Manual.ly Logo

Einhell CC-BC 5 Manual

4.5 · 10 Ratings

PDF manual · 72 Pages

English

M: OA-GPT-54-NAN
page

/ 72

Loading...
5bad8e6fd5f302a402d1fa5b06a5821e05e4 page 5
D
- 5 -
Bei alten Batterien, bei denen der Ladestrom
nicht zurückgeht, liegt ein Defekt vor, wie
Zellenschluss oder Altersschaden.
Der Ladestrom sollte 1/10 bis 1/6 der Batterieka-
pazität betragen.
Achtung! Ladezeit nicht überschreiten. Nach
dem Ladezeitende den Netzstecker aus der
Steckdose ziehen und das Ladegerät von der
Batterie trennen.
Der genaue Ladezustand kann nur durch Messen
der Säuredichte mit einem Säureheber ermittelt
werden.
Hinweis! Beim Ladevorgang werden Gase frei
(Bläschenbildung an der Oberfl äche der Batte-
riefl üssigkeit). Achten Sie daher auf gute Belüf-
tung in den Räumen.
Werte der Säuredichte (kg/l bei 20°C)
1,28 Batterie geladen
1,21 Batterie halb geladen
1,16 Batterie entladen
5.2 Laden der Batterie beenden
•
Ziehen Sie den Netzstecker aus der Steck-
dose.
•
Lösen Sie zuerst das schwarze Ladekabel
von der Karrosserie.
•
Anschließend lösen Sie das rote Ladekabel
vom Pluspol der Batterie.
•
Achtung! Bei positiver Erdung lösen Sie
zuerst das rote Ladekabel von der Karosse-
rie dann das schwarze Ladekabel von der
Batterie.
•
Batteriestopfen wieder aufschrauben oder
aufdrücken (falls vorhanden).
6. Überlastschutz
Bild 3:
Die eingebaute Flachsicherung schützt das Gerät
vor Falschpolung und Kurzschluss. Bei einem
Defekt der Sicherung muss diese ausgewechselt
und durch eine Sicherung mit gleichen Ampere-
wert ersetzt werden. Beim Auswechseln der
Flachsicherung muss zuerst der Netzstecker aus
der Steckdose gezogen und die Ladeklemmen
von der Batterie abgenommen werden. Bei ther-
mischer Überlastung unterbricht ein selbsttätig
schaltender Schutzschalter die Aufl adung. Nach
einer Abkühlpause schaltet dieser wieder selbst-
tätig ein.
7. Wartung und Pfl ege der Batterie
•
Achten Sie darauf, daß Ihre Batterie immer
fest eingebaut ist.
•
Eine einwandfreie Verbindung an das Lei-
tungsnetz der elektrischen Anlage muss
gewährleistet sein.
•
Batterie sauber und trocken halten. An-
schlussklemmen mit einem säurefreien und
säurebeständigen Fett
(Vaseline) leicht einfetten.
•
Bei nicht wartungsfreien Batterien ca. alle 4
Wochen Höhe des Säurestandes prüfen und
bei Bedarf nur destilliertes Wasser nachfüllen.
8. Reinigung, Wartung und
Ersatzteilbestellung
Gefahr!
Ziehen Sie vor allen Reinigungsarbeiten den
Netzstecker.
8.1 Reinigung
•
Halten Sie Schutzvorrichtungen, Luftschlitze
und Gehäuse so staub- und schmutzfrei wie
möglich. Reiben Sie das Gerät mit einem sau-
beren Tuch ab oder blasen Sie es mit Druck-
luft bei niedrigem Druck aus.
•
Wir empfehlen, dass Sie das Gerät direkt
nach jeder Benutzung reinigen.
•
Reinigen Sie das Gerät regelmäßig mit einem
feuchten Tuch und etwas Schmierseife. Ver-
wenden Sie keine Reinigungs- oder Lösungs-
mittel; diese könnten die Kunststoffteile des
Gerätes angreifen. Achten Sie darauf, dass
kein Wasser in das Geräteinnere gelangen
Anl_CC_BC_5_12_SPK1.indb 5Anl_CC_BC_5_12_SPK1.indb 5 09.03.16 09:0109.03.16 09:01

Chat with your Einhell CC-BC 5 manual using AI

Get instant AI answers from your Einhell CC-BC 5 manual

Ask anything about the Einhell CC-BC 5. Answers come from this manual, with the pages they are based on.

CC-BC 5 Maintenance Schedule

Remind me when maintenance is due
Every 4 weeks
Check acid level in non-maintenance-free batteries

Check the acid level approximately every 4 weeks and top up with distilled water if necessary.

After each use
Clean device after use

We recommend cleaning the device immediately after each use. Keep safety devices, air vents, and housing free of dust and dirt.

Regularly
Clean device regularly

Clean the equipment regularly with a moist cloth and soft soap. Do not use cleaning agents or solvents.

As needed
Clean charging terminals

Remove any corrosion from the charging terminals during storage or cleaning.

Free maintenance reminders

Timed to your purchase date. Always free, unsubscribe anytime.

By submitting you agree to the privacy policy. Unsubscribe with one click in any email.
M: QW-35-FL

Ask a Question

0/1000

Do you recommend CC-BC 5?

Yes No
0
User Pic

thibault39

9 months ago

Will this Einhell CC-BC 5 charger work with AGM or gel batteries, and does it stop charging automatically when the battery is full?

0
User Pic

Manual.ly

9 months ago

The CC-BC 5 is primarily designed for common lead-acid battery types (check the exact battery chemistry and voltage ratings listed in the manual for this model). Some reviews indicate not all modern battery variants (for example certain gel/AGM types) can be charged reliably, so compatibility depends on your battery's specifications. Also note that charging may not automatically stop at full charge, so for battery types that are not clearly supported, it is recommended to monitor the process (for example using the displayed charging current) and stop charging when the battery is fully charged. Always follow the manual for your specific battery to avoid overcharging.

M: OA-GPT-5-NAN
M: OA-GPT-5-NAN

Frequently Asked Questions

A

It is designed for 12V lead-acid starter batteries used in vehicles. It can work with non-maintenance-free batteries directly, and maintenance-free versions only with careful monitoring. It is not intended for AGM or gel batteries.

Is this answer helpful?

A

The instructions recommend disconnecting the battery from the vehicle’s electrical system before charging. This helps protect onboard electronics such as ABS, ASR, injectors, and the computer from voltage spikes.

Is this answer helpful?

A

Connect the red cable to the battery’s positive pole first. Then connect the black cable to the car body or the negative pole, depending on the vehicle’s grounding setup. Always avoid sparks and open flames.

Is this answer helpful?

A

Charging time depends on battery capacity and how empty the battery is. The manual gives a rough formula based on battery Ah and charging current. Older batteries may charge abnormally if there is a fault.

Is this answer helpful?

A

It includes a flat fuse that helps protect against reverse polarity and short circuits. A thermal protection switch also interrupts charging if the unit overheats and restarts automatically after cooling.

Is this answer helpful?

A

The charging current drops as the battery fills up. For a more exact check, the manual suggests measuring acid density with a battery tester. Typical values are given for charged, semi-charged, and discharged states.

Is this answer helpful?

A

Keep the battery clean, dry, and securely installed. Lightly grease the terminals with acid-resistant grease. Store the charger in a dry place and clean the clamps regularly to prevent corrosion.

Is this answer helpful?

M: OA-GPT-54-NAN

Advantages and Disadvantages

Advantages

  • Simple 12V charging solution for common lead-acid starter batteries.
  • Charging current indicator helps monitor the process at a glance.
  • Built-in fuse and overload protection improve basic safety.
  • Carry handle makes the charger easy to move and store.
VS

Disadvantages

  • Not suitable for AGM or gel batteries.
  • Maintenance-free batteries require close supervision during charging.
  • Must be used in dry indoor spaces only.
  • Battery should often be disconnected from vehicle electronics before charging.
M: OA-GPT-54-NAN

Product Specification

Battery voltage

12V

Charging current max.

5A

Battery capacity

16-80Ah

Display

Pointer

Color

red, black

Dimensions

7.60x4.96x8.35in (WxHxD)

Weight

4.50lb

M: OA-GPT-54-NAN

Product Description

Einhell CC-BC 5 Battery Charger

The Einhell CC-BC 5 Battery Charger is a straightforward and practical solution for charging 12V starter batteries used in everyday vehicles. Built for lead-acid batteries, it is designed with simplicity in mind, making it a useful choice for drivers who want a reliable charger for regular battery care. If you are looking up the Einhell CC-BC 5 Battery Charger Manual, the key idea is clear: this charger is meant for safe, controlled charging with basic but important protection features.

Designed for everyday battery care

This charger supports non-maintenance-free 12V starter batteries and can also be used with maintenance-free versions, provided the charging process is watched carefully. The unit is not intended for AGM or gel batteries, so it is best suited to traditional automotive battery types. Its output is compact and modest, which makes it well matched to smaller battery capacities and normal household vehicle use.

The charger includes a charging current indicator, a carry handle, red and black charging cables, and a flat fuse for protection against reverse polarity and short circuits. These features keep the device easy to understand and practical for routine use. The instructions also stress that the battery should ideally be disconnected from the vehicle’s electrical system before charging, especially because modern cars often contain sensitive electronics.

Safe use and charging behavior

One of the most important points is correct connection order: red to positive, black to the vehicle body or negative side depending on grounding. The charger works from a standard 230V supply and should only be used in dry indoor spaces. During charging, gas may form, so ventilation and spark-free conditions are essential. The text also explains that charge time depends on battery size and state of discharge, with older batteries sometimes revealing faults if the current does not drop as expected.

Maintenance and long-term care

The charger itself needs very little maintenance, but battery care matters. Batteries should be kept clean, dry, and securely installed. For serviceable batteries, electrolyte levels should be checked regularly and topped up with distilled water when needed. Cleaning the charger after use and storing it in a dry place helps preserve performance and extend service life.

Notes

  • Not suitable for AGM or gel batteries.
  • Always observe polarity and ventilation requirements.
  • Disconnect the battery from the vehicle when possible before charging.
  • Do not exceed the recommended charging time.
M: OA-GPT-54-NAN

© Copyright 2026 Manual.ly