Manual.ly Logo

Schutte Ocean Manual

0.0 · 0 Ratings

PDF manual · 37 Pages

English

M: OA-GPT-5-NAN
page

/ 37

Loading...
c41186401d8f525366312361e78621c67c05 page 9
9
• Warning - risk of electrocution! Make sure that there
are no electrical power lines where you are drilling before
starting to drill holes.
Installation Instructions
• Check all connections carefully after rst-time use to make
sure that they are tight.
• We do not assume any warranty for incorrect installation -
in particular for subsequent damages!
Shower settings
Use the diverter to set which shower mode is activated
(overhead shower or hand shower).
The slope of the overhead shower can be set as desired by
the user.
Instructions for care
Sanitary taps require special care. Therefore, please observe
the following instructions:
• Chrome-plated surfaces are sensitive to lime-dissolving
agents, acidic cleaning agents and all kinds of abrasives.
• Never clean coloured surfaces with abrasive, corrosive, or
alcoholic agents.
• Only clean your taps with clear water and a soft cloth or a
shammy.
Maintenance
• Please observe that the upper part of the valve and the
thermostat element are wear parts, and that these may
have to be replaced in case of hard water or dirty water
every 1-2 years.
• Please check all joints and connections for leaks or visible
damages at regular intervals.
• In case of any leaks or visible damages to the tting or con-
nection hoses, these should be immediately checked by a
specialist and replaced if necessary.
Decommissioning
• Cut o the water supply before dismantling the product.
• Pay attention to escaping residual water.
• Disassemble the product in the reverse order of the as-
sembly instructions.
Disposal
Your washbasin tap is delivered in a solid packaging, in or-
der to protect it against transport damages. The packaging
consists of recyclable materials. Dispose it in an environ-
mentally suitable manner.
Do not throw the product into the normal domestic waste at
the end of its service life, but ask your municipal administra-
tion about the possibility of an environmentally friendly
disposal.
The illustrations are to be considered as gurative
representations, deviations of the product are possible.
Subject to technical modications.
WARRANTY CARD
The Franz Joseph Schütte GmbH, based in Wallenhorst, shall
take on a manufacturer’s warranty for the product you have
procured in accordance with the warranty conditions stated
below.
Your legal warranty claims from the purchase contract with
the seller and your legal rights shall not be limited by this
warranty.
Warranty conditions:
1. Scope of warranty
The Franz Joseph Schütte GmbH shall grant a warranty
for proper material qualities and material processing in
accordance with the intended purpose as well as profes-
sional assembly, tightness and function. The warranty shall
only apply for the country in which the product has been
procured.
Included within the scope of the warranty is a guarantee,
reduced to 1 year, for the durability of non-high-gloss
chrome-plated surfaces, such as bronzed or coloured
surfaces.
Excluded from the warranty are the following:
• Damages due to improper assembly, commissioning and
handling
• Valves
• Damages due to external inuences such as re, water and
chemical inuences
• Mechanical damage due to accidents, falls or impacts
• Negligent or intentional destruction
• Normal wear or poor maintenance
• Damages due to repairs by unqualied persons
• Improper handling, insucient care and use of unsuitable
cleaning agents
• Chemical or mechanical inuences during transport, stor-
age, connection, repair and use of the product
2. Warranty service
The warranty performance refers, depending on our choice,
to repairs conducted free of charge, the free delivery of
spare parts or a product of the same quality on return of the
decient part or product. If the type concerned is longer
produced, we reserve the right to deliver a replacement
product from our range which is as similar as possible to the
returned type.
Replaced products or parts are transferred into our property.
On returning the product, the purchaser shall bear the costs
of transportation and the transport risk if this does not con-
cern a warranty case in accordance with the legal warranty
regulations. In the latter case, we shall reimburse the costs
of transportation.
The reimbursement of expenses for deinstallation and
installation, inspection, claims due to lost prot and for
damages are excluded from the warranty, as are any further
claims for damages and losses of whatever kind which are
caused through the product or its use.
3. Assertion of the warranty claim
The warranty claim must be asserted within the warranty
period with the submission of the original receipt of pur-
chase to Franz Joseph Schütte GmbH, Hullerweg 1, 49134
Wallenhorst.
4. Warranty period
The warranty period is always of the duration stated on the
label or the packaging of each individual product. Should no
specic warranty be stated for a specic product, this always
totals 2 years from the data of purchase, whereby the date

Chat with your Schutte Ocean manual using AI

Get instant AI answers from your Schutte Ocean manual

Ask anything about the Schutte Ocean. Answers come from this manual, with the pages they are based on.

Ocean Maintenance Schedule

Remind me when maintenance is due
Semiannual
Check connections for leaks and damage

Inspect all connections and joints at regular intervals for tightness or visible damage.

Yearly
Replace valve upper part and thermostat element

If water is very hard or dirty, replace the valve upper part and thermostat element every 1-2 years as they are wear parts.

Free maintenance reminders

Timed to your purchase date. Always free, unsubscribe anytime.

By submitting you agree to the privacy policy. Unsubscribe with one click in any email.
M: QW-35-FL

Ask a Question

0/1000

Do you recommend Ocean?

Yes No

Frequently Asked Questions

A

The system is suitable for instantaneous (flow) water heaters. It is not suitable for low-pressure water heaters or open electric storage heaters. If unsure, check your heater type or consult a qualified installer.

Is this answer helpful?

A

Yes. The manufacturer recommends installation by qualified personnel. Professional installation helps ensure correct sealing, prevents water damage, and preserves warranty coverage.

Is this answer helpful?

A

Clean only with clear water and a soft cloth. Avoid lime-dissolving agents, acidic cleaners, abrasive products and alcohol-based cleaners to prevent surface damage and preserve the finish.

Is this answer helpful?

A

Regularly check all connections for leaks or visible damage. Replace seals, the valve top and the thermostat element as wear parts when needed—typically every 1–2 years in hard or dirty water. Install filters to reduce debris ingress.

Is this answer helpful?

A

Shut off the water supply and drain the shower system if ambient temperatures may fall below 0 °C to avoid frost damage. Ensure the installation location is frost-protected whenever possible.

Is this answer helpful?

A

Yes. Franz Joseph Schütte GmbH provides a manufacturer’s warranty covering material and workmanship per the terms on the packaging and warranty card. Warranty exclusions include incorrect installation, normal wear, external damage, and repairs by unqualified persons.

Is this answer helpful?

A

Yes. The integrated diverter allows easy switching between the overhead shower and the hand shower. The overhead shower angle is also adjustable for personal preference.

Is this answer helpful?

M: OA-GPT-5-NAN

Advantages and Disadvantages

Advantages

  • Thermostatic valve reduces scald risk and stabilizes temperature for safer showers.
  • Adjustable overhead shower angle and hand shower give flexible, comfortable coverage.
  • Durable chrome/anthracite finish offers a modern look that complements many bathrooms.
  • Includes glass shelf for convenient storage of shower essentials.
  • Recommendation for filters protects cartridge and extends component life.
VS

Disadvantages

  • Not compatible with low-pressure or open storage water heaters.
  • Seals, valve top and thermostat element are wear parts and may need replacement every 1–2 years in hard water.
  • Professional installation is recommended; incorrect mounting can void warranty and cause water damage.
  • Chromed surfaces are sensitive to acidic or abrasive cleaners and require careful maintenance.
  • Must be drained and shut off in freezing conditions to avoid frost damage.
M: OA-GPT-5-NAN

Product Specification

Material

Plastic, Metal

Color

chrome, grey

Mounting type

Surface mounted, 3 hole

Height

31.50 in

Projection

16.73 in

Spout

Hand shower (3 spray types), square rain shower (11.81x11.81 in)

Operation

2-way control unit, integrated thermostat, 2 levers (1 function, 1 flow regulator)

Special features

Diverter head shower/hand shower, integrated shelf, shower rail, shower holder, anti-limescale system

M: OA-GPT-54-NAN

Product Description

Schütte Ocean Duschsystem chrom/anthrazit Manual

The Schütte Ocean shower system in chrome/anthracite blends modern design with practical functionality. Built for domestic use with instantaneous water heaters, this overhead shower set includes a thermostat valve, hand shower and glass shelf, offering a premium bathing experience while focusing on safety and longevity.

Design and Features

Finished in high-contrast chrome and anthracite, the system pairs a large adjustable overhead shower with a flexible hand shower. The thermostat armature maintains water temperature and reduces scald risk. The diverter lets you switch between overhead and hand showers, while the overhead head angle is user-adjustable for targeted coverage. A tempered glass shelf provides convenient storage for shower essentials.

Installation and Suitability

Intended for use in private households and rooms above freezing, the system is suitable for instantaneous (flow) water heaters but not for low-pressure or open storage heaters. Mounting should be performed by qualified personnel. The product ships with fixings for typical solid masonry; appropriate anchors should be chosen for other wall types. Filters or angle valves with filters are recommended to protect the cartridge from debris.

Safety and Maintenance

Before installation, shut off the main water supply and check that seals are seated correctly to avoid leaks. Beware of hidden pipes and electrical lines when drilling. Chromed surfaces are sensitive to acidic, abrasive or lime-dissolving cleaners; clean only with clear water and a soft cloth. Seals, the valve top and the thermostat cartridge are wear parts and may need replacement every 1–2 years in hard or dirty water. Inspect connections regularly and have any leaks or damage handled by a professional.

Warranty and Service

The manufacturer provides a warranty that covers material and workmanship and ensures function and tightness; terms vary by country and surface finish. Damage from improper installation, external influences, normal wear, or repairs by unqualified persons is excluded. Warranty claims require the original proof of purchase and must be filed within the specified warranty period.

Practical Tips

  • Install a filter or filtered angle valves to protect internal parts.
  • Drain the system and shut off water when temperatures fall below 0 °C to prevent frost damage.
  • Avoid corrosive or abrasive cleaning agents to preserve finish and function.

Notes:

  • Not suitable for low-pressure or open electric storage heaters.
  • Professional installation preserves warranty and prevents water damage.
  • Keep the original purchase receipt for warranty claims.
M: OA-GPT-5-NAN

© Copyright 2026 Manual.ly