Manual.ly Logo

Bosch DIY AdvancedAquatak 140 Manual

0.0 · 0 Ratings

PDF manual · 294 Pages

English

M: OA-GPT-54-NAN
page

/ 294

Loading...
bc60732ad9ae673511ce119b89452c6921f2 page a
10 | Deutsch
dem Schlauch zu verdrängen und schließen Sie ihn dann an
den Hochdruckreiniger an.
Fehlersuche
Symptome Mögliche Ursache Abhilfe
Motor läuft nicht an Stecker nicht angeschlossen Stecker anschließen
Steckdose defekt Andere Steckdose benutzen
Sicherung hat ausgelöst Sicherung wechseln
Verlängerungskabel beschädigt Ohne Verlängerungskabel versuchen
Motorschutz hat angesprochen Den Motor 15 min abkühlen lassen
Eingefroren Pumpe, Wasserschlauch oder Zubehör auftauen
lassen
Motor bleibt stehen Sicherung hat ausgelöst Sicherung austauschen
Netzspannung nicht richtig Netzspannung prüfen, muss der Angabe auf dem
Typenschild entsprechen
Motorschutz hat angesprochen Den Motor 15 min abkühlen lassen
Sicherung löst aus Sicherung zu schwach An einen Stromkreis anschließen, der passend
zur Leistung des Hochdruckreinigers abgesichert
ist
Der Motor läuft, aber
kein Druck vorhanden
Düse teilweise verstopft Düse reinigen
Motorgeräusch vorhan-
den aber keine Funkti-
on
Unzureichende Netzspannung Prüfen Sie, ob die Spannung des Stromnetzes
den Angaben auf dem Typenschild entspricht.
Zu niedrige Spannung wegen Verwendung eines
Verlängerungskabels
Prüfen Sie, ob das Verlängerungskabel geeignet
ist
Gerät wurde lange Zeit nicht benutzt Wenden Sie sich an den autorisierten Bosch Kun-
dendienst
Probleme mit der Autostop-Funktion Wenden Sie sich an den autorisierten Bosch Kun-
dendienst
Pulsierender Druck Luft im Wasserschlauch oder in der Pumpe Hochdruckreiniger mit offener Sprühpistole, offe-
nem Wasserhahn und bei auf Niederdruck einge-
stellter Düse laufen lassen, bis ein gleichmäßiger
Arbeitsdruck erreicht wird
Wasserversorgung nicht korrekt Prüfen, ob der Wasseranschluss den Angaben in
den technischen Daten entspricht. Die kleinsten
Wasserschläuche die verwendet werden dürfen,
sind 1/2" oder Ø13mm
Wasserfilter verstopft Wasserfilter reinigen
Wasserschlauch gequetscht oder geknickt Wasserschlauch gerade auslegen
Hochdruckschlauch zu lang Hochdruckschlauch-Verlängerung abnehmen,
max. Wasserschlauchlänge 7m
Druck gleichmäßig
aber zu niedrig
Hinweis: Bestimmtes
Zubehör verursacht
einen niedrigen Druck
Düse abgenutzt Düse auswechseln
Start-/Stoppventil abgenutzt Abzug 5 mal schnell hintereinander betätigen
Der Motor läuft, aber
Druck begrenzt oder
kein Arbeitsdruck
Wasser nicht angeschlossen Wasser anschließen
Filter verstopft Filter reinigen
Düse verstopft Düse reinigen
F 016 L81 693 | (10.01.2019) Bosch Power Tools

Chat with your Bosch DIY AdvancedAquatak 140 manual using AI

Get instant AI answers from your Bosch DIY AdvancedAquatak 140 manual

Ask anything about the Bosch DIY AdvancedAquatak 140. Answers come from this manual, with the pages they are based on.

AdvancedAquatak 140 Maintenance Schedule

Remind me when maintenance is due
Yearly
Inspect for defects

Regularly check for obvious defects such as loose fixings, worn or damaged components, and ensure covers are undamaged.

Show in the manual (page 11)
After every use
Drain water from hose and pump

Turn off switch and press trigger to drain high-pressure hose. Drain pump by running motor briefly at end of season.

Show in the manual (page 11)
Before each use
Clean water filter

Ensure Bosch inlet filter is clean and fitted before using the machine with alternative water sources or mains water.

As needed
Clean nozzle

Clean nozzle if pressure is low or pulsating due to partial blockage.

Show in the manual (page 10)

Free maintenance reminders

Timed to your purchase date. Always free, unsubscribe anytime.

By submitting you agree to the privacy policy. Unsubscribe with one click in any email.
M: QW-35-FL

Ask a Question

0/1000

Do you recommend AdvancedAquatak 140?

Yes No

Frequently Asked Questions

A

It is designed for cleaning areas and objects outdoors around the house, including surfaces, tools, vehicles and boats, as long as you use suitable accessories and Bosch-approved cleaning agents.

Is this answer helpful?

A

Yes. The Autostop function switches the motor off when you release the trigger on the spray gun. This helps you pause safely and efficiently without running the pump continuously.

Is this answer helpful?

A

The guidance stresses that you should not connect it directly to the drinking water network without proper backflow protection. A system separator/backflow valve is required so that water passing through is not considered potable.

Is this answer helpful?

A

Use only clean or filtered water for intake. The manual also emphasizes keeping the Bosch inlet filter clean and correctly fitted. Using a dirty or damaged filter can invalidate warranty and reduce performance.

Is this answer helpful?

A

Yes, it supports self-priming. With the self-priming accessory kit, it can draw water from tanks or natural sources, including up to about 0.5 m above the water level. Proper airtight hoses, couplings, and the inlet filter are critical.

Is this answer helpful?

A

Only detergents specifically recommended for pressure washers. Use sparingly and follow the dilution recommendations on the product label. Do not use solvent-containing liquids or undiluted acids.

Is this answer helpful?

M: OA-GPT-54-NAN

Advantages and Disadvantages

Advantages

  • Strong pressure washer performance for home exterior cleaning
  • Autostop motor shutoff when releasing the trigger improves efficiency
  • Practical cleaning sequence: loosen with fan nozzle, apply detergent, rinse
  • Self-priming support for water tanks and natural sources (with kit)
  • Safety guidance covers electrical and water-connection precautions
VS

Disadvantages

  • Requires careful electrical setup, including RCD-protected connections
  • Needs clean or filtered intake water and a properly maintained inlet filter
  • Hose and nozzle care are essential to prevent loss of pressure
  • High-pressure operation demands two-handed control and PPE awareness
  • Alternative water use depends on the correct self-priming accessories
M: OA-GPT-54-NAN

Product Specification

Operating Mode

Cold Water

Power

2100W

Pressure

2,030.53 psi

Flow Rate

max. 118.88 gal/h

Inlet Temperature

max. 104 F

Mobility

Trolley

Fuel Tank

no

Weight

38.68 lbs

Scope of Delivery

High-pressure gun, High-pressure hose (8m), Lance/Spray wand, Nozzle (Rotary nozzle), Hose reel, Accessory holder, Hose, Water filter

M: GO-GEM-FL-25

Product Description

Bosch DIY AdvancedAquatak 140 Electric high-pressure washer

If you want a reliable way to tackle outdoor grime, the Bosch DIY AdvancedAquatak 140 Electric high-pressure washer is built for everyday cleaning jobs around the home. With a 2.1 kW motor, it delivers strong cleaning performance for patios, garden tools, vehicles and boats, using the right accessories and approved detergents.

What makes this washer a practical choice is how well it supports safe, controlled use. The guidance in the Bosch DIY AdvancedAquatak 140 Electric high-pressure washer Manual emphasizes key precautions such as never aiming the jet at people, using clean or filtered water intake, and protecting electrical connections. You also get an Autostop function that switches the motor off when the trigger is released, helping reduce unnecessary running during breaks.

Cleaning is designed to be straightforward. You can start with the fan nozzle to loosen heavy dirt, then apply detergent using the foam/solution bottle, and finally rinse with the fan nozzle to lift residues away. For vertical surfaces, the recommended approach is to work from the bottom up during cleaning, then rinse from top down.

The AdvancedAquatak 140 can also be used with alternative water sources thanks to its self-priming capability. With the correct self-priming accessory kit, it can draw water from tanks or natural sources up to about 0.5 m above the water level. The manual highlights that the Bosch inlet filter should be clean and correctly fitted, and that hoses and couplings must be airtight to maintain suction performance.

Key results

  • Up to 14 MPa (140 bar class) maximum pressure for removing ground-in outdoor dirt
  • Rated 11 MPa with 6.8 L/min rated flow for steady rinsing power
  • Autostop motor shutoff when the trigger is released for efficient control
  • Self-priming support to draw water from tanks/natural sources with the right kit
  • Safety-focused setup requirements: use filtered water, backflow protection, and RCD protection

Notes

  • For best results, keep the nozzle and water filter clean and avoid running the unit dry.
  • Use only detergents approved for pressure washers and follow the recommended dilution.

Pros and cons

Pros

  • Strong cleaning capability for outdoor surfaces, tools and vehicles
  • Autostop function improves control and reduces wasted power
  • Fan-nozzle and detergent-bottle steps simplify the cleaning workflow
  • Self-priming enables use with tanks or natural water sources
  • Manual-driven safety requirements help prevent common hazards

Cons

  • Not intended for professional use (home and garden focus)
  • Requires correct electrical setup (RCD protection, proper extension cords)
  • Demands clean/filtered water and a correctly seated inlet filter
  • High-pressure jet requires careful handling with protective awareness
  • Accessory kit and correct hoses may be needed for alternative water sources
M: OA-GPT-54-NAN

© Copyright 2026 Manual.ly