Manual.ly Logo

Candy HCT827XL/E Manual

0.0 · 0 Ratings

PDF manual · 66 Pages

English

M: QW-35-FL
page

/ 66

Loading...
4e50dc921b85f7a6a4ea26d0beff712b442d page 10
7. CLEANING AND MAINTENANCE
7.1 GENERAL
Before starting to clean your oven, be sure that all control knobs
are off and your appliance is cooled off. Unplug the appliance.
Do not use cleaning materials containing particles that might
scratch the enamelledand painted parts of your oven. Use cream
cleaners or liquid cleaners, which do not contain particles.
As they might harmthe surfaces, do not use caustic creams,
abrasive cleaning powders, rough wire wool or hard tools. In the
event the excess liquids spilling over your oven should burn, it may
cause a damage to the enamel. Immediately clean up the spilt
liquids.
7.2 CLEANING THE OVEN
Make sure to unplug the oven before starting to clean it.You will
obtain best results if you clean the oven interior while the oven is
slightly warm. Wipe your oven with a soft piece of cloth dampened
with soap water after each use. Then wipe it again, this time with a
wetted cloth, and wipe it dry. A complete cleaning may be
necessary from time to time, using a liquid cleaning material. Do
not clean using dry and powder type cleaners. For products with
catalytic enamel frames, the rear and side walls of the inner frame
do not require cleaning. However; depending on usage, it is
recommended that you replace them after a certain period of time.
7.3 CLEANING THE VITROCERAMIC HOB
7.4 MAINTENANCE
Replacing the Oven Light Bulb
It is recommended that you leave this operation to the Authorised
Service.
Unplug the oven first and make sure that it is cold. After removing
the lid infront of the light, take the bulbout. Insert the new bulb
0
resistant to 300 C, which you will find at Authorised Services, into
the place of the bulb you have removed. Then fit the light
protecting lid back into its place. After that, your oven will be ready
for use.
8. SERVICE AND TRANSPORTATION
8.1 REQUIREMENTS BEFORE CONTACTING
TO SERVICE
If the oven does not operate ;
The oven may be plugged off, there has been a black out.
If the oven does not heat ;
The temperature may be not adjusted with oven’s temperature
control switch.
If the oven light does not operate does not light;
The electricity should be controlled.
It should be controlled whether the ulb is defective.
Cooking (If lower-upper part does not cook equally) ;
Control the shelf locations, cooking period and temperature
values according to the manual. In case of the product doesn't
work properly and malfunctioning causes cannot be found, switch
off the product. Please do not tamper with it and call the Technical
Service.
It is important to communicate to Authorized Technical Service the
product model and it's serial number that can be found on the
rating label.
8.2 INFORMATION RELATED TO TRANSPORT
If you need any transport ;
Keep the original packaging of product and carry it with its original
packaging when needed.
Follow the transport signs on the packaging.
If the original packaging is not available;
Take measure for the external surfaces (glass and painted
surfaces) of oven and hob aganist possible blows.
15 GB
. Before carrying out any maintenance work on the hob, allow it
to cool down.
. Only products, (creams and scrapers) specifically designed for
aglass ceramic surfaces should be used. They are obtainable
from hardware stores.
. Avoid spillages, as anything which falls on to the hob surface
will quickly burn and will make cleaning more difficult.
. It is advisable to keep away from the hob all substances which
are liable to melt, such as plastic items, sugar, or sugar-based
products.
.MAINTENANCE:
- Place a few drops of the specialised cleaning product on the
hob surface.
- Rub any stubborn stains with a soft cloth or with slightly damp
kitchen paper.
- Wipe with a soft cloth or dry kitchen paper until the surface is
clean.
If there are still some stubborn stains:
- Place a few more drops of specialised cleaning fluid on the
surface.
- Scrape with a scraper, holding it at an angle of 30° to the hob,
until the stains disappear.
- Wipe with a soft cloth or dry kitchen paper until the surface is
clean.
- Repeat the operation if necessary.
A FEW HINTS:
Frequent cleaning leaves a protective layer which is essential to
prevent scratches and wear. Make sure that the surface is clean
before using the hob again. To remove marks left by water, use
a few drops of white vinegar or lemon juice. Then wipe with
absorbent paper and a few drops of specialised cleaning fluid.
The glass ceramic surface will withstand scraping from flat-bot-
tomed cooking vessels, however, it is always better to lift them
when moving them from one zone to another.
NB:
Do not use a sponge which is too wet.
Never use a knife or a screwdriver.
A scraper with a razor blade will not damage the surface, as long
as it is kept at an angle of 30°.
Never leave a scraper with a razor blade within the reach of
children.
Never use abrasive products or scouring powders.
. The metal surround : to safely clean the metal surround wash
with soap and water, rinse, then dry with a soft cloth.
Any change in the colour of the glass-ceramic surface
does not affect its operation or the stability of the surface.
Such discolorations are mostly a result of burnt food
residues or use of cookware made of materials such as
aluminium or copper; these stains are difficult to remove.
30° Maxi

Chat with your Candy HCT827XL/E manual using AI

Get instant AI answers from your Candy HCT827XL/E manual

Ask anything about the Candy HCT827XL/E. Answers come from this manual, with the pages they are based on.

HCT827XL/E Maintenance Schedule

After each use
Clean the oven interior

Wipe the oven with a soft cloth dampened with soapy water after each use. Then wipe with a wetted cloth and dry it.

Show in the manual (page 16)
From time to time
Complete cleaning of the oven

Perform a complete cleaning using a liquid cleaning material. Do not use dry or powder type cleaners.

Show in the manual (page 16)
As needed
Replace catalytic lining panels

For models with catalytic enamel frames, replace the rear and side walls after a certain period depending on usage.

Show in the manual (page 16)
After each use
Clean the vitroceramic hob

Allow the hob to cool down. Apply specialized cleaning fluid, rub stains with a soft cloth, and scrape if necessary at a 30-degree angle.

Show in the manual (page 16)
When required
Replace the oven light bulb

Unplug the oven and let it cool. Remove the lid, take out the old bulb, and insert a new bulb resistant to 300°C.

Show in the manual (page 16)
M: qwen/qwen3.8-flash

Ask a Question

0/1000

Do you recommend HCT827XL/E?

Yes No

Frequently Asked Questions

A

Aquactiva uses steam generated from 300ml of water to soften food residues and fat inside the oven, making cleaning easier after a 30-minute cycle.

Is this answer helpful?

A

No, never line the oven walls with aluminum foil. It can melt against the hot enamel, causing permanent damage and potentially ruining the coating.

Is this answer helpful?

A

Ensure the shelf stop is directed upwards and inserted completely into the cavity. The special profile helps shelves stay horizontal even when fully extended.

Is this answer helpful?

A

This is normal. The bonding agent for the insulating panels burns off during the first heating. Wait for fumes to clear before cooking food.

Is this answer helpful?

A

Children under 8 should not use the oven unsupervised. Accessible parts get very hot, so keep them at a safe distance during and after cooking.

Is this answer helpful?

A

Clean the oven after each use to prevent burnt-on grease. A deep clean with the Aquactiva function can be done periodically to maintain hygiene.

Is this answer helpful?

M: QW-35-FL

Advantages and Disadvantages

Advantages

  • Aquactiva steam function simplifies cleaning by loosening fat and residue
  • Shelf safety system prevents racks from falling out when pulled out
  • Versatile cooking functions including grill, fan, and pizza settings
  • Energy-saving tips like residual heat cooking reduce electricity usage
  • Glass-ceramic hob heats quickly and is easy to wipe clean
VS

Disadvantages

  • Requires professional installation for safe electrical connection
  • Oven door and parts become extremely hot during operation
  • Aluminum foil cannot be used inside the oven as it damages enamel
  • Cleaning agents must be non-abrasive to avoid scratching surfaces
  • Initial burning smell may occur during first use due to insulation heating
M: QW-35-FL

Product Specification

Energy efficiency class

A

Color

stainless steel, black

Capacity

70 L

Number of programs

5

Programs

Defrost, Grill, Convection, Top/Bottom heat, Pizza

Door system

hinge at bottom

Drawer system

telescopic runner (1-way)

Steam system

no

Cleaning

coated oven walls (enamel), hydrolysis (Aquactiva)

Display

yes

Features

retractable rotary knobs, timer, clock display, cool front

Cooktop control

yes

Energy consumption conventional heating

3.96 kWh/cycle

Energy consumption convection

3.40 kWh/cycle

Cutout dimensions

23.62x23.62 in (WxD)

M: QW-35-FL

Product Description

Candy HCT827XL/E Built-in Oven - Read, Download & Print Free

Welcome to the ultimate guide for the Candy HCT827XL/E Built-in Oven. This appliance represents a perfect blend of modern design and functional efficiency, designed to elevate your culinary experiences in any kitchen. Whether you are baking delicate pastries or grilling hearty meals, this oven provides the versatility needed for every cooking style.

The Candy HCT827XL/E features a sophisticated control panel that allows for precise temperature management and function selection. From static cooking with fan assistance to powerful grilling modes, the options are tailored to meet diverse dietary needs. The integrated Aquactiva function is a standout feature, utilizing steam to loosen stubborn food residues and fat, making post-meal cleanup significantly easier. This eco-friendly cleaning method reduces the need for harsh chemicals while maintaining the pristine condition of your oven interior.

Safety is paramount in the design of this unit. The shelf safety system ensures that racks remain stable even when fully extended, preventing accidental spills. Additionally, the glass-ceramic hob included in many configurations offers rapid heating and easy maintenance, provided it is cared for according to specific guidelines. The installation process requires careful attention to ventilation and electrical connections to ensure optimal performance and longevity. Always refer to the detailed instructions regarding wiring and positioning to avoid overheating or electrical hazards.

Maintaining your Candy HCT827XL/E is straightforward. Regular cleaning with non-abrasive materials will keep the enamel and glass surfaces looking new. Avoid using sharp tools or abrasive powders that could scratch the surfaces. For deep cleaning, the catalytic self-cleaning panels (if equipped) can help break down grease automatically during high-temperature cycles. Remember to always disconnect power before performing any maintenance tasks to ensure personal safety.

With its robust build quality and user-friendly interface, the Candy HCT827XL/E stands out as a reliable companion for home chefs. By following the recommended usage and care tips found in the manual, you can enjoy years of delicious cooking without interruption. This device is not just an appliance; it is a tool that empowers creativity in the kitchen.

M: QW-35-FL

© Copyright 2026 Manual.ly