Manual.ly Logo

Telwin Pulse 30 Manual

0.0 · 0 Ratings

PDF manual · 88 Pages

English

M: QW-35-FL
page

/ 88

Loading...
ca7088bcbae659ae0104483e5951c2f16b35 page 5
- 5 -
EN
WARNING: BEFORE USING THE BATTERY CHARGER
READ THE INSTRUCTION MANUAL CAREFULLY.
1. GENERAL SAFETY RULES FOR THE USE
- Avoid contact with battery acid. Should an operator
be sprayed or come into contact with the acid, rinse
the relative parts immediately under clean running
water. Continue to rinse the area until the physician
arrives.
- During the charge the battery produces explosive
gases, avoid the formation of ames and sparkes.
DO NOT SMOKE.
- Position the batteries to be charged in a well-
ventilated place.
- Protect the eyes. Always wear protective goggles
when using acid lead accumulators.
- Always wear suitable clothing. Never wear baggy
clothing or jewellery that can get caught up in
moving parts. During all operations, electrically
insulated protection clothing and non-slip boots
must be worn at all times. Persons with long hair
must tie it back and wear a hair net.
- Inexperience and untrained people should be
properly instructed before using the appliance.
- This appliance can be used by children aged from 8
years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience
and knowledge if they have been given supervision
or instruction concerning use of the appliance in a
safe way and understand the hazards involved.
- Children shall not play with the appliance.
- Cleaning and user maintenance shall not be made
by children without supervision.
- Use the battery charger only indoors and make sure
that you start it in airy places. DO NOT SET IN THE
RAIN OR SNOW.
- Disconnect the mains cable before connecting to or
disconnecting the charging cables from the battery.
- Do not connect or disconnect the clamps to or from
the battery with the battery charger operating.
- Never use the battery charger inside the car or in the
bonnet.
- Substitute the mains cable only with an original one.
- If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly
qualied persons in order to avoid a hazard.
- Do not use the battery charger to charge batteries
which are not rechargeable.
- Make sure the available power supply voltage
corresponds to that shown on the battery charger
rating plate.
- To prevent damaging the vehicle electronics,
scrupulously respect the warnings given by the
producer of the vehicle or the batteries used.
- This battery charger has components such as
switches and relays which can cause arcs or sparks.
Therefore when using it in a garage or in a similar
place set the battery charger in a suitable case.
- Repair or maintenance of the inside of the battery
charger can be executed only by skilled technicians.
- WARNING: ALWAYS DISCONNECT THE POWER
SUPPLY CABLE FROM THE MAINS BEFORE
CARRYING OUT ANY SIMPLE MAINTENANCE
OPERATION ON THE BATTERY CHARGER.
- The battery charger is protected from indirect
contact by an earth wire as indicated for class I
equipment. Make sure the power outlet is protected
by an earth connection.
- In models without this element, connect plugs
of appropriate capacity, not below the fuse value
indicated on the rating plate.
- Class A device:
This battery charger complies with the requirements
of the technical standard for products to be used
in industrial environments and for professional
purposes. No compliance with the electromagnetic
compatibility in domestic use buildings is guaranteed
and those connected directly to a low voltage power
supply network that furnishes buildings designated to
domestic use.
2. GENERAL DESCRIPTION
Battery charger indicated for charging WET, GEL, AGM,
PbCa lead batteries used by motorised vehicles (petrol and
diesel) and electric vehicles: automobiles, motor vehicles,
motorcycles, boats, etc. It is possible to charge 6V, 12V and
24V batteries; the 50 model also has a starter aid mode (for
vehicles with petrol and diesel engines only).
Rechargeable batteries according to the output voltage
available: 6V / 3 cells; 12V / 6 cells; 24V / 12 cells.
3. INSTALLATION
3.1 BATTERY CHARGER POSITION
When running, position the battery charger in a stable
position and make sure the air ow through the openings
which guarantee required ventilation is not blocked.
3.2 CONNECTION TO THE MAINS
- The battery charger must only be connected to a power
supply system with neutral conductor connected to
earth.
- Check that the mains voltage is the same as the battery
charger voltage indicated on the rating plate.
- The power line must have a protection system, such as
fuses or circuit breakers, that can support the maximum
apparatus absorption.
- Use the relative power cable when connecting to the
mains.
- Any power cable extensions must be of suitable section
size, never lower than that of the supplied power cable.
- It is always compulsory to connect the device to the
grounding system, using the yellow-green wire in the
power cable identied with the label (
), whilst the other
two wires must be connected to the phase and neutral
conductors on the mains power supply.
4. OPERATING DURING CHARGING
N.B.: Before charging, make sure the capacity (Ah)
of the battery to be charged is not lower than that
indicated on the battery charger rating plate (Cmin).
Follow the instructions scrupulously in the order given
below.
4.1 BATTERY PREPARATION
If the battery to be charged is the WET type, the procedure
is as follows:
The documentation can be downloaded in PDF version from
the link: www.telwin.com/usermanual

Chat with your Telwin Pulse 30 manual using AI

Get instant AI answers from your Telwin Pulse 30 manual

Ask anything about the Telwin Pulse 30. Answers come from this manual, with the pages they are based on.

Ask a Question

0/1000

Do you recommend Pulse 30?

Yes No

Frequently Asked Questions

A

This charger is designed for lead-acid batteries including Wet, Gel, AGM, and PbCa types. It works with various vehicles like cars, motorcycles, and boats.

Is this answer helpful?

A

Yes, you can charge multiple batteries simultaneously using series or parallel connections, but they must match in voltage or capacity depending on the configuration.

Is this answer helpful?

A

No, the starter aid mode is only available on the 50 version of the unit and is intended for vehicles with petrol and diesel engines.

Is this answer helpful?

A

You must wear protective goggles, electrically insulated clothing, and non-slip boots. Long hair should be tied back, and loose jewelry should be removed.

Is this answer helpful?

A

Place the charger in a stable, well-ventilated indoor area. Never use it in rain, snow, or inside a car bonnet.

Is this answer helpful?

A

Connect the red clamp to the positive terminal first, then the black clamp to the vehicle chassis or negative terminal away from the fuel pipe.

Is this answer helpful?

M: QW-35-FL

Advantages and Disadvantages

Advantages

  • Supports multiple battery types including Wet, Gel, AGM, and PbCa
  • Versatile voltage options covering 6V, 12V, and 24V systems
  • Includes a starter aid mode for quick engine assistance on compatible models
VS

Disadvantages

  • Requires careful adherence to safety protocols regarding ventilation and PPE
  • Not suitable for non-rechargeable batteries or vehicles without batteries attached
  • Must be used indoors in dry conditions to prevent water damage
M: QW-35-FL

Product Specification

Suitable for

AGM, Lead, EFB, Gel

Battery voltage

6V, 12V, 24V

Max charging current

25A

Battery capacity

5-400Ah

Display

LED

Color

red, black

Dimensions

13x4x6.3in (WxHxD)

Weight

7.28lbs

M: QW-35-FL

Product Description

Telwin Pulse 30: The Ultimate Multi-Function Battery Charger

The Telwin Pulse 30 stands as a robust solution for maintaining and reviving lead-acid batteries across a wide range of vehicles. Designed for both professional mechanics and DIY enthusiasts, this charger supports wet, gel, AGM, and PbCa battery types commonly found in cars, motorcycles, boats, and other motorized equipment. Whether you need to charge a standard 6V, 12V, or 24V battery, the Telwin Pulse 30 Manual provides clear guidance on how to maximize performance while ensuring safety.

Safety is at the forefront of the Telwin Pulse 30 design. The device adheres to strict general safety rules that prevent accidents during operation. Users are advised to work in well-ventilated areas to avoid exposure to explosive gases generated during charging. Essential protective gear, such as insulated clothing, non-slip boots, and safety goggles, is mandatory when handling acid lead accumulators. The manual emphasizes never smoking near the unit and avoiding contact with corrosive electrolytes. For added protection, the charger includes features to prevent electric shock and ensures proper grounding to protect against indirect contact hazards.

Installation and operation are straightforward when following the provided instructions. The unit must be placed in a stable position where air can flow freely through ventilation openings. Connection to the mains requires a dedicated power supply with appropriate fuses and a secure earth connection. The red clamp connects to the positive terminal, while the black clamp attaches to the vehicle chassis or negative terminal, ensuring correct polarity to avoid damage to sensitive vehicle electronics. The charger also supports simultaneous charging of multiple batteries using series or parallel configurations, provided voltage and capacity requirements are met.

For users needing quick assistance, the model 50 version includes a starter aid mode. This feature allows for a rapid 10 to 15-minute charge to help jump-start vehicles with petrol or diesel engines. However, caution is required; if the engine does not start after repeated attempts, further use should be stopped to prevent battery or electrical system damage. Always ensure the battery is connected before attempting to start the vehicle to avoid overvoltage spikes.

Maintenance tips included in the documentation suggest cleaning terminals to remove oxide deposits for better clamp contact. If the battery is permanently installed in a vehicle, consulting the vehicle's specific maintenance manual is recommended. The Telwin Pulse 30 is built for durability and reliability, making it an essential tool for anyone who values their vehicle's electrical health.

M: QW-35-FL

© Copyright 2026 Manual.ly