Manual.ly Logo

VDO Cycle Parts Eco Light M60 + Red Plus Manual

0.0 · 0 Ratings

PDF manual · 2 Pages

English

M: OA-GPT-5-NAN
page

/ 2

Loading...
bcc1be14cef8b11f4d5a5d11bae71761eab6 page 2
1
Anbauhöhe zwischen 250 -1200 mm.
Mounting height between 250 -1200 mm.
4
Mode / Modus / Mode / Modo / Modo / Modo / Mode / Tryb
2
Installation / Montage / Montage / Montaggio / Montaje /
Montagem / Montage / Montaż
3
Alignment / Ausrichtung / Alignement / Allineamento /
Alineación / Alinhamento / Opstelling / Wyrównanie
65
Charging / Ladevorgang / Charge / Ricarica / Carga / Carregamento / Opladen /
Ładowanie
Wenn die rote LED leuchtet, dann umgehend aufladen!
Die LEDs sind nicht austauschbar. Bei Ausfall einer LED
ist die gesamte Leuchte auszutauschen!
If red light appears, please charge! The LEDs are not
replaceable. If an LED fails, the complete light has to
be replaced.
90°
17°
Achten Sie bitte darauf, dass
die in der Abbildung rot mar-
kierte Abdichtung nach dem
Ladevorgang stets korrekt
verschlossen ist.
Make sure that the sealing
marked in the illustration is
always closed correctly after
charging.
Bezugsachse der Schlussleuchte parallel zur Fahrbahn und parallel
zur Fahrzeuglängsachse.
Reference axis of the rear light parallel to the road surface and parallel
to the longitudinal axis of the bike.
Fahrzeugmittelachse
Vehicle center axis
Bezugsachse
Reference axis
ECO LIGHT RED PLUS
Die O-Ring Größe ist so auszuwählen, dass ein Verrutschen des Rücklichts
während der Fahrt verhindert wird. Das Rücklicht darf nicht an beweglichen
und verstellbaren Teilen der Sattelstütze angebracht werden.
The O-ring size should be selected to prevent the tail light from slipping while
driving. The device may not be mounted on any movable parts of the saddle pillar.
A B
ca. 2.5 h
Battery indicator / Akku Indikator / Indicateur de
batterie / Indicatore della batteria / Indicador de
batería / Batterij-indicator / Wskaźnik baterii
Unifit:
10-32 mm
Micro
Eine Energieentnahme über den Micro-USB-Anschluss ist nicht möglich.
Diese Lampe muss bei einer defekten Lichtquelle ausgetauscht werden.
Energy extraction through the Micro USB port is not possible. These lamp
needs to be replaced in case of defective light source.
DC 5 V/ max. 1A
charger not incl.
Die Lichtverteilung darf
nicht verdeckt sein!
Do not cover the tail light!
Das VDO Rücklicht ist ein sensorgesteuertes, selbstkalibrierendes
Verzögerungslicht. Die Kalibrierung erfolgt bei jedem Einschalten und wird
durch eine ca. 3 sec. grün leuchtende LED angezeigt.
Achtung: Vor dem Einschalten das VDO Rücklicht montieren
und das Fahrrad in eine waagerechte Position bringen.
The VDO rear light is a sensor-controlled, self-calibrating
negative acceleration light. It is calibrated every time it is switched on
and is indicated by a green LED for approx. 3 seconds.
Attention: Before switching the VDO rear light on,
mount it and place the bicycle in a horizontal position.
90°
Rücklicht ist an. Verzögerungslicht ist aktiv.
Bei negativer Beschleunigung
leuchtet 1 weitere rote LED für
ca. 3 Sekunden.
Rear light is on. The negative acceleration light is active.
During negative acceleration, 1 additional red LED lights up for
approximately 3 seconds.
1 x click = Dauer-
+ Verzögerungslicht /
Constant
+ Negative acceleration light
+ 1 x click = off
Schalter / Button
Akku Indikator
Battery indicator
15 - 0 %
Während des Ladevorgangs leuchtet die grüne Indikator
LED. Nach dem Ladevorgang erlischt diese.
During charging, the green indicator LED lights up.
The indicator will go out after charging.

Chat with your VDO Cycle Parts Eco Light M60 + Red Plus manual using AI

Get instant AI answers from your VDO Cycle Parts Eco Light M60 + Red Plus manual

Ask anything about the VDO Cycle Parts Eco Light M60 + Red Plus. Answers come from this manual, with the pages they are based on.

Ask a Question

0/1000

Do you recommend Eco Light M60 + Red Plus?

Yes No

Frequently Asked Questions

A

Mount the Red Plus on a fixed, non-movable part of the seatpost using an appropriately sized O-ring (fit for 10–32 mm). Ensure the O-ring prevents slipping and the reference axis of the light is parallel to the road and the bike’s longitudinal axis.

Is this answer helpful?

A

Each time the Red Plus powers on it self-calibrates; a green LED lights for about 3 seconds to indicate calibration. The bicycle must be mounted and placed horizontally before switching the light on to ensure proper sensor calibration.

Is this answer helpful?

A

The LEDs are not serviceable or replaceable. If any LED fails, the entire light unit must be replaced to ensure correct operation and compliance with safety standards.

Is this answer helpful?

A

The lights use a USB Li-ion battery and charge via Micro-USB. Use a DC 5 V / max. 1 A charger (not included). Expect up to approximately 7 hours burn time depending on mode and conditions. The green LED remains lit during charging and goes out when charging is complete.

Is this answer helpful?

A

No. The Micro-USB connection is for charging only; it cannot be used as a power output to charge other devices or power external equipment.

Is this answer helpful?

A

When the sensor detects negative acceleration (deceleration), an additional red LED briefly lights (around 3 seconds) to signal braking or slowing, supplementing the constant tail light for improved visibility to following traffic.

Is this answer helpful?

A

Cycle Parts GmbH declares CE and RoHS conformity for the Eco Light Red Plus. The CE declaration and related documentation are available online at ce.cycleparts.de/ecolightredplus.

Is this answer helpful?

M: OA-GPT-5-NAN

Advantages and Disadvantages

Advantages

  • Sensor-controlled, self-calibrating negative-acceleration rear light improves visibility during braking.
  • Rechargeable Li-ion battery with Micro-USB charging offers up to 7 hours burn time and convenient recharging.
  • Simple O-ring mounting (10–32 mm) enables tool-free installation and adjustable fit for most seatposts.
  • Clear battery and calibration LED indicators provide straightforward status feedback during use and charging.
  • CE and RoHS conformity ensures compliance with EU safety and environmental requirements.
VS

Disadvantages

  • LEDs are not replaceable; any LED failure requires replacement of the entire unit.
  • Micro-USB port is charge-only—no power output to charge other devices.
  • Charger not included; requires DC 5 V / max. 1 A adapter purchased separately.
  • Must be mounted on non-movable parts and within specific height range, limiting some installation options.
  • Sealing must be correctly closed after charging to maintain waterproofing; user oversight can cause issues.
M: OA-GPT-5-NAN

Product Specification

Type

Lighting set

Colors

black, white, red

Max. light output

60 lux

Min. light output

15 lux

Max. runtime

12 hr

Min. runtime

3 hr

Light mode

Continuous light (3 levels)

Power supply

Rechargeable battery

Mounting

Strap

Special features

USB port, brake light compatible, StVZO compliant

M: OA-GPT-54-NAN

Product Description

VDO Cycle Parts Eco Light M60 + Red Plus Front light Manual

The VDO Cycle Parts Eco Light M60 paired with the Red Plus front light is a compact, sensor-driven lighting solution designed for everyday cyclists who want reliable visibility and modern charging convenience. Both units prioritize safety: the Red Plus rear light features a self-calibrating negative-acceleration (brake) function that lights additional LEDs briefly when deceleration is detected, while the Eco Light M60 offers steady, efficient illumination powered by a rechargeable Li-ion battery and charged via Micro-USB.

Product highlights and design

The Red Plus rear light mounts on seatposts (10–32 mm) using O-rings sized to prevent slippage and must not be attached to moving or adjustable parts. It calibrates on power-up—indicated by a green LED for about three seconds—and requires the bike to be horizontal during calibration. The unit provides a constant tail light plus a momentary boost on negative acceleration: one click toggles constant light with the negative-acceleration function; another click switches it off. The LEDs are not replaceable; a failed LED requires replacement of the entire light.

The Eco Light M60 is built for straightforward use: a USB Li-ion battery gives up to seven hours of burn time and a visibility range up to 500 m (depending on conditions). Charging uses a DC 5 V / max. 1 A charger (not included). The device is sealed and includes a marked sealing area that must be closed after charging to preserve waterproofing and function. Energy cannot be drawn from the Micro-USB port; it is strictly for charging.

Practical use and safety notes

Installation guidance emphasizes alignment: the reference axis of the rear light should be parallel to the roadway and bike longitudinal axis. The Red Plus must be mounted at a recommended height between 250 and 1,200 mm. During charging the green indicator LED remains lit; when charging completes the indicator goes out. If the red battery LED appears, recharge immediately. The light distribution must never be covered. CE and RoHS conformity is declared by Cycle Parts GmbH; CE documentation is available online.

Final thoughts

Together the Eco Light M60 and Red Plus rear light form a dependable, easy-to-install lighting set that focuses on rider visibility, battery convenience, and an intelligent braking indicator. They suit commuters and recreational riders who want low-maintenance, regulation-compliant lighting.

Notes

  • Always ensure the sealing cap is fully closed after charging.
  • Do not mount on movable saddle parts; choose proper O-ring size to prevent slipping.
  • LEDs are non-serviceable—replace the unit if any LED fails.
  • Use a DC 5 V / max. 1 A charger; charger not included.
  • Keep the light’s beam unobstructed for correct operation.
M: OA-GPT-5-NAN

© Copyright 2026 Manual.ly