Manual.ly Logo

Eurolite LED BC-3 Manual

1.0 · 2 Ratings

PDF manual · 14 Pages

English

M: OA-GPT-5-NAN
page

/ 14

Loading...
deb01e9db8beaf72c5703feb7dcc5ae5edc1 page a
00078963.DOC, Version 1.1 10/14
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it
on immediately. The arising condensation water might damage your device. Leave the device switched off
until it has reached room temperature.
This device falls under protection-class II and features a protective insulation. The voltage and frequency
must exactly be the same as stated on the device. Wrong voltages or power outlets can lead to the
destruction of the device and to mortal electrical shock.
Always plug in the power plug last. The power plug must always be inserted without force. Make sure that
the plug is tightly connected with the outlet.
Never let the power-cord come into contact with other cables! Handle the power-cord and all connections
with the mains with particular caution! Never touch them with wet hands, as this could lead to mortal
electrical shock.
Never modify, bend, strain mechanically, put pressure on, pull or heat up the power cord. Never operate next
to sources of heat or cold. Disregard can lead to power cord damages, fire or mortal electrical shock.
The cable insert or the female part in the device must never be strained. There must always be sufficient
cable to the device. Otherwise, the cable may be damaged which may lead to mortal damage.
If extension cords are used, make sure that the core diameter is sufficient for the required power
consumption of the device. All warnings concerning the power cords are also valid for possible extension
cords.
Make sure that the available voltage is not higher than stated on the technical sticker.
Make sure that the power-cord is never crimped or damaged by sharp edges. Check the device and the
power-cord from time to time.
Always disconnect from the mains, when the device is not in use or before cleaning it. Only handle the
power-cord by the plug. Never pull out the plug by tugging the power-cord. Otherwise, the cable or plug can
be damaged leading to mortal electrical shock. If the power plug or the power switch is not accessible, the
device must be disconnected via the mains.
If the power plug or the device is dusty, the device must be taken out of operation, disconnected and then be
cleaned with a dry cloth. Dust can reduce the insulation which may lead to mortal electrical shock. More
severe dirt in and at the device should only be removed by a specialist.
There must never enter any liquid into power outlets, extension cords or any holes in the housing of the
device. If you suppose that also a minimal amount of liquid may have entered the device, it must immediately
be disconnected. This is also valid, if the device was exposed to high humidity. Also if the device is still
running, the device must be checked by a specialist if the liquid has reduced any insulation. Reduced
insulation can cause mortal electrical shock.
There must never be any objects entering into the device. This is especially valid for metal parts. If any metal
parts like staples or coarse metal chips enter into the device, the device must be taken out of operation and
disconnected immediately. Malfunction or short-circuits caused by metal parts may cause mortal injuries.
HEALTH HAZARD!
Never look directly into the light source, as sensitive persons may suffer an
epileptic shock (especially meant for epileptics)!
Please consider that damages caused by manual modifications to the device are not subject to warranty.
Keep away children and amateurs!

Chat with your Eurolite LED BC-3 manual using AI

Get instant AI answers from your Eurolite LED BC-3 manual

Ask anything about the Eurolite LED BC-3. Answers come from this manual, with the pages they are based on.

LED BC-3 Maintenance Schedule

Regularly
Clean the device exterior

Use a soft, lint-free, damp cloth to remove dust. Do not use alcohol or solvents.

Regularly
Inspect device and power cord

Check the device and power cord from time to time for damage.

Show in the manual (page 10)
M: QW-35-FL

Ask a Question

0/1000

Do you recommend LED BC-3?

Yes No
0
User Pic

Lena Schwarz

10 months ago

My item arrived defective with a loose connection (wackelkontakt). How can I exchange it, and what is the process if shipping took a couple extra days? Also, is the quality really worth the price?

0
User Pic

Manual.ly

10 months ago

We are sorry it arrived defective. Please contact support with your order number and include photos/videos showing the issue (and the packaging/labels if possible). We will open an RMA and guide you through the exchange or return. In many cases, we provide a return label and replace the item once the RMA is approved, which helps minimize delay. Shipping delays of a few days can happen, but your exchange request should still be handled within the standard return window. Regarding quality and price: the product is designed as a basic standard item. If workmanship is not meeting your expectations due to a defect, the exchange/return is the right route. Send us the details and we will help you quickly.

M: OA-GPT-5-NAN
M: OA-GPT-5-NAN

Frequently Asked Questions

A

The BC-3 accepts 100–240 V AC at 50/60 Hz via a Europlug and uses a switch-mode power supply that automatically adapts to the mains voltage. Use a properly protected outlet and an RCD (30 mA) where applicable.

Is this answer helpful?

A

No. The BC-3 is designed for indoor use only and must be kept away from rain, moisture and high humidity. Exposure to liquids or fog jets can reduce insulation and create a risk of electric shock or damage.

Is this answer helpful?

A

No. The housing must never be opened by users. There are no serviceable parts inside; maintenance and repairs should only be performed by authorized service agents using original spare parts.

Is this answer helpful?

A

Hanging installations must use the mounting bracket and be secured with a secondary safety attachment (e.g., safety cable or catch net). Overhead rigging requires experienced personnel and installations must support at least 10x the device weight for one hour.

Is this answer helpful?

A

Regularly clean the exterior with a soft, damp, lint-free cloth. Do not use alcohol or solvents. Disconnect the device from mains before cleaning. Inspect power cables and mounting hardware periodically; replace damaged cables with approved replacements.

Is this answer helpful?

A

The BC-3 uses three 1 W LEDs (red, green, blue) and rotates the faceted head at approximately 30 revolutions per minute to produce circular beam effects. Power consumption is about 3.5 W.

Is this answer helpful?

A

Leave at least 50 cm of free space for ventilation, a minimum of 0.5 m from flammable materials, and at least 0.1 m between the light output and the illuminated object. Do not place the fixture where it may contact surrounding surfaces.

Is this answer helpful?

M: OA-GPT-5-NAN

Advantages and Disadvantages

Advantages

  • Compact, lightweight design (88 x 88 x 93 mm; 0.2 kg) — easy to transport and position.
  • Automatic 100–240 V switch-mode power supply — works worldwide without voltage switching.
  • Distinct mirror-ball beam effect with three 1 W RGB LEDs for colorful circular patterns.
  • Flexible installation: can be floor-mounted or hung via bracket (with proper rigging).
  • Low power consumption (3.5 W) while producing visible decorative lighting effects.
VS

Disadvantages

  • Not weatherproof — indoor use only; must be kept away from moisture and rain.
  • Hanging installation requires professional rigging and secondary safety attachments.
  • Not intended for continuous 24/7 operation; needs duty cycles to maximize life.
  • No user-serviceable parts inside — repairs require authorized service and original parts.
  • Limited output compared with larger fixtures — best for small venues or decorative use.
M: OA-GPT-5-NAN

Product Specification

Effects

Mirror Ball Emulator

Power Consumption

30W

Dimensions

3.46x3.66x3.46in (WxHxD)

Weight

0.44 lb

M: OA-GPT-54-NAN

Product Description

Eurolite LED BC-3 — Compact Beam Effect

The Eurolite LED BC-3 is a small, versatile beam-effect fixture designed to create vivid circular light patterns using a faceted mirror-ball head and three 1 W RGB LEDs. With a compact footprint (88 x 88 x 93 mm) and lightweight construction (0.2 kg), the BC-3 suits mobile DJs, small stages, bars and decorative lighting installations where dynamic, rotating beams are desired.

Key characteristics and usage

The unit runs from 100–240 V AC (50/60 Hz) via a Europlug and uses switch-mode power supply technology for automatic voltage adaptation. It rotates the faceted head at about 30 revolutions per minute, producing continuous circular effects in red, green and blue. The device can be placed on the floor or mounted using its bracket; hanging installation is supported but requires secure, professional rigging and a secondary safety attachment. The BC-3 is intended for indoor, professional-use environments (stages, clubs, theatres) and is not designed for continuous 24/7 operation — periodic rest improves service life.

Safety and installation notes

Follow strict safety guidelines: keep the fixture dry, avoid exposing it to direct fog/smoke jets (maintain at least 0.5 m distance), and ensure ventilation clearance of at least 50 cm to prevent overheating (max ambient 45 °C). Maintain a minimum distance of 0.1 m from illuminated objects and 0.5 m from flammable materials. The product is double-insulated (Class II) and requires a properly protected mains supply (RCD recommended). Do not open the housing; internal parts are not user-serviceable.

Maintenance and reliability

Cleaning is simple — use a soft, damp, lint-free cloth; do not use solvents or alcohol. Regular inspections of the power cable and mounting hardware are advised. Faulty power cords must be replaced with approved parts from an authorized dealer. Service and repairs should be performed only by qualified technicians using original spare parts.

Notes

  • Produces mirror-ball style beams with RGB mixing from three 1 W LEDs.
  • Rotation speed: ~30 RPM; power consumption: 3.5 W.
  • Indoor use only; designed for professional entertainment applications.
  • Always secure hanging installations with a secondary safety attachment and qualified rigging personnel.
M: OA-GPT-5-NAN

© Copyright 2026 Manual.ly