Manual.ly Logo

Mackie ShowBox Manual

0.0 · 0 Ratings

PDF manual · 51 Pages

English

M: OA-GPT-5-NAN
page

/ 51

Loading...
ee3a60eadd6e40c9299ee839d29381aff29b page 21
SHOWBOX BATTERY POWERED ALL-IN-ONE PERFORMANCE RIG WITH BREAKAWAY MIX CONTROL
33
AC Power
Be sure the ShowBox is plugged into an outlet that is able to supply the correct voltage. It will continue to operate at lower
voltages, but will not reach full power. Be sure the electrical service can supply enough amperage for all the components
connected to it.
We recommend that a sti (robust) supply of AC power be used because the amplifiers place high current demands
on the AC line. The more power that is available on the line, the louder the speaker will play and the more peak output
power will be available for a cleaner, punchier bass. A suspected problem of “poor bass performance” is ofen caused
by a weak AC supply to the amplifiers.
Never remove the ground pin on the power cord or any other component of the ShowBox. This is very dangerous.
Care and Maintenance
Your ShowBox will provide many years of reliable service if you follow these guidelines:
• Avoid exposing it to moisture. If it is set up outdoors, be sure it is under cover if rain is expected.
• Avoid exposure to extreme cold (below freezing temperatures). If you must operate in a cold environment, warm up
the voice coils slowly by sending a low-level signal through them for about 5 minutes prior to high-power operation.
• Use a dry cloth to clean the cabinet. Only do this when the power is turned o. Avoid getting moisture into any
of the openings of the cabinet, particularly where the drivers are located.

Chat with your Mackie ShowBox manual using AI

Get instant AI answers from your Mackie ShowBox manual

Ask anything about the Mackie ShowBox. Answers come from this manual, with the pages they are based on.

ShowBox Maintenance Schedule

Before use in cold
Warm up voice coils

If operating in cold environments below freezing, send a low-level signal for about 15 minutes prior to high-power operation.

Show in the manual (page 33)
As needed
Clean cabinet with dry cloth

Use a dry cloth only when the power is turned off. Avoid getting moisture into any openings, particularly near drivers.

Show in the manual (page 33)
M: QW-35-FL

Ask a Question

0/1000

Do you recommend ShowBox?

Yes No

Frequently Asked Questions

A

Yes. ShowBox records a stereo mix of all inputs to a microSD card as 24-bit/48 kHz WAV files and can stream a stereo mix via USB-C to a computer or mobile device for live streaming or DAW recording.

Is this answer helpful?

A

The breakaway mixer connects to the ShowBox with the included CAT5 cable. It provides per-channel gain/volume, EQ, compressor, FX, looper controls, snapshots, headphone level and main mute. It can be docked or mounted to a mic stand using the supplied mount.

Is this answer helpful?

A

Amp/PA voicing adjusts the overall tonal balance for instrument/amp-style sound or a PA-style profile; Outdoor mode compensates frequency response for open-air venues to preserve perceived balance and increases front-panel LED brightness.

Is this answer helpful?

A

The FX send provides a post-preamp, pre-channel-fader signal to pedals; return brings the processed signal back into the external FX mix bus. Use the channel’s external FX knob to set the wet level and retain pedal tone without preamp distortion.

Is this answer helpful?

A

The multi-band feedback eliminator automatically places up to eight notch filters to remove offending frequencies and maximize gain-before-feedback. Engage it when you encounter feedback or in venues where an engineer isn’t present.

Is this answer helpful?

A

Battery life varies with usage but roughly supports mobile gigs (manufacturer lists up to ~12 hours). The internal lithium-ion battery charges while the ShowBox is plugged into AC; remove and replace via the bottom compartment following safety instructions.

Is this answer helpful?

A

Yes. A two-button footswitch connected to the 1/4" TRS jack controls looper transport (left button) and FX mute (right button), making hands-free looping and FX control possible while performing.

Is this answer helpful?

M: OA-GPT-5-NAN

Advantages and Disadvantages

Advantages

  • Portable, battery-powered all-in-one PA and instrument amp with up to ~12 hours playtime
  • Breakaway mixer provides hands-on channel control, FX selection, looper, snapshots and tuner
  • Comprehensive I/O: XLR mic preamps, Hi-Z instrument jacks, stereo line, Bluetooth, external FX loop
  • Built-in looper, multi-engine FX (serial and parallel), compressor and 3-band EQ per channel
  • USB-C and microSD recording support for streaming and capturing 24-bit/48 kHz WAV files
VS

Disadvantages

  • FX2 processing limited to paired channels (parallel) due to processing constraints
  • Looper recordings are mono and cannot be included in snapshots or edited after recording
  • USB-C is audio-only and not a power source; separate charging/power still required for the unit
  • MicroSD reliability depends on card speed/class; older cards may drop recordings
  • No fly-points — unit cannot be flown and must be pole- or floor-mounted with appropriate hardware
M: OA-GPT-5-NAN

Product Specification

Principle

2-way

Tweeter

1x 1 in

Woofer

1x 8 in

Frequency Range

55 Hz-20 kHz (-3 dB)

Power

400 W Peak

Audio Connections

Stereo Line In (0.25 in jack), 2x Mic In (XLR), Line In (0.25 in jack), 2x Instrument In (0.25 in jack), Line Out (0.25 in jack), Line Out (XLR), Headphones (0.25 in jack)

Other Connections

1x USB-C 3.1, Card reader (microSD), Footswitch

Wireless

Bluetooth 5.1

Power Supply

Li-ion battery (12 h, 5200 mAh), Mains operation

SPL max.

122 dB

Special Features

integrated effects, portable

Dimensions

11.81x19.69x9.80 in (WxHxD)

Weight

20.94 lb

Included

1x compact speaker

M: OA-GPT-54-NAN

Product Description

Mackie ShowBox — Portable All-in-One Performance Rig

Mackie ShowBox is a rugged, battery-powered all-in-one performance rig designed for solo performers, buskers, small bands, and streamers who need pro-quality sound without hauling separate amps, mixers, and interfaces. Lightweight and road-ready, ShowBox combines inputs for microphones, guitars, keyboards and line sources with integrated effects, a looper, tuner, and a detachable breakaway mixer you can mount on a mic stand. It also offers USB-C streaming/recording and microSD capture, making it ideal for live shows, rehearsals, and online performances.

What it offers

ShowBox features two XLR mic preamps, two high-impedance instrument inputs, a stereo line channel, Bluetooth streaming, and an aux input that can be used simultaneously. Each input gets a 3-band EQ, compressor (on channels 1–4), selectable FX engines (FX1 in series, FX2 in parallel), external FX send/return for pedals, and per-channel controls accessible from the breakaway mixer. The looper records up to minutes of mono audio at 48 kHz and can overdub; recordings can also be saved to a microSD card as 24-bit/48 kHz WAV files. The USB-C interface streams a 2-in/2-out stereo mix to and from computers and mobile devices for live streaming or direct recording.

ShowBox has two voicing modes (Amp/PA) and an Indoor/Outdoor mode to optimize tonal balance for the venue. A multi-band feedback eliminator automatically finds and notches feedback frequencies. Built-in protection includes limiting, over-excursion and thermal safeguards, and a user-replaceable lithium-ion battery that delivers portable operation and charges in-unit while plugged in. The breakaway mixer connects via an included CAT5 cable, provides hands-on control of gain, volume, EQ, compressor, FX, snapshots, loop controls, headphone volume and a main mute. A footswitch input supports looper and FX mute control.

Why performers like it

The ShowBox simplifies setup and reduces gear to a single, portable system while retaining versatile tone-shaping, effects, and recording options. It’s optimized for quick auto-gain setup, live performances in variable acoustic environments, and streaming/recording with minimal fuss.

Notes

  • MicroSD cards should be Class 10 or better and must be formatted before use for reliable recording.
  • USB-C is audio-only (24-bit/48 kHz); it does not power the unit.
  • Use the feedback eliminator and voicing modes to tame room issues; always set gain carefully to avoid clipping.
  • Headphone output does not mute the mains; use the main mute or lower main volume for phone-only monitoring.
  • Replace batteries only with equivalent types and follow safety instructions; do not expose battery to heat.
M: OA-GPT-5-NAN

© Copyright 2026 Manual.ly