Manual.ly Logo

Velleman CS50 Manual

0.0 · 0 Ratings

PDF manual · 19 Pages

English

M: OA-GPT-54-NAN
page

/ 19

Loading...
9c4d309f7db0e2aae1957803a482d5141c4b page 3
CS50
V. 03 – 11/07/2017 3 ©Velleman nv
USER MANUAL
1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle
could harm the environment. Do not dispose of the unit (or batteries) as unsorted municipal
waste; it should be taken to a specialized company for recycling. This device should be
returned to your distributor or to a local recycling service. Respect the local environmental
rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Velleman! Please read the manual thoroughly before bringing this device into
service. If the device was damaged in transit, do not install or use it and contact your dealer.
For educational purposes only - use only under the supervision of an adult instructor.
2. General Guidelines
Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.
3. How to Set Up the Metal Detector
Only the length of the stem and the angle of the search coil have to be adjusted.
Adjusting the Length of the Stem
1. Turn the nut of the stem clockwise until it loosens.
2. Adjust the length of the stem until you can walk comfortably with the search coil at 0.5 to 2" above
the ground.
3. Tighten the nut by turning counterclockwise.
Adjusting the Position of the Search Coil
1. Loosen the knobs of the search coil and rotate the unit until it is parallel to the ground.
2. Tighten the knobs to keep the search coil from vibrating or rotating during use.
4. Battery Installation
Remove the cover of the battery compartment located on the handle and insert a new 9 V-battery.
Observe the polarity indications !
5. Operation
The CS50 Treasure Hunter enables you to hunt for coins, jewellery, gold and silver. The LED indicator on
the handle will light when a metal object is detected and the buzzer will be activated.
Hold the CS50 in a comfortable position with the search coil parallel to a surface free of metal objects.
Put the adjustable "ON/OFF" sensitivity switch (on the handle) in the position where the LED indicator
lights up slightly and the buzzer produces the faintest of beeping sounds. This is the "no-metal-detected"
threshold position in which the CS50 is at its most sensitive. Rotate the dial even further to enter the
"metal-detected" state.
Use the "maximum sensitivity point" to perform a test on a metal object. The buzzer will beep at max.
volume and the LED will light at max. intensity. These elements indicate that a metal object has been
detected.
Place the sensitivity switch exactly between the "no metal detected"-state and the "metal detected"-
state. Familiarize yourself with the sensitivity of the device by repeating the test with objects of different
sizes made of various metals, such as copper, iron and aluminium.
Note: The max. sensitivity position will be influenced by environmental factors.
6. Tips for Treasure Hunters
Always install the max. sensitivity position when using the device.
Sweep the metal detector from side to side while maintaining a constant distance between the search
coil and the ground. Do not swing the detector like a pendulum.
Take your time. You may miss a target if you walk too fast.

Chat with your Velleman CS50 manual using AI

Get instant AI answers from your Velleman CS50 manual

Ask anything about the Velleman CS50. Answers come from this manual, with the pages they are based on.

CS50 Maintenance Schedule

After salt water use
Rinse search head with fresh water

Rinse the waterproof search head with fresh water after using the device in salt water to prevent corrosion of metal parts.

When signal weakens
Replace battery

Replace the 9 V battery when the buzzer signal becomes weak or faint.

M: QW-35-FL

Ask a Question

0/1000

Do you recommend CS50?

Yes No

Frequently Asked Questions

A

The CS50 Treasure Hunter is designed for finding coins, jewelry, and metal objects including gold and silver. It uses a sensitivity control plus a LED indicator and a buzzer to alert you when a metal object is detected.

Is this answer helpful?

A

Start with the search coil parallel to a metal-free surface. Turn the sensitivity switch so the LED lights slightly and the buzzer is at its faintest. This is the no-metal-detected threshold. Then rotate further into the metal-detected region. For testing on known metal, use the maximum sensitivity point.

Is this answer helpful?

A

Sweep side to side while keeping the search coil at a consistent height above the ground. Maintain steady, controlled movement and avoid swinging the detector like a pendulum. Take your time because moving too fast can cause you to miss targets.

Is this answer helpful?

A

The search head is waterproof and can be submerged in fresh or salt water. The handle is not waterproof. If you use it in salt water, rinse the search head with fresh water afterward to help prevent corrosion.

Is this answer helpful?

A

It runs on 1x 9V battery (6LR61C, not included). Replace the battery when the buzzer becomes weak. When installing, observe polarity markings in the battery compartment, and do not leave old batteries installed.

Is this answer helpful?

A

Always seek permission from the site owner and follow applicable national, regional, and local laws. Do not destroy historically or archaeologically valuable objects. If you find something you cannot identify, contact a museum or historical society, and refill any holes while leaving vegetation intact.

Is this answer helpful?

M: OA-GPT-54-NAN

Advantages and Disadvantages

Advantages

  • LED indicator plus buzzer feedback makes detections easy to notice.
  • Adjustable sensitivity (baseline and maximum test point) helps beginners calibrate quickly.
  • Simple setup: adjust stem length and coil angle for comfortable scanning.
  • Search head is waterproof and can be used in fresh or salt water.
  • Includes an ethical code: permission, legal compliance, and careful site restoration.
VS

Disadvantages

  • Uses a 9V battery (6LR61C), not included.
  • Handle is not waterproof, so it must be kept dry.
  • Maximum sensitivity is influenced by environmental factors.
  • Detects using a basic on/off style alert, with limited target information.
  • Best results require steady sweeping; rushing can make you miss targets.
M: OA-GPT-54-NAN

Product Specification

Suitable for

Metal

Power supply

Battery operated (1x 9V block battery)

M: GO-GEM-FL-25

Product Description

Velleman CS50 Metal Detector (Velleman CS50 Metal Detector Manual)

Looking for an easy, beginner-friendly way to try metal detecting? The Velleman CS50 Metal Detector, also called the CS50 Treasure Hunter, is a low-cost detector designed to help you locate common targets like coins, jewelry, and metal objects including gold and silver. It keeps things simple with clear feedback: a LED indicator on the handle lights up when metal is detected, and a built-in buzzer activates to alert you with sound.

The detector is made for straightforward use. You adjust the length of the stem and the angle of the search coil, then install a 9V battery in the handle. During scanning, you hold the CS50 with the search coil parallel to the ground over an area free of metal objects. The adjustable ON/OFF sensitivity control lets you find a baseline where the LED glows only slightly and the buzzer sounds at its faintest. From there, you can move into the stronger detection region and even use the maximum sensitivity point to test the response on known metal.

For more reliable results, the CS50 uses a practical sweeping technique. Move the detector side to side while keeping a consistent distance between the coil and the ground. The guidance is to avoid fast, careless movements that can make you miss targets. The device also notes that maximum sensitivity can change due to environmental factors, so it helps to recalibrate your feel for the sensitivity as you go.

Built for outdoor exploration, the CS50 includes a waterproof search head that can be submerged in fresh or salt water. After using it in salt water, you should rinse the search head with fresh water to help prevent corrosion. The handle itself is not waterproof, so keep it protected.

Finally, the CS50 comes with a universal code of conduct. You are encouraged to hunt only with permission, follow local laws, avoid damaging historically or archaeologically valuable items, and leave vegetation intact while filling any holes you dig.

Key results

  • Simple operation with LED plus buzzer feedback for clear target alerts.
  • Adjustable sensitivity with a recommended baseline and a maximum test point.
  • Waterproof search head supports use in fresh or salt water (with rinsing).
  • Easy setup: adjust stem length and search coil parallel to the ground.
  • Best performance comes from controlled side-to-side sweeping and patience.

Notes

  • Use the sensitivity setting carefully since surroundings can shift the maximum-sensitivity position.
  • Replace the 9V battery when the buzzer weakens, and observe polarity during installation.
  • Handle the detector gently to avoid circuit or housing damage.
M: OA-GPT-54-NAN

© Copyright 2026 Manual.ly