Manual.ly Logo

Mackie EM-99B Manual

0.0 · 0 Ratings

PDF manual · 12 Pages

English

M: QW-35-FL
page

/ 12

Loading...
0521922620b98510e14cfd958ff1739d10b7 page 4
IMPORTANT SAFETY INSTRUCTIONS
. Read, follow, and keep these instructions. Heed all warnings.
2. Do not expose the microphone to extreme cold or heat.
3. Do not expose the microphone to rain, use it in water or in damp or wet conditions.
4. Do not expose the microphone to any excessive dust and other foreign particles.
5. Keep the microphone clean by washing outside with a dry cloth.
6. Keep the microphone stored when not in use.
7. Never attempt to disassemble the microphone.
8. Mackie cannot be held responsible for any damage caused by improper use
or modifications of the microphone.
9. This device complies with Part 5 of the FCC Rules [and contains license-exempt
transmitter(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada’s license-exempt RSS standard(s)].
Operation is subject to the following two conditions:
() This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme
aux CNR d’Innovation, Sciences et Développement économique Canada applicables
aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions
suivantes:
() L’appareil ne doit pas produire de brouillage, et
(2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d’en compromettre le fonctionnement.
0. NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 5 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Changes or modifications to this device not expressly approved by LOUD Audio,
LLC. could void the user’s authority to operate the equipment under FCC rules.
Canada ICES-003(B)/NMB-003(B)
Correct disposal of this product: This symbol indicates that this
product should not be disposed of with your household waste,
according to the WEEE directive (202/9/EU) and your national law.
This product should be handed over to an authorized collection site
for recycling waste electrical and electronic equipment (EEE).
Improper handling of this type of waste could have a possible negative
impact on the environment and human health due to potentially hazardous substances
that are generally associated with EEE. At the same time, your cooperation in the correct
disposal of this product will contribute to the effective usage of natural resources.
For more information about where you can drop off your waste equipment for recycling,
please contact your local city office, waste authority, or your household waste disposal
service.
INTRODUCTION
Elevate your voice to the big leagues with the Mackie
EM-99B Dynamic Broadcast Microphone.
This professional mic is built to deliver perfect sound
for podcasting, live streaming, and dialogue recording.
The highly sensitive cardioid capsule (-53dB) with a specially
tuned frequency response captures just the right amount
of detail and warmth.
Get a little excited on stream? No worries thanks
to a single-axis suspension that reduces vibration noise
while an internal pop filter reduces pops and plosives.
With an all-metal body, durable XLR connection, and robust
mount, the Built-Like-a-Tank™ EM-99B is built to last.
It even comes with a high-quality desktop stand,
so you are ready to record right out of the box.
FEATURES
CARDIOID DYNAMIC BROADCAST MICROPHONE
PROFESSIONAL XLR CONNECTION
NO POWER REQUIRED
HIGH SENSITIVITY (-53DB)
DIALOGUE OPTIMIZED FREQUENCY RESPONSE (50HZ–16KHZ)
SINGLE-AXIS SUSPENSION SUPPRESSES VIBRATIONS
INTERNAL FOAM POP FILTER
RUGGED, DURABLE METAL BODY
XLR CABLE INCLUDED
FOAM WINDSCREEN INCLUDED
WEIGHTED DESKTOP STAND INCLUDED
GETTING STARTED
If not using the included quick-release mic stand, start
on the paragraph below with the five asterisks (*****).
If using the included quick-release mic stand, begin by roating
the quick-release bar clockwise onto the base until snug.
The mic is attached to a rotatable suspension bar.
The suspension bar (and mic) should carefully be rotated
clockwise on top of the mic stand’s quick-release bar until
snug. [NOTE: the quick-release bar may be raised to help
keep the bar from spinning while tightening the mic to it.
Do so by squeezing (and holding) the handle
while simultaneously raising/lowering the bar.
Then tighten the mic to the stand].
Slide the foam windscreen over the mic to minimize wind
and other environmental noises for crystal clear indoor
or outdoor reception. Attach the included XLR cable
from the mic to the mixer and off you go!
*****If you are reading this, then the mic will either
be hand-held or (more likely) mounted on top of a mic stand
with a smaller-sized bolt than that of the included mic stand.
First, attach the slotted nut to the EM-99B by rotating
it clockwise until snug. [NOTE: if necessary, you may use
a coin, paperclip or similarly-shaped object to assist with the
tightening]. Next, the mic (with slotted nut) should carefully
be rotated clockwise on top of the mic stand until snug.
Slide the foam windscreen over the mic to minimize wind
and other environmental noises for crystal clear indoor
or outdoor reception. Attach the included XLR cable
from the mic to the mixer and off you go!

Chat with your Mackie EM-99B manual using AI

Get instant AI answers from your Mackie EM-99B manual

Ask anything about the Mackie EM-99B. Answers come from this manual, with the pages they are based on.

Ask a Question

0/1000

Do you recommend EM-99B?

Yes No

Frequently Asked Questions

A

No, it is a dynamic mic requiring no external power.

Is this answer helpful?

A

It ranges from 50 hz to 16 khz for dialogue optimization.

Is this answer helpful?

A

No, do not expose to rain or moisture.

Is this answer helpful?

A

Stand, XLR cable, windscreen, and slotted nut.

Is this answer helpful?

A

Wipe with a dry cloth, do not disassemble.

Is this answer helpful?

A

www.mackie.com or call 1-800-898-3211.

Is this answer helpful?

A

Yes, limited warranty available in US and Canada.

Is this answer helpful?

M: QW-35-FL

Advantages and Disadvantages

Advantages

  • Durable all-metal body construction for long-term use in professional settings
  • Includes weighted desktop stand and XLR cable for immediate use
  • No external power required as it uses passive dynamic technology
  • Internal foam pop filter reduces plosive sounds effectively
  • Cardioid pattern rejects background noise well
VS

Disadvantages

  • Heavy weight may be cumbersome for some portable setups
  • Requires audio interface with preamps for operation
  • Limited power options mean no phantom power is provided
  • Size might be too large for very compact spaces
  • Warranty coverage is primarily US and Canada specific
M: QW-35-FL

Product Specification

Type

Streaming microphone, speaker microphone

Design

analog

Transducer Type

dynamic

Polar Pattern

Cardioid

Connection

XLR

Frequency Range

50Hz-16kHz

M: QW-35-FL

Product Description

Elevate Your Audio Experience

Welcome to the world of professional broadcasting with the Mackie EM-99B. This dynamic broadcast microphone is engineered for creators who demand clarity and durability. Whether you are recording dialogue, streaming live, or producing top-tier podcasts, this tool delivers professional results. The cardioid capsule ensures you capture exactly what you need while rejecting unwanted background noise effectively. It transforms the way you communicate, bringing your voice to the big leagues with enhanced quality. For detailed setup steps, check the Mackie EM-99B Manual for specific installation diagrams.

Why It Stands Out

You do not need phantom power to operate this unit, making it versatile for various audio interfaces and mixing consoles. The single-axis suspension system minimizes vibration noise, which is crucial for handheld use or noisy environments. Inside the rugged metal body, an internal foam pop filter works silently to reduce plosives. You will rarely hear harsh p or b sounds disturbing your recording sessions ever again. This attention to detail ensures a clean signal path for every transmission.

What Comes In The Box

Every user gets ready to record right out of the packaging. The kit includes a weighted desktop stand, a high-quality xlr cable, and a foam windscreens. This saves you from hunting for accessories and ensures compatibility with your existing gear. The stand allows for stable positioning on your desk, while the included cable connects directly to your mixer. It is a complete solution for home studios and remote setups alike, eliminating setup delays.

Technical Performance

The frequency response is optimized for dialogue, ranging from 50 hz to 16 kilohertz. This range captures the warmth and detail of the human voice perfectly across the spectrum. Sensitivity sits at -53db, meaning it picks up sound efficiently without requiring excessive gain on your preamps. Impedance is set to 350 ohms, which is standard for dynamic broadcast microphones in this class. The build quality is robust, ensuring longevity even with the rigors of daily professional use.

Maintenance and Safety

Keep the device clean by washing the outside with a dry cloth to remove dust. Do not expose it to rain or extreme temperatures as this can damage the internal components. Follow the instructions for proper handling to ensure warranty validity and peak performance over time. This equipment complies with FCC rules and international safety standards for electronic devices. Proper disposal is also noted to protect the environment from hazardous substances.

Final Thoughts and Support

The Mackie EM-99B is built to last with its all-metal construction and reliable components. It is a staple for any audio enthusiast looking for a rugged and sound option. You can trust this microphone to handle the rigors of daily broadcasting without fail. If you need help, support is available online or by phone during normal business hours. It is a powerful tool for your creative journey and production workflow.

Notes

Remember to keep the receipt for warranty claims. Contact support for technical issues.

M: QW-35-FL

© Copyright 2026 Manual.ly