Manual.ly Logo

Bosch DIY UniversalAquatak 36V-100 Manual

0.0 · 0 Ratings

PDF manual · 303 Pages

English

M: OA-GPT-5-NAN
page

/ 303

Loading...
9f8aaab841fc23d02d4966cf5f69e0210dbf page 9
Deutsch | 9
Symptome Mögliche Ursache Abhilfe
Schlauch kann nicht
entfernt werden
Ist das Gerät noch eingeschaltet, erhöht sich
durch den Druck im Gerät die erforderliche Kraft.
Schalten Sie das Gerät aus, danach drücken Sie
den Abzug um den Druck abzubauen
Der Motor startet, aber
kein Druck vorhanden
Düse teilweise verstopft Düse reinigen
Unzureichende Wasserversorgung Prüfen Sie den Wasserfilter. Wechseln Sie zu ei-
nem alternativen Wasseranschluss.
Düse verschlissen oder beschädigt Düse ersetzen
Motorgeräusch vorhan-
den aber keine Funkti-
on
Probleme mit der Autostop-Funktion Wenden Sie sich an den autorisierten Bosch Kun-
dendienst
Pulsierender Druck Luft im Wasserschlauch oder in der Pumpe Hochdruckreiniger mit offener Sprühpistole ohne
Lanze oder Düse bei niedrigem Druck laufen las-
sen, bis der normale Arbeitsdruck erreicht ist
Wasserversorgung nicht korrekt Prüfen Sie, ob der Wasseranschluss den Angaben
in den technischen Daten entspricht. Die kleins-
ten Wasserschläuche die verwendet werden dür-
fen, sind 1/2" oder Ø13mm
Überprüfen Sie das Selbst-Ansaugzubehör
Wasserfilter verstopft Wasserfilter reinigen
Wasserschlauch gequetscht oder geknickt Wasserschlauch gerade auslegen
Hochdruckschlauch zu lang Verlängerung vom Hochdruckschlauch entfernen
(Schlauchverlängerung max. 7 m)
Düse teilweise verstopft Düse reinigen
Wartung und Service
Wartung
u Vor allen Arbeiten am Gerät Akku entfernen und Wasser-
anschluss lösen.
Hinweis: Führen Sie die folgenden Wartungsarbeiten regel-
mäßig aus, damit eine lange und zuverlässige Nutzung ge-
währleistet ist.
Untersuchen Sie das Gerät regelmäßig auf offensichtliche
Mängel, wie lose Befestigung und verschlissene oder be-
schädigte Bauteile.
Prüfen Sie, ob Abdeckungen und Schutzvorrichtungen unbe-
schädigt und richtig angebracht sind. Führen Sie vor der Be-
nutzung eventuell notwendige Wartungs- oder Reparaturar-
beiten durch.
Nach Gebrauch/Aufbewahrung
Schalten Sie das Gerät aus und betätigen Sie den Abzug, um
den aufgebauten Druck abzubauen und den Hochdruck-
schlauch zu entleeren.
Das Äußere des Hochdruckreinigers mit Hilfe einer weichen
Bürste und einem Lappen reinigen. Wasser, Lösemittel und
Poliermittel dürfen nicht verwendet werden. Alle Verschmut-
zungen entfernen, insbesondere die Lüftungsschlitze des
Motors reinigen.
Lagerung nach Saisonende: Entleeren Sie alles Wasser aus
der Pumpe, indem Sie den Motor einige Sekunden laufen las-
sen und den Abzug betätigen.
Keine anderen Gegenstände auf das Gerät stellen.
Legen Sie keine Gegenstände in das Batteriefach.
Lagern Sie das Gerät in einer frostfreien Umgebung.
Stellen Sie sicher, dass die Kabel während der Lagerung
nicht eingeklemmt sind. Knicken Sie den Hochdruck-
schlauch nicht ab.
Filter
Der Einsatz von zwei Filtern (Innen- und Außenfilter) erhöht
den Schutz vor dem Eindringen von Verunreinigungen in die
Maschine und verlängert somit die Lebensdauer des Pro-
dukts.
Stellen Sie sicher, dass beide Filter stets sauber und frei von
Verunreinigungen sind.
Umweltschutz
Umweltbelastende Chemikalien dürfen nicht in den Boden,
ins Grundwasser, in Teiche, Flüsse etc. gelangen.
Bei der Verwendung von Reinigungsmitteln die Angaben auf
der Verpackung und die vorgeschriebene Konzentration ge-
nau einhalten.
Bei der Reinigung von Motorfahrzeugen die örtlichen Vor-
schriften beachten: Es muss verhindert werden, dass abge-
sprühtes Öl ins Grundwasser gelangt. Recyceln Sie Rohstof-
fe, anstatt sie zu entsorgen.
Akku-Pflege
Um eine optimale Nutzung des Akkus zu gewährleisten, be-
achten Sie folgende Hinweise und Maßnahmen:
– Schützen Sie den Akku vor Feuchtigkeit und Wasser.
– Lagern Sie das Elektrowerkzeug und den Akku nur im
Temperaturbereich von –20 °C bis 50 °C. Lassen Sie den
Akku z.B. im Sommer nicht im Auto liegen.
Bosch Power Tools F 016 L94 142 | (27.07.2023)

Chat with your Bosch DIY UniversalAquatak 36V-100 manual using AI

Get instant AI answers from your Bosch DIY UniversalAquatak 36V-100 manual

Ask anything about the Bosch DIY UniversalAquatak 36V-100. Answers come from this manual, with the pages they are based on.

UniversalAquatak 36V-100 Maintenance Schedule

After every use
Relieve pressure and empty hose

Switch off the machine and press the trigger to relieve built-up pressure and empty the high-pressure hose.

After every use
Clean exterior and vents

Clean the exterior with a soft brush or cloth. Remove all debris, especially from motor ventilation slots.

Regularly
Inspect device for defects

Check for loose fixings, worn or damaged components, and ensure covers and guards are undamaged.

Regularly
Clean water filters

Ensure both internal and external filters are kept clean and clear of debris at all times.

Occasionally
Clean battery venting slots

Clean the venting slots of the battery using a soft, clean, and dry brush.

When performance drops
Replace battery

Replace the battery if charging results in a significantly reduced working period.

M: QW-35-FL

Ask a Question

0/1000

Do you recommend UniversalAquatak 36V-100?

Yes No

Frequently Asked Questions

A

The UniversalAquatak 36V-100 accepts Bosch GBA 36V batteries: 2.0 Ah, 4.0 Ah or 6.0 Ah. Use only manufacturer-recommended batteries and the supplied charger. Performance is limited at temperatures below 0 °C.

Is this answer helpful?

A

No. The appliance must not be connected to a drinking-water network without a system separator compliant with IEC 61770 Type BA. Water that has passed through such a separator is considered non-potable.

Is this answer helpful?

A

Use the self-priming accessory kit (inlet strainer with non-return valve, 3 m reinforced suction hose, universal coupling). Submerge the hose and ensure the strainer stays underwater, then start the unit with the lance disconnected; priming can take around 60 seconds.

Is this answer helpful?

A

Check for air in the suction hose or pump, clean the water and inlet filters, ensure the supply hose is at least 1/2" (12.7–13 mm) and not kinked, remove excessive high-pressure hose length, and clean or replace a blocked or worn nozzle.

Is this answer helpful?

A

ECO mode reduces power consumption for efficient cleaning. Auto-stop shuts off the motor when the trigger is released. The machine auto-sleeps after 15 minutes of inactivity and auto-shuts off after 30 minutes of continuous running to protect the unit and conserve battery.

Is this answer helpful?

A

Store batteries separately at 5 °C optimal (acceptable −20 °C to 50 °C), protect from moisture and direct sunlight, avoid leaving batteries in hot cars, clean vent slots occasionally with a soft dry brush, and replace batteries showing significantly reduced runtime.

Is this answer helpful?

A

Never direct the jet at people, animals, electrical parts or the machine; wear PPE (safety goggles, protective clothing) as needed, avoid using solvent-based or undiluted acidic cleaners, use reinforced hoses with correct diameter, and ensure proper ventilation when operating in confined spaces.

Is this answer helpful?

M: OA-GPT-5-NAN

Advantages and Disadvantages

Advantages

  • Cordless mobility with Bosch 36V battery compatibility for flexible outdoor use.
  • Compact and lightweight design (≈5.9 kg with battery) for easy handling and transport.
  • ECO mode and auto-stop functions to conserve battery and reduce runtime waste.
  • Self-priming capability and dual filters enable use with alternative water sources.
  • Clear LED indicators and on-product battery status display simplify monitoring and troubleshooting.
VS

Disadvantages

  • Limited flow rate (2.6 l/min) and rated pressure may be insufficient for heavy-duty commercial cleaning.
  • Performance reduced below 0 °C; battery and unit require frost-free storage and operation conditions.
  • Requires recommended reinforced hoses and accessories; damaged hoses must be replaced to avoid burst risk.
  • Not suitable for spraying asbestos or hazardous materials; some cleaners cannot be used (solvents, undiluted acids).
  • Noise level (~69 dB(A)); hearing protection is advised during prolonged use.
M: OA-GPT-5-NAN

Product Specification

Operating Mode

Cold Water

Pressure

max. 1,450.38psi

Flow Rate

max. 49.12gal/h

Inlet Temperature

max. 104F

Mobility

Carrying Handle

Fuel Tank

no

Dimensions

15.12x20.94x8.15in (WxHxD)

Weight

10.14lb

M: OA-GPT-54-NAN

Product Description

Bosch DIY UniversalAquatak 36V-100 Cordless High-Pressure Cleaner Manual

The Bosch DIY UniversalAquatak 36V-100 is a compact cordless high-pressure cleaner designed for convenient outdoor cleaning tasks around the home. Powered by Bosch GBA 36V batteries (2.0, 4.0 or 6.0 Ah), this lightweight unit delivers up to 6.7 MPa rated pressure with a peak allowable pressure of 10 MPa, making it suitable for washing garden furniture, patios, bikes, driveways and vehicles when used with the appropriate nozzle and detergent. Weighing about 5.9 kg with battery, it combines portability with practical features like an ECO mode for efficient battery use, an auto-stop when the trigger is released, and an automatic sleep function after inactivity.

The cleaner features a 3-in-1 nozzle for variable spray patterns, a detergent nozzle and an accessory lance with a foam bottle option for applying cleaning agents. Two filters (internal and external) protect the pump from debris and the unit supports self-priming from alternative water sources (up to 0.5 m lift) using supplied suction accessories. The product includes clear LED indicators for battery state and product errors, and an integrated battery status display that shows remaining capacity with three green LEDs.

Safety and correct use are emphasized throughout the manual. Key warnings include never directing the high-pressure jet at people, animals, the unit or electrical components; always using a proper water feed and reinforced hoses (minimum 1/2" / 12.7 mm); and never connecting the appliance to a drinking-water network without a system separator (per IEC 61770 Type BA). The manual details PPE recommendations, filter care, and precautions for cleaning sensitive surfaces like tyres and engines. Maintenance instructions cover routine checks, cleaning ventilation slots, draining water before storage, and battery care, including temperature ranges for storage and charging and safe transport guidelines for Li-ion batteries.

Operation instructions guide the user through battery insertion, water connection, priming the pump, selecting nozzles and ECO mode use. Troubleshooting covers common issues—lack of pressure, pulsation, leaks, LED error codes—and suggests corrective actions such as cleaning/replacing nozzles, checking filters and connections, allowing batteries to reach ambient temperature, and contacting Bosch service when needed. Environmental guidance reminds users to follow local rules for detergent use and disposal, avoid contaminating groundwater, and recycle batteries and the appliance appropriately.

Notes:

  • Battery compatibility: GBA 36V 2.0/4.0/6.0 Ah; limited performance below 0 °C.
  • Weight: approx. 5.9 kg (with battery) / 4.6 kg (without battery).
  • Noise: ~69 dB(A); wear hearing protection when indicated.
  • Self-priming: can draw from tanks or natural sources with supplied accessories.
M: OA-GPT-5-NAN

© Copyright 2026 Manual.ly