Manual.ly Logo

Grundfos JP5-48 S-BBVP Manual

0.0 · 0 Ratings

PDF manual · 19 Pages

English

M: gpt-5.6-terra
page

/ 19

Loading...
5afdbabccaa4841363041ec5c78bfee5d876 page 2
English (GB) Installation and operating instructions
Original installation and operating instructions
Table of contents
1. General information ........................5
1.1 Target group..............................5
1.2 Hazard statements..........................5
1.3 Notes ..................................5
2. Receiving the product.......................5
2.1 Inspecting the product........................5
2.2 Scope of delivery, JP ........................5
2.3 Scope of delivery, JP Booster ...................6
3. Installing the product .......................6
3.1 Location ................................6
3.2 Mechanical installation .......................6
3.3 Electrical connection.........................8
4. Startup of the product......................10
4.1 Priming the product ........................11
4.2 Starting up the product ......................11
5. Product introduction.......................11
5.1 Product overview, JP .......................12
5.2 Product overview, JP Booster ..................12
5.3 Intended use ............................12
5.4 Pumped liquids ...........................12
5.5 Identification.............................13
6. Service ...............................13
6.1 Maintenance ............................13
6.2 Maintaining the pressure tank ..................13
6.3 Service kits .............................13
7. Taking the product out of operation .............14
7.1 Draining JP and JP PT-V .....................14
7.2 Draining JP PT-H..........................14
7.3 Storage of the product.......................14
7.4 Frost protection...........................14
8. Fault finding the product ....................14
8.1 The pump does not start .....................15
8.2 The pump stops unexpectedly during operation and
starts again after a while .....................15
8.3 The pump runs, but does not deliver the expected
amount of water ..........................15
8.4 Fault finding boosters with a pressure manager .......15
8.5 Fault finding boosters with a pressure tank ..........16
9. Technical data ...........................17
9.1 Operating conditions........................17
9.2 Head and flow rate.........................17
9.3 Inlet pressure ............................17
9.4 Miscellaneous data ........................17
10. Disposing of the product ....................17
1. General information
This appliance can be used by children aged from 8 years
and above and persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge if
they have been given supervision or instruction
concerning use of the appliance in a safe way and
understand the hazards involved.
Children shall not play with the appliance. Cleaning and
user maintenance shall not be made by children without
supervision.
Read this document before you install the product.
Installation and operation must comply with local
regulations and accepted codes of good practice.
1.1 Target group
These installation and operating instructions are intended for
professional as well as non-professional users.
1.2 Hazard statements
The symbols and hazard statements below may appear in Grundfos
installation and operating instructions, safety instructions and
service instructions.
DANGER
Indicates a hazardous situation which, if not avoided, will
result in death or serious personal injury.
WARNING
Indicates a hazardous situation which, if not avoided,
could result in death or serious personal injury.
CAUTION
Indicates a hazardous situation which, if not avoided,
could result in minor or moderate personal injury.
The hazard statements are structured in the following way:
SIGNAL WORD
Description of the hazard
Consequence of ignoring the warning
• Action to avoid the hazard.
1.3 Notes
The symbols and notes below may appear in Grundfos installation
and operating instructions, safety instructions and service
instructions.
Observe these instructions for explosion-proof products.
A blue or grey circle with a white graphical symbol
indicates that an action must be taken.
A red or grey circle with a diagonal bar, possibly with a
black graphical symbol, indicates that an action must not
be taken or must be stopped.
If these instructions are not observed, it may result in
malfunction or damage to the equipment.
Tips and advice that make the work easier.
2. Receiving the product
2.1 Inspecting the product
On receipt of the product, do the following:
1. Check that the product is as ordered.
If the product is not as ordered, contact the supplier.
2. Make sure that the supply voltage and frequency correspond to
the values stated on the product nameplate.
Related information
5.5.1 Nameplate example for JP and JP Booster
2.2 Scope of delivery, JP
The box contains the following items:
• 1 Grundfos JP pump
• 1 lifting-handle kit
• 1 quick guide
• 1 safety instructions booklet.
5
English (GB)

Chat with your Grundfos JP5-48 S-BBVP manual using AI

Get instant AI answers from your Grundfos JP5-48 S-BBVP manual

Ask anything about the Grundfos JP5-48 S-BBVP. Answers come from this manual, with the pages they are based on.

Ask a Question

0/1000

Do you recommend JP5-48 S-BBVP?

Yes No

Frequently Asked Questions

A

It is suitable for garden irrigation, domestic water supply, pressure boosting, drawing water from tanks or shallow wells, and small horticultural, agricultural, or commercial water applications.

Is this answer helpful?

A

The pump can self-prime from a maximum suction height of 8 m. This figure includes pressure losses in the suction pipe at a liquid temperature of 20 C.

Is this answer helpful?

A

The JP5-48 has a maximum flow rate of 5 m3/h and a maximum head of 48 m. Actual output depends on suction height, pipework, fittings, and the operating point.

Is this answer helpful?

A

Yes, it can handle clean rainwater and clean well water. Install a filter on the suction side when sand, gravel, or deposits may be present to protect the pump.

Is this answer helpful?

A

The base JP5-48 pump has an integrated thermal motor switch that protects against overload and overheating. Dedicated dry-run protection is provided by the optional JP PM pressure-manager version.

Is this answer helpful?

A

The listed 50 Hz version uses a 1 x 230 V supply and has a 1490 W input power rating. Electrical installation and protective measures must comply with local regulations.

Is this answer helpful?

M: gpt-5.6-terra

Advantages and Disadvantages

Advantages

  • Self-priming design can lift clean water from up to 8 m below the pump, including water containing air.
  • Delivers up to 5 m3/h flow and 48 m head for irrigation, pressure boosting, and tank transfer tasks.
  • Stainless-steel pump housing and composite hydraulic parts support corrosion resistance and long service life.
  • Integrated thermal motor protection helps guard against overload, blockage, and dry-running related overheating.
  • Compact layout and carry handle make placement and transport easier for domestic and garden installations.
VS

Disadvantages

  • Designed only for clean, non-aggressive liquids without solids, long fibres, or abrasive contaminants.
  • Outdoor installation requires a protective cover against sun, rain, snow, and frost.
  • At up to 81 dB(A), operating noise may need consideration near patios or quiet residential areas.
  • Correct suction pipe sizing, a filter, and often a foot valve are needed for dependable installation.
  • The standard pump does not include the automatic pressure manager features found on JP PM versions.
M: gpt-5.6-terra

Product Specification

Power

1,490 W

Flow rate

1,320.86 gal/h

Maximum head

158.46 ft

Suction height

26.25 ft

Pressure

87.02 psi

Pressure connection

1 in

Suction connection

1 in

Features

without tank

Cable length

4.92 ft

Weight

26.46 lb

M: gpt-5.6-terra

Product Description

Grundfos JP5-48 S-BBVP Electric Garden Pump - Read, Download & Print Free

The Grundfos JP5-48 S-BBVP Electric Garden Pump is a compact, self-priming centrifugal pump designed to move clean water reliably for domestic, garden, and small commercial applications. Its strong suction performance makes it a practical choice where water must be drawn from a rainwater tank, storage vessel, shallow well, or other source located below pump level. With a maximum suction lift of up to 8 metres, it supports flexible installation in many outdoor water supply setups.

Built around a single-stage hydraulic design, the JP5-48 delivers a maximum flow rate of 5 m3/h and a maximum head of 48 metres. This combination suits tasks such as lawn and border irrigation, filling tanks, boosting water pressure, and supplying clean water to small horticultural or agricultural operations. The integrated ejector and guide vanes help the pump establish suction efficiently, including when the water contains air.

Durable Construction for Everyday Water Transfer

The pump housing is manufactured from stainless steel, helping it resist corrosion in routine water-handling environments. A composite impeller and corrosion-resistant internal materials further support dependable operation. The practical carrying handle makes the unit easier to position, while its compact form is useful where installation space is limited.

An air-cooled motor with sealed, permanently lubricated bearings is designed for low-maintenance use. The single-phase motor includes a built-in thermal switch that interrupts operation during overload, blockage, or dry-running conditions and restarts after adequate cooling. This protection helps reduce the risk of motor damage during unexpected operating issues.

Installation and Water Quality Considerations

For best performance, install the Grundfos JP5-48 S-BBVP Electric Garden Pump on a level base near the water source and keep the suction pipe as short and straight as possible. Outdoor installations require suitable protection from direct sun, rain, snow, and frost. Where rainwater or well water may carry sand, gravel, or sediment, a suction-side filter is recommended. A foot valve with strainer is also useful when the pump is installed above the water level.

This model is intended for clean, thin, non-aggressive, non-toxic, and non-explosive liquids without solids or long fibres. Suitable media include drinking water and rainwater. It should not be selected for dirty water, abrasive slurry, or chemically aggressive liquids.

Notes

  • Maximum operating pressure is 6 bar.
  • Maximum liquid temperature is 40 C in continuous duty.
  • The pump operates on 1 x 230 V, 50/60 Hz power.
  • Use correctly sized vacuum-resistant suction piping to maintain efficient priming and flow.
  • Product code for the 230 V, 50 Hz Schuko version is 99458769.
M: gpt-5.6-terra

© Copyright 2026 Manual.ly