Guidance and manufacturer’s declaration – electromagnetic immunity
The SFT08 is intended for use in the electromagnetic environment specified below. The customer or the user of the SFT08 should assure that it is used in such an environment.
Immunity testIEC 60601 test levelCompliance levelElectromagnetic environment – guidance
Electrostatic discharge (ESD)
IEC 61000-4-2
6 kV contact
8 kV air
6 kV contact
8 kV air
Floors should be wood, concrete or ceramic tile. If floors are covered with synthetic material, the relative humidity should be at least 30 %.
Electrical fast transient/burst
IEC 61000-4-4
2 kV for power supply lines
1 kV for input/output lines
Not applicable
Mains power quality should be that of a typical commercial or hospital environment.
Surge
IEC 61000-4-5
1 kV line(s) to line(s)
2 kV line(s) to earth
Not applicable
Mains power quality should be that of a typical commercial or hospital environment.
interruptions and voltage variations on
power supply input lines
IEC 61000-4-11
< 5 % UT (> 95 % dip in UT) for 0,5 cycle
40 % UT (60 % dip in UT) for 5 cycles
70 % UT (30 % dip in UT) for 25 cycles
< 5 % UT (> 95 % dip in UT) for 5 sec
Not applicable
Mains power quality should be that of a typical commercial or hospital environment. If the user of the SFT08 requires continued operation during
power mains interruptions, it is recommended that the SFT08 be powered from an uninterruptible power supply or a battery.
Power frequency (50/60 Hz)
magnetic field IEC 61000-4-8
3 A/m, 50/60Hz3 A/m
Power frequency magnetic fields should be at levels characteristic of a typical location in a typical commercial or hospital environment.
NOTEU
T
is the a.c. mains voltage prior to application of the test level.
Table 4
Recommended separation distances between portable and mobile RF communications equipment and the ME EQUIPMENT or ME SYSTEM
The SFT08 is intended for use in an electromagnetic environment in which radiated RF disturbances are controlled. The customer or the user of the SFT08 can help prevent electromagnetic interference by maintaining a minimum distance between portable and
mobile RF communications equipment (transmitters) and the SFT08 as recommended below, according to the maximum output power of the communications equipment.
Rated maximum output power
of transmitter
(W)
Separation distance according to frequency of transmitter
(m)
150 kHz to 80 MHz
d = 1,2
80 MHz to 800 MHz
d = 1,2
800 MHz to 2,5 GHz
d = 2,3
0,010,120,120,23
0,10,380,380,73
11,21,22,3
103,83,87,3
100121223
For transmitters rated at a maximum output power not listed above, the recommended separation distance d in meters (m) can be estimated using the equation applicable to the frequency of the transmitter, where P is the maximum output power rating of the trans
-
mitter in watts (W) according to the transmitter manufacturer.
NOTE 1At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.
NOTE 2These guidelines may not apply in all situations. Electromagnetic propagation is aected by absorption and reflection from structures, objects and people.
dauer trotz Signalton eingehalten werden. Werden Temperatu-
ren über 37,8 °C (100 °F) gemessen, ertönt ein Fieberalarm
(kurze Pieptöne – 10 Sekunden lang.) Werden Temperaturen
über 42,9 °C (109,2 °F) gemessen, so erscheint das Symbol für
„Hi °C“ („Hi °F“). Zur Verlängerung der Batterielebensdauer
schalten Sie bitte nach der Messung das Thermometer durch
kurzes Drücken der EIN/AUS-Taste aus. Ansonsten schaltet
sich das Thermometer nach ca. 10 Min. automatisch ab.
Speicher
Der letzte Messwert wird automatisch gespeichert. Um diesen
Wert anzuzeigen drücken Sie die EIN/ AUS- Taste. Zunächst
führt das Thermometer einen Selbsttest durch. Danach er
-
scheint der zuletzt gespeicherte Messwert für ca. 2 Sek. An-
schließend wird der Referenzwert von 37 °C (98,6 °F) und „Lo“
im Display angezeigt. Das Thermometer ist Messbereit und der
alte gespeicherte Messwert wird automatisch durch den neuen
Messwert ersetzt.
Messeinheit ändern
Sie können sich die Temperatur in Grad Celsius (°C) und Grad
Fahrenheit (°F) anzeigen lassen. Zum Einstellen halten Sie die
EIN/AUS-Taste beim Einschalten länger als 2 Sekunden ge
-
drückt bis sich die Messeinheit ändert. Der gespeicherte Wert
wird in der neuen Messeinheit angezeigt.
Batterienwechsel
Das Fieberthermometer enthält eine Langzeit Alkali-Mangan-
Batterie (LR41, 1,5 V),für ca. 2 Jahre. Die Batterie muss ge
-
wechselt werden, wenn „T” am rechten, unteren Rand
erscheint. Drücken Sie den Batteriefachdeckel am Ende des
Gerätes mit den Fingern zusammen und ziehen Sie ihn kräftig
nach hinten weg. Entnehmen Sie die alte Batterie und ersetzen
Sie diese durch eine Batterie gleichen Typs. Das +Zeichen auf
der Batterie muss nach oben zeigen. Stecken Sie anschließend
den Batterie fachdeckel auf das Gehäuse auf.
Die verbrauchten, vollkommen entladenen Batterien müssen
Sie über speziell gekennzeichnete Sammelbehälter, Sonder
-
müllannahmestellen oder über den Elektrohändler entsorgen.
Sie sind gesetzlich dazu verpflichtet, die Batterien zu entsor
It is used to measure human body temperature at home or in everyday care. The thermometer is intended only for body temperature checks and supports practical monitoring for adults, children, and patients who need gentle handling.
Is this answer helpful?
A
Rectal measurement is described as the most reliable and accurate method. Oral measurement is also usable, while axillary measurement is less precise and generally not recommended when exact results are important.
Is this answer helpful?
A
Yes. When temperature rises above the alarm threshold, the device emits a short fever warning signal. It also shows a high-temperature indication when readings become unusually elevated, helping users notice potential illness quickly.
Is this answer helpful?
A
Yes. The thermometer is waterproof and can be cleaned or disinfected with water or suitable disinfectant. It should never be boiled, and only approved cleaning agents should be used to avoid damage.
Is this answer helpful?
A
Yes. The last measured value is stored automatically in memory. You can recall it by pressing the power button, which is useful for comparing readings over time or sharing results with a doctor.
Is this answer helpful?
A
The thermometer uses an LR41 1.5 V battery. The battery should be replaced when the low-battery indicator appears, and used batteries should be disposed of properly through approved collection points.
Is this answer helpful?
M: OA-GPT-54-NAN
Advantagesand
Disadvantages
Advantages
Flexible measuring tip improves comfort and safety, especially for children or sleeping users.
Supports rectal, oral, and axillary measurement for more practical everyday use.
Clear display with Celsius/Fahrenheit switching, memory, and fever alarm functions.
Waterproof design makes cleaning and disinfection simple after each use.
VS
Disadvantages
Axillary measurement is less accurate and not recommended as the main method.
Requires careful handling; it should not be bent beyond 90° or exposed to heat.
Uses a specific LR41 battery, so replacement is needed after long-term use.
M: OA-GPT-54-NAN
Product
Specification
Type
digital stick thermometer
Operating mode
Battery operated (1x button cell)
Application
in the mouth (oral), in the armpit (axillary), in the rectum (rectal)
Sanitas SFT 08 Manual: A Practical Digital Thermometer for Everyday Health Checks
The Sanitas SFT 08 is designed for users who want a simple, reliable way to monitor body temperature at home. Built as a compact clinical thermometer, it focuses on ease of use, quick feedback, and dependable readings across several measurement methods. Its flexible measuring tip adds comfort, especially for children, sleeping patients, and anyone who needs a gentler fit during use.
One of the strongest points of the SFT 08 is its versatility. It supports rectal, oral, and axillary measurement, giving users options depending on age, comfort, and situation. The rectal method is presented as the most accurate, while oral use offers a balanced everyday choice. The device also includes a fever alarm, memory function, and a clear display that can switch between Celsius and Fahrenheit, making it easy to read and compare results.
The thermometer is built with practical daily care in mind. It is waterproof, so cleaning and disinfection are straightforward after each use. The included self-test helps confirm that the unit is working properly when powered on, while the automatic shutoff helps preserve battery life. A single LR41 battery is included, and the thermometer is intended to be lightweight, portable, and ready for repeated home use.
Safety is a major theme throughout the product design. The SFT 08 should only be used for human body temperature, and the manual emphasizes careful handling, especially around children. It should also be kept away from strong electromagnetic fields and protected from damage, heat, and direct sunlight. These details make it clear that the thermometer is built for responsible home monitoring rather than rough or casual treatment.
Overall, the Sanitas SFT 08 Manual reflects a device that is small in size but strong in usefulness. It combines comfort, accuracy, and simple operation into one compact thermometer that fits well into family health routines.
Notes
Best accuracy is achieved with rectal measurement.
Oral readings are useful, but axillary readings are less precise.
Clean and disinfect before and after use.
Store the thermometer in its protective case when not in use.