Manual.ly Logo

Broil King Regal 590 Pro Manual

0.0 · 0 Ratings

PDF manual · 36 Pages

English

M: OA-GPT-5-NAN
page

/ 36

Loading...
35c912da3e90db5032fe685a106b4b329510 page a
MAINTENANCE
10
REGULAR MAINTENANCE
The following components should be inspected and cleaned
(as necessary) before every usage of your gas grill to ensure
optimal performance, safety and efficiency.
STAINLESS STEEL COOKING GRIDS
Brush grids with a long-handled stainless steel grill brush to
remove loose debris. Next, perform a Burn-Off (see below).
After the Burn-Off and while grill is still hot, brush the grids
again to remove any remaining debris. As the grill is hot,
use caution and oven mitts while handling the brush.
CAST IRON COOKING GRIDS
All OMC cast iron cooking grids are coated with a durable
porcelain enamel finish to protect the grids and reduce the
tendency of food sticking to grids. With all OMC cast iron
cooking grids instead of burning off your grill after each
usage, we recommend leaving food residue on grids and
performing a Burn-Off (see below) before each use; this
helps build up a protective layer of oil on the grids and will
aid in preventing rust and deterioration.
Cast iron grids should be seasoned before every use by
wiping or spraying them with vegetable or olive oil. Ensure
that the whole surface of the grid is covered by a light layer
of oil. This helps prevent rusting and deterioration. If rusting
does occur, scrape it off gently with a scrub pad and season
thoroughly. During longer periods of inactivity, grids should
be seasoned, wiped dry then stored in a dry place. Before
first usage and after periods of storage, grids should be
washed (see “Cooking Grids” to right), dried with paper towel
then wiped down thoroughly with vegetable shortening or
olive/vegetable oil.
FLAV-R-WAVE™
If residue accumulates on the Flav-R-Wave™, remove the
cooking grids and scrape the residue off the Flav-R-Wave™
with a grill brush.
GREASE TRAY
The grease tray is located directly under the drainage hole
on the bottom of the gas grill. It is accessible from the side or
rear of the appliance and should be cleaned or replaced
regularly to avoid grease overflowing onto your patio.
GENERAL CLEANING
Perform a Burn-Off (see below). When gas grill is cool,
remove grids, scrape the Flav-R-Wave™ clean then remove
it. Clean the interior of the gas grill as necessary by scraping
the sides and bottom of the cook box and vacuuming.
BURN-OFF
Ignite the burners as per “Lighting” (page 6). Operate gas
grill on HIGH with lid closed for 10 min. or until smoking
stops. Turn the gas source off then turn control knobs to
OFF.
ANNUAL MAINTENANCE
The following components should be inspected and cleaned
at least once a year or after any period of storage over 30
days to ensure optimal performance, safety and efficiency.
BURNER
Remove burner and inspect for cracks and deterioration.
Clean venturi tubes using a pipe cleaner or venturi brush to
eliminate any blockages. See “Venturi Tubes.” (Page 6)
While the burner is removed, clean the interior of cook box
by scraping the sides and bottom of the cook box and
vacuuming.
HOSE
Inspect and replace if necessary. For propane see “Hose
and Regulator.” (Page 4)
EXTERIOR FINISH
If white oxidation spots appear, wash the outside of the cook
box with a mild soap and water solution. Rinse the surfaces
thoroughly then wipe them with a cloth dipped in cooking oil
to restore the luster. For repair of paint scratches and scuffs,
use a good quality HIGH temperature (600°F) spray paint for
touch-up. Rusting is a natural oxidation process and may
appear on cast-iron and steel parts. Rust will not affect short
term performance of your grill.
STAINLESS STEEL
Wash with soap and water. Use stainless steel cleaner to
polish and remove stains or marks. Weathering and extreme
heat can cause a stainless steel lid to turn a tan color. This is
discoloration and is not considered a manufacturing defect.
RESIN COMPONENTS AND SIDE SHELVES
Wash with soap and water.
REPLACEMENT PARTS
If a problem is found with the regulator, hose, burner, or
control valves, do not attempt repair. See your dealer,
approved service center, or contact the factory for repairs or
replacement parts. To ensure optimum performance, use
only original OMC replacement parts.
LEAK TEST
When reconnecting a gas cylinder on propane models, be
sure to check for leaks. See “Leak Testing.” (Page 5)
COOKING GRIDS
To wash stainless or cast iron grids, use a light detergent
and water and then rinse and dry with paper towel; never air
dry grids or use a dishwasher. For cast iron grids, thoroughly
season (see left: “Cast Iron Cooking Grids”) after washing.

Chat with your Broil King Regal 590 Pro manual using AI

Get instant AI answers from your Broil King Regal 590 Pro manual

Ask anything about the Broil King Regal 590 Pro. Answers come from this manual, with the pages they are based on.

Regal 590 Pro Maintenance Schedule

Remind me when maintenance is due
Yearly
Inspect burner and clean venturi tubes

Remove burner to inspect for cracks and clean venturi tubes to eliminate blockages.

Show in the manual (page 10)
Yearly
Inspect QCC cylinder valve seal

Check seal for cracks or abrasion once a year or when replacing cylinder; replace if damaged.

Yearly
Clean exterior finish

Wash cook box with mild soap and water; wipe with cooking oil to restore luster if needed.

Show in the manual (page 10)
Before every use
Clean cooking grids

Brush stainless steel grids to remove debris. Season cast iron grids with oil before each use.

Show in the manual (page 10)
Before every use
Perform Burn-Off

Operate grill on HIGH with lid closed for 10 minutes or until smoking stops to clean interior.

Show in the manual (page 10)
Every time cylinder filled
Leak test gas connections

Test all fittings and cylinder valve for leaks using soap solution when connecting gas.

Before every use
Inspect hose for damage

Check hose for cracks, cuts, or abrasion before each use; do not operate if damaged.

Free maintenance reminders

Timed to your purchase date. Always free, unsubscribe anytime.

By submitting you agree to the privacy policy. Unsubscribe with one click in any email.
M: QW-35-FL

Ask a Question

0/1000

Do you recommend Regal 590 Pro?

Yes No

Frequently Asked Questions

A

Use an LP propane cylinder equipped with a QCC®-1 quick closing coupling and an Overfill Prevention Device (OPD) as specified. Cylinder capacity should not exceed 20 lb (9 kg) and must be installed and secured per instructions.

Is this answer helpful?

A

With valves off, connect the cylinder, open it slowly, and apply a soap-and-water solution to all connections. Bubbles indicate leaks; if detected, close the cylinder valve, tighten fittings, and retest. Never test with an open flame.

Is this answer helpful?

A

Regularly inspect and clean venturi tubes to remove spider nests and debris, clean the Flav-R-Wave and grease tray, and perform annual burner inspections. Blocked venturi tubes can cause flashbacks, popping flames, or uneven heat.

Is this answer helpful?

A

After cleaning, dry thoroughly and apply a light coating of vegetable or olive oil before each use to build a protective layer. Remove rust gently, re-season, and store grids dry during long inactivity periods.

Is this answer helpful?

A

Check propane level and perform leak and venturi inspections. Try manual lighting to identify ignitor issues, ensure regulator is hand-tightened correctly, realign venturi tubes and clean orifices; contact authorized service if problems persist.

Is this answer helpful?

A

No — the manual warns not to operate the main burners simultaneously with the rear rotisserie burner. Follow lighting instructions for the rear burner and remove the warming rack before use.

Is this answer helpful?

A

Warranty durations vary by component; core stainless and cast components have lengthy coverage (some lifetime), Flav-R-Wave and burners have multi-year warranties. Coverage depends on model specifics and normal domestic use; see warranty terms for exclusions.

Is this answer helpful?

M: OA-GPT-5-NAN

Advantages and Disadvantages

Advantages

  • Large, versatile cooking area with five main burners plus rear rotisserie for varied techniques.
  • Sturdy construction: stainless steel components and durable tube burners for long life.
  • Flav-R-Wave vaporization system evens heat and adds flavor while reducing flare-ups.
  • QCC®-1 and OPD-compatible propane connections enhance safety and prevent overfill.
  • Detailed maintenance and troubleshooting guidance simplifies upkeep and problem solving.
VS

Disadvantages

  • Heavy and complex: may require two people for assembly and positioning.
  • Requires regular venturi and grease-trap cleaning to avoid flashbacks and flare-ups.
  • Some replacement parts and repairs may need authorized service and could incur costs.
  • OPD cylinder behavior (slower purge) may confuse some filling stations or users.
  • High-heat discoloration and surface rust can occur; cosmetic upkeep needed for finish.
M: OA-GPT-5-NAN

Product Specification

Type

Grill cart

Number of burners

4

Burners

4x Main burner (Stainless steel)

Grill attachments

Grill grate (Cast iron), Warming rack (enameled), Grill lid with thermometer

Grilling area

32.01x19.29in (WxD), 617.52in² (Area)

Storage surfaces

2x Side shelf, Base cabinet

Features

Castors, Ignition system

Dimensions

62.99x49.21x24.80in (WxHxD)

Weight

220.02lb

M: OA-GPT-54-NAN

Product Description

Broil King Regal 590 Pro — Powerful, Precise, and Built to Last

The Broil King Regal 590 Pro stands out as a premium propane grill engineered for serious home grilling. With five main burners, a rear rotisserie burner, and generous cooking area, it combines high output and precise temperature control for searing, roasting, and low-and-slow cooking. The Regal 590 Pro balances heavy-duty construction—stainless steel components, robust tube burners, and a heat-diffusing Flav-R-Wave system—with thoughtful user-focused features like an electronic ignition, durable cast or stainless cooking grids, and ample storage and workspace.

This grill excels for enthusiasts who want versatility: direct grilling for steaks and burgers, indirect convection for roasts and whole poultry, and rotisserie capability for even, hands-off roasting. Temperature zones are intuitive with labeled control knobs; the rear burner supports rotisserie cooking without flare-ups, while the Flav-R-Wave vaporizer helps even heat distribution and flavorful drippings management.

Safety and propane compatibility are central. The Regal 590 Pro uses QCC®-1 quick closing coupling and an Overfill Prevention Device (OPD)–compatible cylinder setup, plus an 11 in WC regulator for LP use. Clear safety guidelines emphasize outdoor use, leak testing, venturi maintenance, and correct cylinder handling and storage. The grill’s design includes accessible components for cleaning and inspection: removable burners, venturi tubes, grease tray, and a servicing-forward hose/regulator connection.

For performance, the grill offers distinct cooking ranges: HIGH for quick searing and burn-off, MEDIUM/HIGH for steaks, MEDIUM for general grilling and roasting, and LOW for smoking and delicate items. The manual guides first-time burn-off, seasoning of cast-iron grids, preheating, and tips like coating grids with oil and avoiding ingredient mistakes (e.g., salting too early). Practical cooking charts cover direct grilling and indirect convection/rotisserie times and temperatures for common proteins.

Maintenance is straightforward: routine burn-offs, brushing or seasoning grids, cleaning the Flav-R-Wave, inspecting hoses and seals, annual burner and venturi inspection, and using only genuine replacement parts. Troubleshooting covers common issues—gas smell, ignition failure, yellow flames, flashbacks, and excess-flow device activation—and provides corrective steps including leak testing, cleaning venturi tubes, and contacting authorized service when needed.

With robust warranties for core components and clear service pathways, the Broil King Regal 590 Pro is positioned as a reliable, high-performance choice for backyard chefs who demand cooking flexibility, solid construction, and safety-minded propane integration.

Notes

  • Always perform leak tests after reconnecting cylinders and before first use.
  • Use only the supplied regulator and QCC®-1 compatible OPD cylinders for safe operation.
  • Season cast-iron grids regularly; clean venturi tubes to prevent flashback fires.
M: OA-GPT-5-NAN

© Copyright 2026 Manual.ly