable for home use with EN ISO20957-1/6 Class HB certification and 130 kg max user weight.
VS

Disadvantages

  • Not intended for commercial or multi-user gym environments; warranty may be voided for non-home use.
  • Assembly requires two people and some manual adjustment (screws, centering) which can be fiddly.
  • Speed and belt adjustments require manual screw turns; improper adjustment can reduce belt life.
  • Heart rate control requires an accurate chest strap and correct setup; loss of signal reduces functionality.
  • Electrical safety depends on correct mains voltage and single-outlet use; avoid multi-sockets and overloaded circuits.
M: OA-GPT-5-NAN

Product Specification

Colors

black, white

Motor power

2HP continuous power, 4.5HP maximum power

Speed

0.50-12.43 mph

Incline

0.9-3.3% manually adjustable

Running surface

51.18x16.54in

Max. user weight

286.60lb

Dimensions

62.20x28.74x49.61in

Folded dimensions

36.22x28.74x55.12in

Weight

118.89lb

Features

Transport wheels, hand pulse measurement, chest strap compatible, tablet holder, app support (iOS, Android), foldable

M: OA-GPT-54-NAN

Product Description

Hammer FlyRun 2.0 Treadmill — Practical Guide and Overview

The Hammer FlyRun 2.0 Treadmill is a home-use treadmill built to EN ISO20957-1/6 Class HB standards, designed for users up to 130 kg. It combines a user-friendly console with multiple training modes, safety features, and essential maintenance guidance to deliver a reliable cardio solution for home fitness. The console supports Quickstart, 15 preset programs, three user-program slots, HRC (heart rate control) modes, countdown targets (time, distance, calories), and a body fat measurement function. Speed can be adjusted with dedicated buttons and four quick-speed shortcuts for rapid changes.

Assembly is simplified by partial preassembly; two people are recommended for full setup. The treadmill has a folding mechanism with an air-assist bar for space-saving storage and three incline positions set via a locking pin. The unit requires a stable, level surface with at least 1.5–2 m clearance around it. Electrical safety guidance emphasizes correct mains voltage, avoiding multi-socket overloads, and using the supplied power cord and switch safely.

Safety and start procedures center on the emergency safety key: the treadmill won’t run without it inserted and will stop instantly if removed. Users are instructed to clip the key to clothing and to use the START/STOP button for controlled stopping. The HRC modes (HP1–HP3) automatically adjust speed to keep heart rate near a target value derived from age and intensity; the console displays pulse-related color signals (green/yellow/red) to indicate training zones.

Maintenance and care are clearly detailed: lubricate the deck before first use and periodically thereafter (silicone lubricant supplied), clean the belt with a vacuum or damp cloth (no harsh chemicals), and keep sweat-prone parts wiped. Belt centering and tension adjustments are performed via rear hex screws in small increments (¼ turn max) while the belt runs at ~6 km/h with no user on it. Wear parts like the belt and drive components are listed in the parts section and should be checked regularly.

Training guidance recommends pulse-oriented training, warming up and cooling down, and progressive frequency and intensity—ideally three sessions per week initially, increasing as fitness improves. Target training pulses are calculated from 220 − age, and recommended training intensity is 70–85% of maximum heart rate. Typical session structure: 5–10 min warm-up, 15–40 min training, 5–10 min cool-down.

Notes:

  • Maximum user weight: 130 kg.
  • Designed for home use only; commercial use voids warranty.
  • Lubricate before first use and routinely thereafter.
  • Keep safety-key clipped to clothing during use.

Product manual keyword

Hammer FlyRun 2.0 Treadmill Manual

M: OA-GPT-5-NAN

© Copyright 2026 Manual.ly