Manual.ly Logo

Hilleberg Keron 3 GT Manual

0.0 · 0 Ratings

PDF manual · 16 Pages

English

M: QW-35-FL
page

/ 16

Loading...
5504fd855678380686c3c5bb50c17c08c1cd page 7
| 13
12 |
Hilleberg Keron GT
sv
en
de
2 3
1
4
Verankern des Zeltes
achtung: Keron GT steht gut mit nur vier Heringen, wir empfehlen jedoch dass
Du immer alle Heringe und Leinen verankerst, da sich die Wetterbedingungen
schnell ändern können.
1
Spanne die Leinen der Lüfterhauben und verankere sie.
2
&
3
Setze die
restlichen Heringe an den beiden Längsseiten.
4
Stelle die Leinen so lang wie
möglich ein. Spanne die Leinen und verankere sie wie in der Skizze gezeigt. Bei
starkem Seitenwind ist es ratsam, alle Leinen an der Windseite gerade gegen den
Wind zu verspannen. Achte darauf, dass die Heringe richtig sitzen (siehe Seite 7).
achtung! Die Zeltleinen sollten nur so stark gespannt werden, dass sie nicht die
Form des Zeltes verändern.
Förankra tältet
obs: Keron GT står bra med 4 pinnar men vi rekommenderar att du alltid fäster
alla linor och markpinnar eftersom vädret kan ändras snabbt.
1
Drag ut och fäst båda ventillinorna.
2
&
3
Fäst markpinnarna i fästena på tältets
bägge långsidor.
4
Drag ut linorna i sitt längsta läge och fäst dem enligt skissen.
Om vinden blåser hårt från en sida kan det vara bäst att ha alla linor rakt ut mot
vinden. Kontrollera att alla markpinnar är helt nere i marken i rätt vinkel. (Se sid 7.)
obs: Tältlinorna skall vara spända men inte så mycket att de ändrar tältets form.
Anchoring the tent
note: While the Keron GT is fully pitched with just the four corners properly pegged,
we recommend that you always anchor the tent because weather can change quickly.
1
Peg out the guy lines on the vents at either end of the tent.
2
&
3
Peg out
the floor peg loops at the base of the pole sleeves on both sides of the tent before
pegging out the guy lines.
4
Make sure all the guy lines are set to their longest
length. Peg out the remaining guy lines as shown in the illustration. If the wind is
blowing hard from the side, pull the windward side guy lines straight out. Make
sure the pegs are fully pressed into the ground at the proper angle (see page 7).
note: The guy lines should be taut, but not so tight that they deform the tent.

Chat with your Hilleberg Keron 3 GT manual using AI

Get instant AI answers from your Hilleberg Keron 3 GT manual

Ask anything about the Hilleberg Keron 3 GT. Answers come from this manual, with the pages they are based on.

Keron 3 GT Maintenance Schedule

After every use
Dry the tent and brush out dirt

Hang the tent to dry after each use. Brush off dirt from the outer tent and shake debris from the inner tent before packing.

Show in the manual (page 15)
After every use
Clean zippers with a stiff brush

Brush all zippers with a small, stiff brush to remove sand or grit, especially if used in sandy or dusty conditions.

Show in the manual (page 15)
After every use
Inspect poles for damage

Check the tent poles for potential damage or cracks to ensure safety and structural integrity.

Show in the manual (page 15)
As needed
Replace damaged or lost pegs

Clean the pegs and replace any that are damaged or lost to maintain proper anchoring capability.

Show in the manual (page 15)
M: qwen/qwen3.8-flash

Ask a Question

0/1000

Do you recommend Keron 3 GT?

Yes No

Frequently Asked Questions

A

Yes, the tent is designed for extreme conditions. For snow camping, dig the tent down no more than half its height and use deadman anchors like snow pegs buried in trenches to secure the guy lines.

Is this answer helpful?

A

No, the inner tent is water-repellent but not waterproof. It should only be used separately in dry, fair weather conditions to prevent getting wet.

Is this answer helpful?

A

Ensure maximum ventilation by opening the hooded vents and using the mesh panels. If using the outer tent alone, consider adding a footprint to reduce ground moisture, though some condensation is inevitable.

Is this answer helpful?

A

After use in sandy or dusty environments, brush the zippers with a small stiff brush to remove grit. Never force a zipper if it catches; keep your finger ahead of the slider to prevent fabric jamming.

Is this answer helpful?

A

Technically yes, as the tent stands with just four corner pegs, but it is highly recommended to use all 22 peg points and guy lines because weather can change rapidly in the backcountry.

Is this answer helpful?

M: QW-35-FL

Advantages and Disadvantages

Advantages

  • Exceptional durability due to Kerlon 1800 fabric
  • Versatile setup allowing inner and outer tent separation
  • Superior ventilation system with adjustable hooded vents
  • Strong tunnel structure resists high winds effectively
  • Multiple door opening options for flexible access
VS

Disadvantages

  • Requires full anchoring for optimal stability in bad weather
  • Outer tent alone is not breathable and may cause condensation
  • Inner tent poles holders sold separately as accessories
  • Zippers require frequent cleaning to prevent grit damage
  • Poles must be handled carefully to avoid breakage during assembly
M: QW-35-FL

Product Specification

Type

Tunnel tent

Capacity

3

External dimensions (LxWxH)

16.7x5.2x3.4ft

Internal dimensions (LxWxH)

7.2x5.2x3.4ft

Water column

18042in

Weight

11.02lbs

M: QW-35-FL

Product Description

Discover the Hilleberg Keron 3 GT Tunnelzelt

The Hilleberg Keron 3 GT Tunnelzelt represents the pinnacle of tunnel tent engineering, designed for those who demand reliability in extreme conditions. This high-quality shelter features a robust Kerlon 1800 outer fabric that offers exceptional tear strength and durability. The integrated inner tent creates a seamless living space, while the tunnel design provides generous headroom and usable area without the need for excessive guy lines.

Constructed with precision, this tent utilizes four 10 mm poles that create a strong, stable arch. The design allows for versatile pitching options, including the ability to separate the inner and outer tents for different camping styles or group gatherings. Proper care is essential to maintain its performance; users are advised to practice setup at home before venturing into the backcountry. The tent includes 22 peg points, though it can stand with just four, full anchoring is recommended for unpredictable weather.

Ventilation is a key feature, with large hooded vents at both ends that allow airflow even when closed, preventing condensation buildup. The doors offer multiple opening configurations, ensuring easy access and ventilation control. Whether used for winter snow camping or summer treks, the Keron 3 GT stands as a testament to Swedish craftsmanship and functional design.

Care and Maintenance

To ensure longevity, always dry the tent thoroughly before storage. Avoid leaving it in direct sunlight for extended periods as UV rays damage fabrics. Regularly clean zippers and check poles for damage. By following these guidelines, your investment will serve you well for many expeditions.

M: QW-35-FL

© Copyright 2026 Manual.ly