Manual.ly Logo

EASYmaxx SUP Board Manual

0.0 · 0 Ratings

PDF manual · 44 Pages

English

M: OA-GPT-5-NAN
page

/ 44

Loading...
a95b4e16833bd723ad392d6ed71d707c08e3 page 10
EN 18
Infl ate
1. Remove the SUP board from the carrier bag and spread it out on a smooth surface
that is free of sharp or pointed objects.
2. Put the air pump hose on the connector (Picture B) and twist clockwise to secure.
3. Unscrew the protective cap on the stern of the SUP board, put the hose on the valve,
push down and twist clockwise to secure (Picture C). The bayonet adapter must be
correctly seated in the valve.
4. Place the air pump on solid, even ground and fi x at the foot part with the feet.
NOTICE – Pressure that is too high can cause material damages! Do not use an air
compressor. The maximum air pressure for this SUP board is 15 psi / 1 bar. Never pump
over 15 psi / 1 bar!
5. Grab the handle and pump air into the SUP board by moving the handle up and down.
The higher the pressure in the SUP board, the more diffi cult it will be to pull the
handle of the pump. In this case, open the bridge opening. Now, air will only pump
into the board when the handle is pushed downwards, but it will be easier to bring
the handle back upwards.
6. Once the SUP board is completely infl ated, unscrew the bayonet adapter from the valve.
7. If the valve pin doesn’t turn back into the proper position and air begins to escape,
turn the pin a bit until the spring comes up. Now the valve is closed. It is possible, in
this case, that it will need a little more air.
8. Place the protective cover back on the valve and screw shut.
Inserting / removing the fi ns
When replacing the fi ns, make sure that the tips of the fi ns are pointing downwards.
1. Place the SUP board so that the fi n box is facing upwards.
2. Push one fi n directly into the guide of the fi n box (Picture D1) until it is fully seated
in the rail.
3. The fi n must be anchored with the locking pin (Picture D2). To do this, put it into the
opening until it audibly clicks into place.
4. Attach the other two fi ns into the fi n boxes in the same way.
To remove the fi ns, remove the locking pins by lightly pushing down and then pulling out,
and then push the fi ns out of the rails.
Attaching the leash
Never use the SUP board without having one leash on board and a foot loop attached
to the user! In some countries, this is a law - fi nd out what the local regulations are and
observe them!
• Pull the fabric band on the leash through the ring on the stern of the SUP board and
attach the leash.
• Place the foot loop around the ankle and fi x it using the hook and loop fastener strap.

Chat with your EASYmaxx SUP Board manual using AI

Get instant AI answers from your EASYmaxx SUP Board manual

Ask anything about the EASYmaxx SUP Board. Answers come from this manual, with the pages they are based on.

SUP Board Maintenance Schedule

Regularly
Inspect the SUP board and accessories for damage

Check the SUP board and all accessories regularly. Do not use the board if visible damage is present.

Show in the manual (page 16)
Regularly
Rinse the SUP board, fins and paddle

Rinse with clear water regularly. Use a mild cleaning agent for heavier soiling.

Show in the manual (page 20)
M: gpt-5.6-terra

Ask a Question

0/1000

Do you recommend SUP Board?

Yes No

Video Manual

Tips for beginner #paddleboarders #outdoormaster #paddleboard #paddleboarding #standuppaddleboarding

Frequently Asked Questions

A

The recommended maximum operating pressure is 15 psi (1.0 bar). Do not use an air compressor and never exceed 15 psi to avoid material damage.

Is this answer helpful?

A

The board is intended for one adult user aged 14 or older. The total maximum load (user plus gear) is 110 kg (242 lbs). It is for private use only, not commercial.

Is this answer helpful?

A

Use the included repair kit: locate the leak (soapy water helps), deflate the board, clean the area with acetone, cut a suitably sized rounded patch, apply adhesive, let it tack 5–8 minutes, press the patch from center out and let the board rest uninflated ~24 hours.

Is this answer helpful?

A

Always wear a leash and life jacket, avoid use in winds over 10 knots, heavy rain or storms, ensure all air chambers are fully inflated, do not use under alcohol or drug influence, and practice in calm shallow water before deeper or busier areas.

Is this answer helpful?

A

Remove fins and leash, deflate fully, fold starting at the bow so air can escape via the stern valve, avoid sharp folds, secure with the strap and place in the carrying bag when dry. For long-term storage, roll loosely or store flat to prevent permanent creases.

Is this answer helpful?

A

Leaks can occur around the valve edge if the valve core loosened — use the valve key to tighten clockwise. If air escapes from inside the valve, press the valve pin to reseat it or remove, inspect and reposition the seal with the valve key, then reinflate and retighten.

Is this answer helpful?

A

Rinse board, fins and paddle with fresh water after use, avoid abrasive cleaners, dry all parts fully before storage, protect from prolonged sun, heat, frost and sharp impacts, and routinely inspect for damage to repair early.

Is this answer helpful?

M: OA-GPT-5-NAN

Advantages and Disadvantages

Advantages

  • Complete kit (board, 3-part paddle, pump with manometer, fins, leash, repair kit, bag) for immediate use.
  • Portable and stowable: folds to fit the included carrying bag for easy transport and storage.
  • Clear maintenance and repair instructions with a repair kit for small punctures and valve troubleshooting.
  • Beginner-friendly guidance: paddle adjustment, mounting tips, and safety limits for calm-water practice.
  • Pumped rigidity up to 15 psi (1.0 bar) provides stability while remaining lightweight for carrying.
VS

Disadvantages

  • Not suitable for children under 14 or for commercial use — limited to single adult recreational use.
  • Unsuitable for rapids, breaking waves, strong currents or winds over 10 knots.
  • Maximum load of 110 kg restricts heavier users or carrying large gear loads.
  • Repairs on seams or larger damage require professional service; kit only for small punctures.
  • Sensitive to heat, prolonged sun exposure, frost and rough surfaces — needs careful handling and storage.
M: OA-GPT-5-NAN

Product Specification

Type

SUP Board

Length

125.98 in

Weight

28.66 lb

M: OA-GPT-54-NAN

Product Description

EASYmaxx SUP Board Manual — Overview and Handy Guide

The EASYmaxx SUP Board is an inflatable stand-up paddleboard designed for recreational paddling on calm waters deeper than 20 cm. Lightweight and portable, it comes as a complete kit with a three-piece adjustable paddle, double-action pump with manometer, three fins (two small, one large), leash, repair kit, carrying bag and straps — everything you need for day trips, fitness paddling or relaxed cruising. The board supports a maximum load of 110 kg (242 lbs) and is intended for single adult users aged 14 and up. It is built for private, non-commercial use and is not suitable for rapids, breaking waves or strong currents.

Assembly and inflation are straightforward: assemble the paddle by locking its three parts, attach the hose to the pump and the bayonet adapter to the valve, and pump to a maximum of 15 psi (1.0 bar). The manual explains using the bridge opening on the pump to ease operation as pressure rises, and how to reseat the valve pin if it leaks. Three fins slide into fin boxes and are secured with locking pins; removal is equally simple.

Safety guidance emphasizes wearing a leash and life jacket, keeping the leash out of reach of children and pets, avoiding use in winds above 10 knots or storms, and never using the board under the influence of alcohol, drugs or medication. Users should practice mounting, steering and stopping in calm, shallow water before venturing into deeper or busier areas. Even distribution of weight is critical to avoid tipping, and heavier loads should be centered under the front elastic straps.

Care, storage and maintenance instructions include rinsing the board, fins and paddle with fresh water, avoiding abrasive cleaners, fully drying all parts before packing, and loosely rolling or storing flat to prevent permanent creases. The supplied repair kit (PVC patches, glue, valve key) and step-by-step patching instructions let users fix small punctures; valve tightening and troubleshooting steps are also detailed. For major seam or structural damage, the manual advises contacting customer service or a qualified repair shop. Finished boards and accessories should be disposed of in an environmentally friendly manner when no longer usable.

Notes:

  • Max load: 110 kg / 242 lbs; single adult user only.
  • Max inflation: 15 psi / 1.0 bar — do not exceed.
  • Recommended: certified surf-school training before first use.
  • Always wear leash and appropriate buoyancy aid; follow local water regulations.
M: OA-GPT-5-NAN

© Copyright 2026 Manual.ly