Manual.ly Logo

Ground Zero Uranium GZUA 2.250SQ-PLUS Manual

0.0 · 0 Ratings

PDF manual · 22 Pages

English

M: OA-GPT-54-NAN
page

/ 22

Loading...
41014a46a1e6863da57729e46f5b6eefb468 page 2
2
Recommended wiring
GZUA 2.250SQ-Plus / GZUA 4.150SQ-Plus
GZUA 6.200SQ-Plus
Speaker wires
min 2.5 mm² / 13 AWG
min 2.5 mm² / 13 AWG
Power supply wires
min 20.0 mm² / 4 AWG
min. 35.0 mm² / 2 AWG
Remote wire
min 0.75 mm² / 20 AWG
min 0.75 mm² / 20 AWG
Mounting instructions
As a precaution, it is recommended to disconnect the vehicles battery before mounting (also note the vehicles manual!)
The power supply wire (+12 V) has to be protected within max. 20 cm / 8” by a main fuse holder with matching fuse value
(Main fuse value has to be equal to the sum of values of the fuses of each connected device)
If necessary, replace a defective fuse by a new one with identical value
Never drill a hole to the vehicles gas tank or brake lines, to wirings or any other important vehicle part!
Never pass wires over sharp edges or vehicle parts
Keep the wiring away from the antenna and electronic devices contributing to radio reception
Install the power supply wiring locally separated from the speaker wiring
The amplifier contains a temperature protection circuit that turns the device off in case of overheating. After a certain cooling
time the amplifier will turn on again automatically. To avoid heat build-up, it´s necessary to provide sufficient air supply for
the amplifier cooling. Therefore, never cover the surface of the heatsink entirely.
The amplifier should not be mounted on a strongly vibrating part or surface (e.g. subwoofer enclosure)
If a pre-amplified output (RCA) is available (on the head unit) it is recommended to make use of them
WARNING !
Powerful car audio systems are able to create extremely high SPL similar to real live concert levels. Permanent exposure to excessively high
sound levels may cause damage to or loss of the hearing.
Furthermore, operation of a motor vehicle while listening to audio equipment at high volume levels may impair your ability to concentrate
on road traffic and external sounds such as horns, warning signals or emergency vehicles. In the interest of general and own safety, it is
recommended to listen to music at appropriately low volume levels while driving.

Chat with your Ground Zero Uranium GZUA 2.250SQ-PLUS manual using AI

Get instant AI answers from your Ground Zero Uranium GZUA 2.250SQ-PLUS manual

Ask anything about the Ground Zero Uranium GZUA 2.250SQ-PLUS. Answers come from this manual, with the pages they are based on.

Ask a Question

0/1000

Do you recommend Uranium GZUA 2.250SQ-PLUS?

Yes No

Frequently Asked Questions

A

It is a 2-channel Class A/B car amplifier designed for clean, controlled power in audio systems that need tuning flexibility. It works well for front speakers or bridged subwoofer use, depending on the build and impedance requirements.

Is this answer helpful?

A

Yes. The model is rated 1 ohm stable in stereo mode, which gives more installation freedom and allows it to support demanding speaker setups when wired correctly.

Is this answer helpful?

A

Yes. It can be used in bridged mode for subwoofer applications, as long as the load and wiring follow the technical limits. It also includes bass boost and phase control for better low-end adjustment.

Is this answer helpful?

A

It offers input sensitivity adjustment, high-pass and low-pass filters, band-pass operation, phase shift, and bass boost. These controls help match the amplifier to different speakers and listening preferences.

Is this answer helpful?

A

Yes. It includes thermal, short-circuit, overload, and over-current protection. A temperature-controlled fan helps with cooling, and the amplifier can shut down temporarily if it gets too hot.

Is this answer helpful?

A

Check battery disconnect, fuse placement, cable gauge, grounding quality, and routing away from sharp edges and interference sources. Also make sure the speaker load matches the amplifier’s rated impedance.

Is this answer helpful?

M: OA-GPT-54-NAN

Advantages and Disadvantages

Advantages

  • 1-ohm stable stereo operation offers flexible speaker matching and stronger build options.
  • Premium WIMA capacitors and Burr-Brown op-amps support clean, detailed audio performance.
  • HPF, LPF, band-pass, phase shift, and bass boost give precise tuning control.
  • Soft turn-on, cooling fan, and protection circuits improve daily reliability.
VS

Disadvantages

  • Installation requires careful wiring, correct fusing, and proper grounding to avoid issues.
  • The amplifier can generate significant heat, so airflow and placement are important.
  • Bass boost and phase features are tied to specific operating modes, limiting use in some setups.
  • Not ideal for vibration-heavy locations like a subwoofer enclosure.
M: OA-GPT-54-NAN

Product Specification

Type

Stereo Amplifier

Channels

2

Power 4Ohm

2x 180W, 1x700W (bridged)

Power 2Ohm

2x 320W, 1x1200W (bridged)

Power 1Ohm

2x 500W

Dimensions

8.23x1.81x14.17in

M: OA-GPT-54-NAN

Product Description

Ground Zero Uranium GZUA 2.250SQ-PLUS: A Compact Powerhouse for Tuned Car Audio

The Ground Zero Uranium GZUA 2.250SQ-PLUS is a 2-channel Class A/B amplifier built for listeners who want control, clarity, and real output in a compact format. Part of the Uranium series, it focuses on sound quality while still offering the kind of power reserve that makes everyday driving and more demanding audio setups feel effortless.

What stands out first is the flexibility. The amplifier is 1 ohm stable in stereo mode, which gives installers more freedom when pairing it with different speaker loads. It also includes adjustable high-pass and low-pass filters, band-pass operation, input sensitivity control, phase shift, and bass boost. In practice, that means the GZUA 2.250SQ-PLUS is not just about volume; it is about shaping the sound to fit the car, the speakers, and the listener’s taste.

Ground Zero adds premium internal components such as WIMA capacitors and Burr-Brown operational amplifiers, both of which are commonly associated with refined signal handling and stable performance. A soft delayed remote turn-on helps reduce system stress at startup, while the temperature-controlled fan and protection circuits work in the background to keep the amplifier safe during heavy use. Status LEDs also make basic monitoring straightforward.

This model is especially attractive for systems that need a versatile 2-channel amp for front speakers or a bridged subwoofer application. With a wide frequency response and strong RMS ratings, it fits well into builds that value detail, punch, and reliability. The included bass remote support and phase adjustment are especially useful when the amplifier is used with a low-pass setup and the goal is tighter low-end control.

Installation still matters. The manual stresses proper fuse protection, correct cable sizing, clean grounding, and careful placement away from heat, vibration, and sharp edges. Those notes are worth following closely, because an amplifier this capable deserves a stable electrical foundation to perform at its best.

Notes

  • Use quality RCA cables for clean signal transfer.
  • Keep power and signal wiring separated.
  • Provide airflow around the heatsink.
  • Match speaker impedance to the amplifier’s limits.
  • For best results, tune filters gradually and test before finalizing the setup.
M: OA-GPT-54-NAN

© Copyright 2026 Manual.ly