Manual.ly Logo

Atika RMC 40-400 Manual

0.0 · 0 Ratings

PDF manual · 117 Pages

English

M: QW-35-FL
page

/ 117

Loading...
099976b7844054ffea99f583927ab5a84673 page 12
17
Refer to the respective operating instructions for further
information on the batteries and the charger.
Inserting/ removing batteries
Inserting batteries
The lawn mower may be operated with one or two
batteries; you may also use batteries with different
capacities.
Open the cover of the battery compartment (6)
Insert one or both batteries in the unit.
Make sure the batteries (12) are pushed in until
they engage audibly.
Insert the safety key (16) between the batteries
Removing batteries
Pull the unlocking lever (B) up and pull out the
batteries.
Start-up
Switching on/off
The device is equipped with a safety circuitry preventing
inadvertent switching on.
Make sure before each startup that the safety button
and the switch bar are working properly.
Do not use the unit if it can only be switched on with
the switch bar. The unit must be checked and
repaired immediately by the customer service.
Start the unit only after placing it on a lawn area
Switching on
Tip the lawn mower slightly towards you so that the front
wheels are above the ground.
Push the safety button (7) and keep it depressed.
Next, pull the switch lever (3) toward the handle hoop.
The lawn mower starts and the blade can turn freely
Your lawn mower has a soft-start function; after
operating the ON-switch, the lawn mower takes
approximately 3 seconds to reach maximum speed.
Now release the safety button (7).
To protect the battery the unit switches off
automatically at a low battery charge.
Do not try to restart the lawn mower; this may
damage the battery.
Charge the lithium-ion batteries (“Battery”
operating instructions).
The cordless lawn mower has an energy-saving function
that automatically adjusts the cutting speed to the requirements
to achieve the best possible cut while maximising run time and
battery life.
Switching off
When you release the switch lever it returns automatically to its
original position.
The cutting blade continues running a little longer
after switching off the unit.
Adjusting the cutting height
Before adjusting the cutting height:
switch off device
Wait until the cutting blade has come to a
stop
Pull off the safety key and remove the
batteries
Adjust the cutting height by moving the height
adjustment lever (5) to the desired position
to increase the cutting height, slide the lever toward the
rear wheel
to reduce the cutting height, slide the lever toward the
front wheel
The cutting height can be adjusted at 7 levels from 2.5 –
7.5 cm.
Recommended cutting height:
Decorative lawn 2.5 – 4 cm (Position 1-3)
Regular lawn 3 – 5 cm (Position 2-4)
Shade lawn 5 – 6 cm (Position 4-6)
During hot and dry weather the cutting height should be
approximately 1 – 2 cm higher.
If the lawn is higher (e.g. after vacation time), cut only
one third of the total height at the most. Allow the lawn
to rest for a few days and then mow in stages to the
normal height again.
Cut the lawn a bit shorter (2.5 – 3 cm) toward winter
to prepare the lawn for the winter.
Increase the cutting height if the motor is
overloaded (motor speed drops and motor noise
changes).

Chat with your Atika RMC 40-400 manual using AI

Get instant AI answers from your Atika RMC 40-400 manual

Ask anything about the Atika RMC 40-400. Answers come from this manual, with the pages they are based on.

RMC 40-400 Maintenance Schedule

Before each use
Check blade condition

Inspect cutting blades for wear or damage before every use. Worn blades reduce performance and strain the motor.

Show in the manual (page 19)
After each use
Clean the mower

Clean the device immediately after work. Remove grass from underside, blades, and vents using a cloth or brush. Do not use water jets.

Show in the manual (page 19)
Regularly
Check fasteners and safety devices

Regularly check for loose nuts, bolts, screws, and damaged parts like the grass catcher. Ensure all guards are properly attached.

Show in the manual (page 18)
Before long-term storage
Prepare for storage

Thoroughly clean the machine and treat metal moving parts with environmentally friendly oil to prevent corrosion. Never use grease.

Show in the manual (page 19)
M: qwen/qwen3.8-flash

Ask a Question

0/1000

Do you recommend RMC 40-400?

Yes No

Frequently Asked Questions

A

No, the lithium-ion batteries and the charger are not part of the standard delivery. You must purchase them separately from your dealer or the manufacturer.

Is this answer helpful?

A

It is recommended not to operate the mower on wet grass. Wet conditions can clog the machine, reduce cutting quality, and increase safety risks.

Is this answer helpful?

A

Use the lever on the side of the mower. Slide it towards the rear wheel to increase height or towards the front wheel to decrease it. There are 7 positions available.

Is this answer helpful?

A

You should only use this mower on slopes with a gradient of less than 15 degrees. Always mow sideways across the slope, never up and down.

Is this answer helpful?

A

Check the blades before every use. Replace them if they are dull or damaged. Dull blades tear grass, causing yellowing, and strain the motor.

Is this answer helpful?

M: QW-35-FL

Advantages and Disadvantages

Advantages

  • Eco-friendly cordless operation with no emissions
  • Adjustable cutting height with 7 different settings
  • Includes both grass catcher and mulching insert options
  • Soft-start function protects the motor and battery
  • Compact design allows handlebars to fold for storage
VS

Disadvantages

  • Battery and charger are not included in the package
  • Requires separate purchase of compatible Li-Ion batteries
  • Not suitable for wet grass or very steep slopes
  • Motor may struggle if grass is too long or dense
  • Blade replacement requires specific tools and caution
M: QW-35-FL

Product Specification

Type

Lawn mower

Battery

36V, Li-Ion

Cutting width

15.75 inches

Cutting height

0.98-2.95 inches, adjustable, 7 levels

Grass collection volume

15.85 gallons

Features

Mulching function, side discharge, rear discharge, fill level indicator

Noise emission

94dB(A)

Weight

48.50 lbs

Delivery scope

without charger and battery

M: QW-35-FL

Product Description

Atika RMC 40-400 Battery Lawn Mower Solo: A Comprehensive Guide

The Atika RMC 40-400 Battery Lawn Mower Solo represents a significant step forward in home gardening efficiency. Designed for private gardens and hobby lawns, this cordless machine offers the freedom of movement without the hassle of cables or fuel. While the battery and charger are sold separately, the mower itself is ready to accept up to two lithium-ion batteries, providing flexible power options for various lawn sizes.

Operating this device requires careful attention to safety and proper assembly. The unit comes with essential accessories like a grass catcher and a mulching insert, allowing users to choose between collecting clippings or returning nutrients to the soil. The cutting height is easily adjustable across seven levels, ranging from 2.5 cm to 7.5 cm, ensuring a perfect cut for decorative, regular, or shade lawns. Safety features include a soft-start function, a safety key that must be inserted between batteries, and an automatic shut-off when the battery charge is low.

Maintenance is straightforward but critical for longevity. Users must regularly check blade sharpness, clean the underside of the mower, and ensure all fasteners are tight. It is important to never use solvents or high-pressure water for cleaning. Always remove the batteries before performing any maintenance tasks. The mower complies with European safety standards and should be disposed of according to local electronic waste regulations. By following the manual instructions regarding noise restrictions and safe operating practices, owners can enjoy a quiet and efficient mowing experience.

M: QW-35-FL

© Copyright 2026 Manual.ly