Manual.ly Logo

esotec Tower Light Duo Color Manual

0.0 · 0 Ratings

PDF manual · 1 Pages

English

M: OA-GPT-54-NAN
page

/ 1

Loading...
53479eea1bc4469d1ac88e65aba2f87080a3 page 1
Usage instructions
Solarlight “Tower Light Duo Color“
These instructions relate ONLY to this product and contain important infor-
mation for using the product for the first time. Please keep these instructions
for later reference and should always accompany the product in the event of
transference to a new user.
1. Introduction
Dear Costumer,
Thank you for purchasing the solar light.
With this solar light you purchased a product manufactured according to the
current state of technology.
This product fulfils all requirements of the valid European and
national regulations. The conformity was proved. The relevant
declarations and documentation are deposited with the manu-
facturer.
To maintain this state and guarantee a safe operation, you as the user will have
to follow this operating manual!
2. Safety Instructions
- In case of damages caused by not following this
operating manual, the warranty rights will expire!
We exclude liability for any consequential damages!
- We exclude liability for property or personal
damages caused by inappropriate handling
or not following the safety instructions.
- In these cases any guarantee rights will expire.
Due to safety and admission reasons (CE) it is not allowed to arbitrarily recon-
struct and/or change the solar light.
Therefore, please keep to the operating manual.
The accident prevention rules of the association of the industrial trade coope-
rative association for electric plants and working material are to be considered
in industrial environments
3. Usage in Accordance with Requirements
The solar light is constructed for the outdoor usage and operation. The
integrated accumulator is charged by the solar cell in the upper part of the
light. At darkness, the light is automatically switched on and is switched
out at sunrise. As light source, 2 very strong light emitting diode (LEDs) are
installed. These LEDs guarantee a strong luminosity with only low power
consumption.
-- However, please note that the duration of illumination may decrea-
se due to a lack of sunshine as well as in the winter months--
In case of longer periods without sunshine (insolation) the accumulator is
charged only insufficiently and is thus not able to guarantee a permanent
readiness for operation. However, this does not indicate that the solar light
is defect. Please wait for the next sunny days and the light will again be
working accordingly
4. Initiation
1. Please carefully take all parts out of the package.
2. Take out the plastic part (1) in the end of the metal tube.
Take the two platic parts apart (2) and press the ground
stik into the plastig part. Press the plastic part with
ground stik into the tube (3).
3. Hold the upper part and screw off the lower part of the
lamp head and take apart (4) the parts. Pull out the saftey
ap from the battery. With the switch you can select the
lighting color between cold and warmwhite (6). Take the
two parts together again, take both stainless steel tube
and light head together.
4. Please carefully connect the earth rod with the bar and
insert it into the ground.
Note: Please do not use force.
The solar light is now activated.
Note: The duration of illumination is strongly dependent on
the intensity and duration of sunshine during the day. During
the winter months the duration of illumination will generally
be shorter. If the lamp should not irradiate on the rst eve-
ning, please wait for a sunny day.
5. Exchange of Accumulator
1. Hold the upper part and screw off the lower part (1) of the lamp head and take
apart (2) the parts.
2. Take the used accumulator out of the battery compartment (3) and insert a new
accumulators according to polarity, into the battery compartment. It is recommen-
ded to charge the new accumulator in a battery charger before inserting them.
3. Re-assemble the lamp in reverse order.
Note: Used batteries or accumulators must be disposed of in a non-polluting way and
do not belong into the domestic waste. Your dealer is legally obliged to take back and
recycle old accumulators.
6. Malfunctions
-Lamp is not automatically switched on at darkness
• An outside light source (e.g. streetlight) simulates daylight and prevents the
lamp from switching on. Place the lamp at a darker location.
Lamp is not switched on at darkness or only for a short period of time.
• Battery safetyap drawn?
• Accumulator weak or defective. Exchange of the accumulators.
7. Technical Data
• Solar module: 300 mWp cristalline
• LED: Nichia LED
• Light angle: 120°
• Light color: 6500 K (coldwhite) or 2800 K (warmwhite)
• Light intensity: 15 lm / 13 lm
• Degree of protection: IP 44
• Protection class: III
• Battery: 1x NiMh 1.2 V/900 mAh (Micro AAA)
• Luminosity period: Max. 8 hrs with full battery
• Working temperature: -20°C bis + 40°C
Manufacturer - Spare parts
esotec GmbH - Weberschlag 9 - D-92729 Weiherhammer
Tel.-Nr: +49 9605-92206-0 Fax.-Nr: +49 9605-92206-10
e-mail:[email protected] Internet: www.esotec.de
Manufacturer Part- Nr: 102603
Rechargeable battery notes
- Rechargeable batteries should not be played with by children. Never leave rechar-
geable batteries lying around; they could be swallowed by children or pets.
- Rechargeable batteries must never be short-circuited, disassembled or thrown into
fire. This leads to a danger of explosion!
- Leaking or damaged rechargeable batteries can cause chemical burns when they
come into contact with skin. For this reason, please make use of suitable protective
gloves.
- Rechargeable batteries should only be replaced by structurally identical rechar-
geable batteries from the same manufacturer. Normal batteries must not be used
since these are not rechargeable.
- Make sure the rechargeable batteries are inserted with the correct polarity.
- For long periods of time of non-use (for example, storage), remove the inserted
rechargeable batteries to avoid damages via the leaking rechargeable batteries.
Disposal:
Dear customer,
please cooperate in avoiding waste. When you intend to dispose of the
product in future, please consider that it contains valuable raw materials
suited for recycling.
Therefore, do not dispose it of with domestic waste but bring it to a collec-
tion point for the recycling of waste electrical and electronic equipment.
Thank you very much for your cooperat
Copyright, esotec GmbH
!
GB
Battery Recycling:
• Used batteries or accumulators must be disposed in the
domestic waste.
• The consumer is legally obliged to bring back old accumu-
lators upon usage, e.g. to public waste collecting locations
or to the place (shops, etc.) where those batteries are sold.
• Batteries that contain harmful substances are marked
with the “strike through dustbin” and one of the chemical
symbols.
NiMh
1.
2.
3.
lighting color
switch
4.
6.
1.
2.
3.
5.

Chat with your esotec Tower Light Duo Color manual using AI

Get instant AI answers from your esotec Tower Light Duo Color manual

Ask anything about the esotec Tower Light Duo Color. Answers come from this manual, with the pages they are based on.

Ask a Question

0/1000

Do you recommend Tower Light Duo Color?

Yes No

Frequently Asked Questions

A

After assembling the lamp and pulling the battery safety tab, use the switch on the lamp head to select the lighting color. Warm-white is 2800 K for a softer glow, while cold-white is 6500 K for a brighter, cooler appearance.

Is this answer helpful?

A

The tower light switches on at darkness and turns off at sunrise. If you do not see it light up, it may be because there is an outside light source simulating daylight (such as a streetlight) or the accumulator charge is still insufficient.

Is this answer helpful?

A

Solar runtime depends on the intensity and duration of sunshine. In winter or during long periods without strong insolation, the accumulator charges only partially, leading to shorter illumination. This behavior indicates reduced charging conditions rather than a defect.

Is this answer helpful?

A

Wait for a sunny day so the accumulator can build charge. If you still have issues, check that the battery safety tab was removed, confirm the color switch setting, and ensure the lamp is placed where it can receive adequate daylight.

Is this answer helpful?

A

Unscrew and open the lamp head, remove the used accumulator, and insert a new NiMh rechargeable battery with correct polarity. It is recommended to charge the new accumulator before inserting it. Reassemble the lamp in reverse order.

Is this answer helpful?

A

No. The manual specifies using structurally identical rechargeable batteries from the same manufacturer. Normal batteries must not be used because they are not rechargeable and can cause unsafe operation or improper performance.

Is this answer helpful?

A

Do not dispose of used batteries or accumulators with domestic waste. Use proper recycling collection points. Dealers may be legally required to take back used accumulators, helping ensure safe handling and recovery of materials.

Is this answer helpful?

M: OA-GPT-54-NAN

Advantages and Disadvantages

Advantages

  • Automatic charging and switching on at darkness and off at sunrise for convenient use.
  • Duo Color selection lets you choose warm-white (2800 K) or cold-white (6500 K).
  • Wide 120 degree beam angle with low power LED lighting for effective pathway illumination.
  • Outdoor suitable with IP44 protection; stainless steel/metal construction supports durable placement.
  • Accumulator replacement is possible, extending service life when used correctly.
VS

Disadvantages

  • Illumination duration depends on sunshine; cloudy weather and winter can significantly shorten runtime.
  • Exterior light sources (for example, nearby streetlights) may prevent the lamp from switching on.
  • First-evening lighting may be absent until the accumulator has been sufficiently charged by sun.
  • Battery replacement and disposal require attention to polarity and proper recycling rules.
M: OA-GPT-54-NAN

Product Specification

Type

Path light

Old energy efficiency class for built-in light source

A++, A+, A (A++ to E)

Permanently installed LEDs

yes

Socket

no

Light source

LED (permanently installed light source), warm white (2800K), 10lm

Total luminous flux

10lm

Material

Stainless steel

Color

stainless steel

Design

round

Special features

Battery operation, Solar operation, integrated light sensor

Degree of protection

IP44

Protection class

3

Dimensions

3.54x23.23in (DxH)

M: GO-GEM-FL-25

Product Description

esotec Tower Light Solar Pathway light Stainless steel warm-white Manual

If you want reliable outdoor ambience without cabling, the esotec Tower Light Solar Pathway light Stainless steel warm-white is a smart choice. Designed for pathway and garden use, this solar tower light charges its integrated accumulator during the day and then automatically switches on at darkness and off again at sunrise.

A standout feature is the Duo Color lighting concept. You can select the atmosphere you prefer by using the switch on the lamp head: warm-white (2800 K) for a cozy, inviting glow, or cold-white (6500 K) for a brighter, more crisp look. The light uses two strong LEDs with a wide 120 degree beam angle, delivering a visible effect while keeping power consumption low.

Practical performance matters with solar lighting, and this model is transparent about what affects run time. Illumination length depends on the intensity and duration of sunshine during the day. In winter months or extended cloudy periods, the accumulator may charge less, so you may experience shorter evenings of light. This is not considered a defect; after sunny days, the light returns to normal operation.

Getting it ready is straightforward. Assemble the tube and lamp head, connect the earth rod to the bar, and insert it into the ground without forcing anything. When first used, pull the safety tab from the battery compartment and then choose your preferred color mode. If the light does not shine on the first evening, simply wait for a sunny day before judging performance.

For long-term use, the accumulator can be replaced. Unscrew the lamp head, remove the used accumulator, insert a new one with correct polarity, and reassemble in reverse order. Charging the new accumulator in a suitable charger is recommended. Old batteries and accumulators must be disposed of properly via recycling routes, not domestic waste.

Key results

  • Warm-white mode (2800 K) with selectable cold-white (6500 K) for flexible garden ambience.
  • Auto on at darkness and off at sunrise with wide 120 degree LED illumination.
  • Weather-ready outdoor use with IP44 protection and durable metal/stainless steel construction.
  • Up to 8 hours possible on a full charge, with shorter evenings when sunshine is limited.

Notes

  • Keep the manual for future users and avoid unauthorized modifications (safety and warranty implications).
  • Strong outside light can delay switching; place the light in a darker location for reliable activation.
  • Use structurally identical NiMh rechargeable batteries when replacing, and follow correct polarity.
M: OA-GPT-54-NAN

© Copyright 2026 Manual.ly