Manual.ly Logo

Honda HRX476C2 VK Manual

0.0 · 0 Ratings

PDF manual · 124 Pages

English

M: OA-GPT-5-NAN
page

/ 124

Loading...
83e84f4176314fa57446aab2b133cc60903e page d
13 EN
ENGINE OIL CHANGE
Drain the oil while the engine is still hot, so that
the oil drains quickly and completely.
CAUTION:
• Used engine oil can cause skin cancer if it remains in contact with
the skin for long periods.
Although this is highly unlikely unless you handle used oil every
day, we recommend that you wash your hands thoroughly with
soap and water each time you handle used engine oil.
1. Put the throttle lever in the
STOP position and turn the
fuel valve OFF. This will
reduce the possibility of fuel
leakage (see page 9).
2. Wipe the oil filler area clean,
and then remove the oil filler
cap/dipstick [1].
3. Place a suitable container [2]
next to the mower to catch
the used oil, and then tilt the
mower on its right side. The
used oil will drain through the
filler neck. Allow the oil to
drain completely.
4. Fill with the recommended oil
(see page 7). Do not overfill.
Engine oil capacity: 0.40ℓ
5. After changing the engine oil
and before starting the
engine, check the oil level
with the mower on a level
surface. If the oil level is
below the low level mark [3],
add oil to reach the high level
mark [4] on the dipstick.
6. Screw in the oil filler cap/dipstick securely.
NOTE:
The used engine oil must be disposed of in a manner which
respects the environment.
We recommend that you take it to a service station which will ensure
that it is recycled. Never dispose of used engine oil in dustbins or
pour it away on the ground, in the gutter or down the drains.
CHECKING THE SPARK PLUG
Recommended plug: NGK - BPR5ES
CAUTION:
• Use only recommended spark plug. Using spark plug with
inappropriate temperature ranges may damage the engine.
If the engine has just been run, do not touch the muffler and the
spark plug which will still be hot.
1. Pull off spark plug cap [5] and remove spark plug [6] using a plug
wrench [7].
2. Inspect the spark plug. Replace it if the electrodes are worn or if
the insulator is cracked or chipped. Clean the spark plug with a
wire brush if you are going to reuse it.
3. Measure the plug gap using a set of feeler gauges; the gap must
be between 0.7 and 0.8 mm. If adjustment is necessary,
carefully bend the side electrode.
4. Install the spark plug carefully, by hand, to avoid
cross-threading.
5. After the spark plug seats, tighten with a spark plug wrench to
compress the washer.
If reinstalling the old spark plug, tighten 1/8 to 1/4 turn after the
spark plug seats.
If installing a new spark plug, tighten 1/2 turn after the spark plug
seats to compress the washer [8].
6. Refit the spark plug cap.
CAUTION:
• A loose spark plug can overheat and damage the engine.
Overtightening the spark plug can damage the threads in the
cylinder head.
MAINTENANCE OF SPARK
ARRESTER
(In Europe and other countries where the machinery directive
2006/42/EC is enforced, this cleaning should be done by your
servicing dealer).
If the lawnmower has just been run, the silencer will still be very
hot. Allow it to cool down before carrying out this operation.
In some regions, it is prohibited to operate an engine without a
spark arrester.
1. Remove the 3 flange bolts [9]
from the muffler protector
[10] and remove the muffler
protector.
2. Remove the 2 tapping
screws [11] from the spark
arrester [12] and remove the
spark arrester from the
muffler.
3. Check the carbon deposits
around the exhaust port and
spark arrester. Clean if
necessary.
4. Replace the spark arrester if
there are any breaks or
tears.
5. Install the spark arrester [12]
and muffler protector [10] in
the reverse order of removal.
SAFETY
D8C19
[2]
[1]
[3]
[4]
[8]
[6]
[7]
[5]
0.7 - 0.8 mm
SAFETY
C19
[12]
[11]
[10]
[9]
[12]

Chat with your Honda HRX476C2 VK manual using AI

Get instant AI answers from your Honda HRX476C2 VK manual

Ask anything about the Honda HRX476C2 VK. Answers come from this manual, with the pages they are based on.

HRX476C2 VK Maintenance Schedule

Remind me when maintenance is due
Monthly
Check fuel quality

Do not use fuel older than one month as its quality deteriorates rapidly over time.

Every 3 months
Check air cleaner

Inspect the air filter element and clean it by tapping or blowing compressed air; replace if damaged.

Show in the manual (page 12)
Every 3 months
Replace air cleaner element

Replace the air filter element if it is damaged or excessively dirty during the 3-month check.

Show in the manual (page 12)
Every 6 months
Change engine oil

Drain used oil while the engine is hot and refill with recommended Honda 4-stroke oil to capacity.

Show in the manual (page 13)
Every 6 months
Check spark plug

Inspect the spark plug electrodes and insulator; adjust gap to 0.7-0.8 mm or replace if worn.

Show in the manual (page 13)
Every 6 months
Clean spark arrester

Remove and clean carbon deposits from the spark arrester in the muffler; replace if broken or torn.

Show in the manual (page 13)
Yearly
Check cutting means balance

Test the cutting means balance after sharpening; file uneven sides or replace if unbalanced.

Show in the manual (page 15)
Yearly
Check valve clearance

Have a servicing dealer check and adjust valve clearance once a year or every 100 hours.

Show in the manual (page 16)
Every 2 years
Check fuel tube

Inspect the fuel tube for damage and replace it as needed every two years.

Show in the manual (page 16)
Each use
Check grass catcher condition

Inspect the grass catcher for wear or deterioration before each use. Replace if torn or frayed.

Each use
Clean lawnmower deck

Keep the underside of the lawnmower clean and free of grass debris after every use to ensure efficient operation.

Show in the manual (page 12)

Free maintenance reminders

Timed to your purchase date. Always free, unsubscribe anytime.

By submitting you agree to the privacy policy. Unsubscribe with one click in any email.
M: QW-35-FL

Ask a Question

0/1000

Do you recommend HRX476C2 VK?

Yes No

Frequently Asked Questions

A

Use unleaded petrol 95 or 98. E10 fuels (up to 10% ethanol) are acceptable. Do not use petrol with more than 10% ethanol or more than 5% methanol. Avoid stale or contaminated fuel and do not store petrol for longer than about one month.

Is this answer helpful?

A

Change engine oil according to the maintenance schedule (initial month/5 hours then periodic intervals). Engine oil capacity is 0.40 L. Use Honda 4-stroke oil or an equivalent high-quality detergent oil with viscosity suitable for ambient temperatures (e.g., SAE 10W-30).

Is this answer helpful?

A

Yes. The mower offers variable mulching control with multiple positions to adjust mulching and ejection. You can collect grass in the catcher, use rear-ejection, or mulch finely chopped clippings to return nutrients to the lawn.

Is this answer helpful?

A

Always inspect blades for wear, cracks or dents and replace worn blades as a set. Sharpen by filing the top edge only and check balance afterward. Tighten cutting-means bolts to specified torque using a torque wrench and always use Honda genuine blades and hardware.

Is this answer helpful?

A

For storage over 30 days: drain fuel and carburetor, change engine oil, pull starter to close valves, coat exposed metal with oil, and store in a dry place. For >3 months, remove the spark plug and add a small amount of oil into the cylinder, then rotate the engine to distribute it.

Is this answer helpful?

A

Yes. Complex adjustments like carburetor jetting for high altitude, flywheel brake servicing, or major repairs should be performed by an authorized Honda dealer to ensure correct settings and preserve warranty.

Is this answer helpful?

A

Inspect the area for debris, check fuel and oil levels, ensure the grass catcher and discharge cover are secure, verify blade condition and bolt tightness, and confirm all safety devices and interlocks function before starting.

Is this answer helpful?

M: OA-GPT-5-NAN

Advantages and Disadvantages

Advantages

  • Reliable Honda GCV170 4-stroke engine delivering steady performance and long life.
  • Flexible cutting options: collection, mulching, and rear-ejection with variable mulching control.
  • Ergonomic adjustable handle and user-friendly controls for comfortable mowing.
  • Clear maintenance access: air cleaner, spark plug, oil dipstick, and accessible blade service.
  • Comprehensive safety features and decals: cutting-means brake, discharge cover, spark arrester.
VS

Disadvantages

  • Fuel capacity and runtime are modest (0.95 L, ~0.8 h) requiring frequent refills for larger jobs.
  • Some adjustments and repairs (carburetor jetting, major repairs) need an authorized dealer.
  • Blade bolt torques and sharpening should be handled carefully; improper service can cause imbalance.
  • Grass catcher fabric can wear and requires replacement with genuine parts for safety.
  • Not optimized for slopes over 20°; caution and limited performance on steep terrain.
M: OA-GPT-5-NAN

Product Specification

Type

Lawnmower

Power

4.16hp, 4.16hp, 10.19in3, 2800/min, 4-stroke, Honda GCVx170

Working width

18.50in

Working height

0.98-3.11in, height adjustable (central), 7 levels

Collection volume

18.23gal

Drive

Wheel drive with speed regulation 0-3.11mph

Gearbox

Forward gear

Special features

Mulching function optional, Rear discharge, manual box emptying

Tank capacity

1.00qt

Noise level

95

Weight

85.98lb

Scope of delivery

Grass catcher

M: OA-GPT-54-NAN

Product Description

Honda HRX 476 C2 VK Petrol Lawn Mower — Reliable Performance and User-Friendly Care

The Honda HRX 476 C2 VK petrol lawn mower is a robust, feature-rich walk-behind mower engineered for homeowners who want professional-quality results with straightforward operation and maintenance. Driven by a Honda GCV170 air-cooled 4-stroke engine, this model balances power and efficiency for lawns of varied size and condition. It offers a 470 mm cutting width, multiple cutting height settings, and Honda’s thoughtfully designed controls so mowing is both precise and comfortable.

Ergonomics and usability are central to the HRX 476 C2 VK. The mower includes adjustable handle positions, an easy-to-use throttle, and a variable drive system (depending on trim) that adapts to terrain and grass density. The grass catcher is sized for practical collection and is simple to fit or remove; a variable mulching control lets you choose between rear-ejection, collection, or mulching to return finely chopped clippings to the lawn as natural fertilizer.

Durability and safety are emphasized throughout the design. The deck and cutting-means are built for balanced, consistent cutting; Honda genuine parts are recommended for replacements. Multiple safety interlocks—cutting-means brake, discharge cover, spark arrester and clear warning decals—help reduce risk during operation and maintenance. The mower also has accessible service points: air cleaner, spark plug, oil filler/dipstick, and clear procedures for blade removal, sharpening or replacement.

Maintenance and storage are straightforward with Honda’s guidance. Regular checks of fuel, engine oil, air cleaner and blade condition are highlighted to preserve performance. The manual advises draining fuel for long-term storage, changing oil, and protecting metal surfaces from corrosion. For persistent issues or adjustments (carburetor jetting at altitude, drive cable adjustments, or repairs), Honda-authorized dealers are recommended to ensure correct service and to protect warranty coverage.

This mower is well suited for homeowners who value a reliable, serviceable machine with flexible cutting options (collection, mulching, rear ejection) and clear safety features. With proper maintenance, the HRX 476 C2 VK provides consistent cutting quality, good bagging performance, and longevity typical of Honda small engines.

Notes

  • Uses unleaded petrol 95/98; avoid fuels with excessive alcohol (E10 acceptable; methanol limited).
  • Engine oil capacity: 0.40 L; recommended Honda or equivalent 4‑stroke oils.
  • Check blades, bolts and grass catcher regularly; replace with Honda genuine parts for safety and balance.
  • Follow storage steps (drain carburetor, change oil, coat against rust) if stored over 30 days.
M: OA-GPT-5-NAN

© Copyright 2026 Manual.ly