Manual.ly Logo

Ground Zero Iridium GZIB 300BR-ACT Manual

0.0 · 0 Ratings

PDF manual · 5 Pages

English

M: OA-GPT-54-NAN
page

/ 5

Loading...
36005907052ba5d5bbb10090b6c5b439f973 page 3
Anschlüsse und Einstellungen / Connections and functions
# Erklärung Description
1
High Level Eingänge
Hiermit lässt sich der Verstärker mittels Hochpegel- Signal
betreiben. Verbinden Sie hierzu die High Level Eingänge direkt mit
den Lautsprecher-ausgängen der Headunit oder eines
vorhandenen, fahrzeug-spezifischen Aktivsystems.
Auto-On
Die Auto-On Funktion der High Level Eingänge ermöglicht den
Betrieb ohne zusätzlichen Remote Anschluß. Das Gerät schaltet
ein, sobald ein Signal an den High Level Eingängen anliegt.
Nutzen Sie keinesfalls die High-und die Low Level-Eingänge
gleichzeitig.
High Level Input
High level input terminal should be connected with the speaker
output of the Headunit or a carspecific active system.
Auto-On
The Auto-On function allows to use the amplifier without
additionally remote connection. The unit automatically turns on
as soon as a signal is received.
Do not use the High- and Low Level Input together at the same
time!
2
Low Level Eingänge
Eingänge für den linken (L) und rechten (R) Kanal des Verstärkers.
Die Vorverstärker Ausgänge der Signalquelle (Headunit) oder
einer externen elektronischen Weiche müssen hier angeschlossen
werden.
Low Level Input
Left (L) and Right (R) channel inputs of the amplifier system.
Pre- amplifier outputs of a source (head unit) or of an external
electronic crossover must be connected to these inputs.
3
Phase Shift
Phasen-Schalter: 0° (Nor.) oder 180° (Rev.) schaltbar.
Phase Shift
Phase switch: 0° (Nor.) or 180° (Rev.) switchable.
4
Input Level
Zum einstellen der Eingangsempflindlichkeit
Input Level
Knob for adjusting the input sensitivity
5
Weiche
Zur Einstellung der oberen Grenz-Frequenz von 40 Hz ~ 120 Hz.
Crossover
To adjust the cut-off frequency from 40 Hz ~ 120 Hz
6
REM -> Remote Antennenanschluss
Wichtig
Bei Benutzung des High Level Eingangs wird der Remote Anschluß
nicht benötigt.
REM -> Remote antenna terminal
Important
The remote connection is not needed if using the High Level In.
7
GND -> Masse Anschluss
GND -> Ground connection
8
B+ -> +12 Volt
Wichtig:
Bitte benutzen Sie mind.
6 mm² Kabel für die Spannungsversorgung
B+ -> +12 Volt
Important:
Please use min. 6 mm² cable for the power supply.
9
Statusanzeige LEDs
Betrieb (grün)
Fehler (rot)
Power / Protection LED
Power (green)
Protection (red)
Stromanschluss / Power connection

Chat with your Ground Zero Iridium GZIB 300BR-ACT manual using AI

Get instant AI answers from your Ground Zero Iridium GZIB 300BR-ACT manual

Ask anything about the Ground Zero Iridium GZIB 300BR-ACT. Answers come from this manual, with the pages they are based on.

Ask a Question

0/1000

Do you recommend Iridium GZIB 300BR-ACT?

Yes No

Frequently Asked Questions

A

It is a 12-inch active subwoofer with a built-in amplifier, designed to add strong bass in a compact, easier-to-install package. It suits drivers who want an all-in-one low-frequency upgrade.

Is this answer helpful?

A

No. The amplifier is already integrated into the unit. That makes installation simpler and reduces the need for extra external audio hardware.

Is this answer helpful?

A

Yes. The high-level input with Auto-On is meant for connection to speaker-level signals, so it can integrate well with many original head units and OEM audio systems.

Is this answer helpful?

A

You can adjust the input sensitivity, the low-pass crossover from 40 Hz to 120 Hz, and the phase switch between 0° and 180°. These controls help you blend it with your system.

Is this answer helpful?

A

It offers up to 300 watts max output and 150 watts RMS. That is enough for a strong everyday bass upgrade with good control, especially in a compact active design.

Is this answer helpful?

A

Check the power cable, ground connection, remote signal if used, and the internal fuse. Also confirm that the supply voltage is within the recommended 10V to 15V range.

Is this answer helpful?

M: OA-GPT-54-NAN

Advantages and Disadvantages

Advantages

  • Built-in amplifier simplifies installation and reduces extra hardware needs.
  • High-level input with Auto-On supports factory stereos and quick integration.
  • Adjustable crossover and phase switch help match the sub to the cabin.
  • Sturdy MDF bass-tunnel enclosure supports controlled, punchy low-end response.
VS

Disadvantages

  • 150 W RMS is solid for daily use, but not ideal for extreme SPL goals.
  • The enclosure still takes noticeable space in smaller trunks.
  • Proper setup matters; poor tuning can affect bass balance.
  • High-level and low-level inputs cannot be used together at the same time.
M: OA-GPT-54-NAN

Product Specification

Type

Enclosed Subwoofer (Bass Reflex)

Amplification

active

Tweeter

no

Mid-range Speaker

no

Woofer

12 in

Frequency Range

40 Hz - 160 Hz

Power

150W RMS, 300W Peak

Impedance

4Ω

Enclosure Dimensions

17.32x14.37x15.35 in (WxHxD)

M: OA-GPT-54-NAN

Product Description

Ground Zero GZIB 300BR-ACT: Compact Active Bass with Serious Impact

The Ground Zero GZIB 300BR-ACT is built for listeners who want deeper, more controlled bass without turning the car into a full custom audio project. This 12-inch active subwoofer combines a sturdy MDF bass-tunnel enclosure with an integrated Class AB MOSFET amplifier, making it a practical all-in-one solution for clean low-end performance. For anyone searching for the Ground Zero GZIB 300BR-ACT Manual, the key idea is simple: this unit is designed to be powerful, flexible, and straightforward to install.

At the heart of the design is a 30 cm woofer with a 4-ohm load, an IMPP cone, and a high-load voice coil that help it handle everyday use with confidence. The enclosure is tuned to support tight, punchy bass rather than loose boom, which makes it a strong match for music styles that rely on rhythm and low-frequency control. With up to 300 watts max output and 150 watts RMS, it delivers enough energy for a noticeable upgrade over standard factory sound.

One of the most convenient features is the input flexibility. The GZIB 300BR-ACT includes both high-level and low-level inputs, so it can work with aftermarket head units as well as factory systems. The Auto-On function is especially useful in OEM setups because it lets the subwoofer wake up automatically when a signal is detected, removing the need for an extra remote wire in many installations. A phase switch from 0° to 180° also helps align bass output with the rest of the system.

Fine-tuning is just as important as raw power, and this model gives users the tools to do it. The input sensitivity control and adjustable crossover range from 40 Hz to 120 Hz make it easier to match the subwoofer to the rest of the audio system. Combined with a signal-to-noise ratio above 90 dB and low distortion, the result is bass that feels intentional rather than overpowering.

Notes

  • Use at least 6 mm² power cable for reliable operation.
  • Do not use high-level and low-level inputs at the same time.
  • If bass seems weak or uneven, try adjusting the phase and crossover first.
  • The enclosure is compact for a powered sub, but it still needs proper cargo-space planning.

Overall, the Ground Zero GZIB 300BR-ACT is a smart choice for drivers who want an easier upgrade path, solid output, and enough adjustment options to dial in satisfying bass.

M: OA-GPT-54-NAN

© Copyright 2026 Manual.ly